ICP—AES法测定玩具材料中痕量砷,硒,锑

用电感耦合等离子体原子发射光谱法（ＩＣＰ－ＡＥＳ０测定了玩具材料中的痕量砷，硒和锑。方法简便快速，回收率为９７．５％－１０２．７％，相对标准偏差小于３％。     

Optimization of selenium determination in plant samples by hydride generation and axial view inductively coupled plasma atomic emission spectrometry

The use of hydride generation coupled with axial view inductively couple plasma atomic emission spectrometry was presented for the determination of selenium in plant samples. The chemical factors affecting potentially the hydride generation efficiency (hydrochloric acid, sodium borohydride and sodium hydroxide concentrations) were assessed through investigation of chemical interference, accuracy and repeatability. The accuracy of measurements was not affected by elements present in high concentration in the plant matrix (K, Ca, Mg, and P). No interference was also observed with transition metals. Using a real sample (maize) with standard additions, decreases of recoveries were sometimes observed for 0.1% (m/v) NaOH, and attained 13.8% in the most unfavourable case. The final accuracy of the method was verified by using two certified reference materials: CRM 402 (white clover) and CRM 279 (sea lettuce). No statistically significant differences were obtained between the measured concentrations and the certified values. The optimized method was found sensitive (detection limit 0.15 μg l⁻¹), reliable and repeatable (R.S.D. between 1.3% and 4.0%).     

Simultaneous determination of arsenic, antimony and selenium by gas-phase diode array molecular absorption spectrometry, after preconcentration in a cryogenic trap

This paper describes a method for the simultaneous determination of As(III), Sb(III) and Se(IV) by combining hydride generation and gas phase molecular absorption spectrometry. A system for continuous hydride generation has been designed and developed, based on the use of a double process of gas-liquid separation, and optimal compromise operation conditions for the three compounds have been found. After generation, the hydrides are collected in a liquid nitrogen cryogenic trap, and then evaporated and driven to the flow cell of a diode array spectrophotometer, in which the transient signals over the 190–250 nm wavelength interval are measured. Under the recommended conditions (sample flow: 35 ml min⁻¹, 0.5 M HCl; reductor flow: 4 ml min⁻¹ of 4% NaBH₄, solution) linear response ranges above 50 μg 1⁻¹ for As(III), 30 μg 1⁻¹ for Sb(III) and 200 μg 1⁻¹ for Se(IV) are obtained with detection limits of 22 μg 1⁻¹, 15 μg 1⁻¹ and 65 μg 1⁻¹, respectively. Multiwavelength linear regression equations were used for the simultaneous determination of the three elements in different synthetic samples, with good precision and accuracy and to study simultaneously the interference from different chemical species for the three compounds. Results were similar to those obtained by other techniques using hydride generation.     

Synthesis, spectroscopic characterization and reactivities of linear and butterfly chromium/selenium complexes containing substituted cyclopentadienyl ligands: crystal structures of [{η-MeC5H4Cr(CO)2}2Se] and [{η-EtO2CC5H4Cr(CO)2}2Se2]

The Cr-Cr singly-bonded dimers [{η⁵-RC₅H₄Cr(CO)₃}₂] (1, R=Me; 2, R=CO₂Et) reacted with an equivalent of elemental selenium in THF at room temperature to give the linear Cr₂Se complexes [{η⁵-RC₅H₄Cr(CO)₂}₂Se] (3, R=Me; 4, R=CO₂Et), whereas the linear Cr₂Se complex (5, R=MeCO) reacted with excess NaBH₄, Ph₃PCHPh or 2,4-dinitrophenylhydrazine under respective conditions to afford the linear Cr₂Se derivatives [{η⁵-RC₅H₄Cr(CO)₂}₂Se] (6, R=MeCH(OH); 7, R=PhCHCMe; 8, R=2,4-(NO₂)₂C₆H₃NHNCMe). Similarly, while the butterfly Cr₂Se₂ complexes [{η⁵-RC₅H₄Cr(CO)₂}₂Se₂] (9, R=Me; 10, R=CO₂Et) could be produced either by reaction of dimers 1 and 2 with an excess amount of elemental selenium, or by reaction of the linear complexes 3 and 4 with an equivalent of elemental selenium, the butterfly Cr₂Se₂ derivatives [{η⁵-RC₅H₄Cr(CO)₂}₂Se₂] (12, R=MeCH(OH); 13, R=PhCHCMe; 14, R=2,4-(NO₂)₂C₆H₃NHNCMe) were yielded by reaction of the butterfly Cr₂Se₂ complex (11, R=MeCO) with an excess quantity of NaBH₄, Ph₃PCHPh and 2,4-dinitrophenylhyazine. Both the linear complexes 3, 4, 6-8 and the butterfly complexes 9, 10, 12-14 are new, which have been fully characterized by elemental analysis, spectroscopy and X-ray crystallography.     

Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Electrochemical vapor generation of selenium species after online photolysis and reduction by UV-irradiation under nano TiO<Subscript>2</Subscript> photocatalysis and its application to selenium speciation by HPLC coupled with atomic fluorescence spectrometry

An online UV photolysis and UV/TiO₂ photocatalysis reduction device (UV–UV/TiO₂ PCRD) and an electrochemical vapor generation (ECVG) cell have been used for the first time as an interface between high-performance liquid chromatography (HPLC) and atomic fluorescence spectrometry (AFS) for selenium speciation. The newly designed ECVG cell of approximately 115 L dead volume consists of a carbon fiber cathode and a platinum loop anode; the atomic hydrogen generated on the cathode was used to reduce selenium to vapor species for AFS determination. The noise was greatly reduced compared with that obtained by use of the UV–UV/TiO₂ PCRD–KBH₄–acid interface. The detection limits obtained for seleno-DL-cystine (SeCys), selenite (Se^IV), seleno-DL-methionine (SeMet), and selenate (Se^VI) were 2.1, 2.9, 4.3, and 3.5 ng mL^–1, respectively. The proposed method was successfully applied to the speciation of selenium in water-soluble extracts of garlic shoots cultured with different selenium species. The results obtained suggested that UV–UV/TiO₂ PCRD–ECVG should be an effective interface between HPLC and AFS for the speciation of elements amenable to vapor generation, and is superior to methods involving KBH₄.     

