弱酸树脂D113对S-腺苷-L-蛋氨酸的交换行为及分离应用研究

考察了S-腺苷-L-蛋氨酸 (S-adenosyl-L-methionine, SAM) 在弱酸树脂争光D113上的静态吸附及分离行为,利用Langmuir等温式对平衡等温线进行了拟合,实验表明,随着pH的提高,平衡交换量增加,提高温度和SAM的初始浓度在一定程度上能促进内扩散过程,利用D113树脂在f 1.7×30.0cm小型柱上从酵母提取液中分离SAM的得率为90%以上,纯度达87%以上。     

A rapid HPIC method for the quantitative determination of tetramethylammonium chloride in some aqueous solutions used as food simulants

Summary The present paper reports a rapid HPIC method for the determination of tetramethylammonium chloride in aqueous matrices which are used as food simulants in migration tests. These simulants were: bidistilled water, an aqueous solution of 3% acetic acid, an aqueous solution of 15% ethyl alcohol, a mixed aqueous solution of 3% acetic acid and 15% ethyl alcohol. The method, as developed, has been applied to the determination of unreacted tetramethylammonium chloride residues which are able to migrate from finished epoxy resins which are used as food packaging materials.Research partially supported by National Research Council of Italy, Special Project RAISA, sub-project 4, Paper N^o 695.     

锂离子筛的制备及其交换性能研究

用浓度为0.5mol/L的盐酸对高温固相合成的前体LiMn2O4进行酸洗脱锂,制得锂离子筛HMn2O4,并在不同pH值和温度下进行了Li 交换性能的研究,同时运用XRD和TEM进行了相应表征。结果表明,锂离子筛吸附交换前后晶体结构只发生了细微变化,但都仍为尖晶石型结构;交换反应在前10min速率最快,约20min就趋于平衡;Li 交换总量随pH值增大而升高,其中pH=7时交换容量为18.5526mg/g;Li 交换量和交换选择性随温度的升高而显著增强。     

用选择离子流动管质谱测定汽油和柴油蒸汽成分

采用选择离子流动管质谱(SIFT／MS)装置，以H30^ 、N0^ 为初始离子对汽油和柴油蒸汽进行了研究，质谱分析表明，汽油和柴油主要由C—H化合物组成，包括烷烃、环烷烃、烯烃、炔烃、二烯烃以及芳香烃。在这几种成分中，烷烃都占有最大的比例；汽油蒸汽和柴油蒸汽最大的区别是柴油蒸汽中长链大分子的挥发性C—H化合物所占的比例远远高于汽油蒸汽。文中还给出了以H30^ 、N0^ 为初始离子所得到的汽油蒸汽的质谱图，以及汽油、柴油蒸汽中各种成分的定量分析结果。     

Gibbs functions for transfer of divalent metal cations from water to water + methanol mixtures using potentiometry, polarography and solubility measurements

Gibbs functions for transfer from water to methanol and to a full range of water + methanol mixtures were obtained for Cu²⁺, Cd²⁺, Pb²⁺, Hg²⁺, Zn²⁺, Mg²⁺, Ca²⁺, Sr²⁺ and Ba²⁺ using potentiometric or polarographic measurements in these solvents. In addition, data were obtained from the solubility products of the alkaline-earth iodates. From values obtained by the different methods and literature data, a table of selected values is given.     

Microcolumn ion chromatography with conductimetric detection

Summary A miniaturized flow cell for an electrical conductivity detector has been made and applied to the ion chromatography of inorganic anions. It consisted of stainless steel tubes (0.13 mm ID×0.31 mm OD) and PTFE tubes (0.25 mm ID×2 mm OD). The detection limit for chloride at S/N=3 was 36 pg or 0.33 ppm for a 0.11 l injection.     

用水合五氧化二锑分离放射性母子体的研究─—一个新的~(201)Pb—~(201)T1发生器的制备

本文研究了无机离子交换剂—水合五氧化二锑（Sb2O5·nH2O）的制备，并用它分离了放射性母子体，制备了一个新的201Pb—201Tl放射性发生器。结果表明，末发生器具有高效、快速、简便的特点，此外还讨论了离子交换反应的机理。     

氟的离子选择电极瞬时电位法测定

研究了氟离子选择电极瞬时电位分析法，其检出限和Nernst响应下限均低于传统电位分析法，空白液切换到试液时瞬时电位达到稳定的峰电位Vp比传统电位法的响应快得多，可以实现小体积试液的快速准确分析；用该法测定了自来水和矿泉水中氟的含量；利用校正曲线的截距和检出限计算了LaF3的溶度积，在0.1mol/L KNO3介质中Ksp(LaF3)=10^-28.45，在0.001mol/L柠檬酸钠＋HAc-NaAc缓冲液（pH=5.50，离子强度I＝0.10mol/L)介质中溶度积K′sp(LaF3)=10^-26.26；据此，计算得柠檬酸与La^3 络合物的稳定常数K1=10^5.46和K2=10^3.99；用离子水合吉氏自由能ΔGh(F^-,g)解释了不同浓度F^-试液瞬时电位的跃迁时间。     

The Electrochemistry of Tetraphenyl Porphyrin Iron(III) Within Immobilized Droplets Supported on Platinum Electrodes

For the first time, the voltammetry of an ensemble of immobilized benzonitrile microdroplets containing 5,10,15,20‐tetraphenyl‐21H,23H‐porphine iron (III) chloride, TPPFeCl immobilized at platinum electrodes immersed in various aqueous electrolytes has been explored. The reduction of TPPFeCl was observed with the voltammetric response seen to be highly dependent on the nature of ions in the surrounding aqueous phase. Unlike voltammetry in purely homogeneous solution the nature of the aqueous electrolyte can influence the voltammetry in the droplet phase. The electrochemical reduction of TPPFeCl contained within tetrabutylammonium chloride (TBACl) supported benzonitrile (PhCN) microdroplets immersed into an aqueous solution of TBACl was first studied. During TPPFeCl reduction the resulting [TPPFeCl]^? species is stabilized due to the excess of chloride anions inside the oil droplet. Voltammograms of homogeneous solutions of PhCN supported with TBACl show similar chemically reversible process which is also attributed to the stable [TPPFeCl]^? species. This anion stabilization was not observed when the oil droplets were supported with tetrabutylammonium perchlorate (TBAP) or when the PhCN solution bathing the microdroplet ensemble was supported with TBAP resulting in a chemically irreversible process. The voltammetry of unsupported droplets immobilized on a platinum electrode immersed in different aqueous electrolytes was also explored and the fate of the