Development and application of a simple routine method for the determination of selenium in serum by octopole reaction system ICPMS

The aim of the study was to develop an inductively coupled plasma mass spectrometry (ICPMS) method for robust and simple routine determination of selenium in serum. Polyatomic interferences on ⁷⁶Se, ⁷⁷Se, and ⁷⁸Se were removed by applying an octopole reaction system ICPMS with the reaction cell pressurized with H₂ gas. We developed a novel simple optimization routine for the H₂ gas flow based on a signal-to-noise ratio (SNR) calculation of the selenium signal measured in a single selenium standard. The optimum H₂ flow was 2.9 mL min^–1. The selenium content in serum was determined after a 50-fold dilution with 0.16 M HNO₃ and quantified by using addition calibration and gallium as an internal standard. The method detection limit was 0.10 g L^–1 for ⁷⁶Se and ⁷⁸Se and 0.13 g L^–1 for ⁷⁷Se. Human serum samples from a case-control study investigating if selenium was associated with risk of colorectal adenoma were analyzed. The average selenium concentration for the control group (n=768) was 137.1 g L^–1 and the range was 73.4–305.5 g L^–1. The within-batch repeatability (a batch is ten samples) estimated from 182 replicate analyses was 6.3% coefficient of variation (CV), whereas the between-batch repeatability was 7.4% CV estimated from 361 replicates between batches. The method accuracy was evaluated by analysis of a human serum certified reference material (Seronorm Serum level II, Sero A/S, Norway). There was a fairly good agreement between the measured average of 145±3 g L^–1 (n=36) and the certified value of 136±9 g L^–1. In addition the method was successfully applied for analysis of zinc serum concentrations without further optimization. For the Seronorm certified reference material a value of 911±75 g L^–1 (n=31) for zinc was obtained, which corresponds well to the certified zinc value of 920±60 g L^–1.     

Low volume microwave digestion for the determination of selenium in marine biological tissues by graphite furnace atomic absorption spectroscopy

A microwave digestion method for the determination of marine biological tissues has been developed to allow determination of selenium in small sample sizes (< 0.1 g). The benefits of this technique include maintaining concentrates in extracts without the subsequent over dilution encountered when using larger vessels, increased sample throughput and reduced loss of volatile material. Freeze dried biological material (< 0.1 g) and nitric acid (1 ml) were placed into 7 ml screw top Teflon vessels which are completely sealed on capping. Two 7 ml vials were placed into larger 120 ml vessels fitted with a Teflon spacer and 10 ml of distilled water. The effects of microwave power and time, and sample mass on selenium recovery from three marine standard reference materials (NIST SRM 1566a Oyster Tissue, NRCC DORM-1 Dogfish Muscle and NRCC TORT-1 Lobster Hepatopancreas) were examined. The optimum conditions: 600 W, 2 min; 0 W, 2 min; 450 W, 45 min, allowed quantitative recoveries of selenium from these and three other standard reference materials (NRCC DOLT-1 Dogfish liver, NIST RM-50 Albacore tuna and IAEA MA-A-2 fish flesh). Studies on sample mass showed that the analysis of sample masses from 0.025 to 0.1 g gave selenium concentrations within the certified range. Six species of selenium: selenite, selenate, selenomethionine, selenocysteine, selenocystamine, and trimethyl selenonium were added to oyster, dogfish, and lobster tissues. Recoveries were near quantitative for all species (94–105%) except trimethyl selenonium (90–101%).     

Cobalt Chalcogenide Clusters. Synthesis,Characterization and DFT Calculations of [Co4Se2(CO)10] and [Co4Te2(CO)11]. Crystal Structure of [Co8Se4(CO)16(μ‐dppa)2]

The reactions of [Co₂(CO)₈] with E(SiMe₃)₂ (E = Se, Te) in CH₂Cl₂ result in the formation of the compounds [Co₄Se₂(CO)₁₀]> ( 1 ) and [Co₄Te₂(CO)₁₁] ( 2 ), respectively. Both cluster complexes have similar molecular structures in which the cobalt atoms form four‐membered rings with μ₄‐bridging chalcogen atoms (Se and Te) above and below the plane of the metal atoms and the carbonyl ligands as either terminal or μ₂‐bridging ligands. DFT‐calculations for both compounds have been carried out in order to obtain some more information about their electronic distribution. In the presence of the phosphine Ph₂PC≡CPPh₂ (dppa), the reaction of [Co₂(CO)₈] with Se(SiMe₃)₂ leads to the formation of [Co₈Se₄(CO)₁₆(μ‐dppa)₂] ( 3 ). During the reaction two molecules of [Co₂(CO)₈] have been added to the acetylene groups of the dppa ligands, whilst the remaining cobalt atoms coordinate to the phosphorus atoms of the phosphine. In this compounds the selenium atoms act as μ₃‐ligands, bridging the metal atoms bonded to the phosphorus with those bonded to the acetylene groups.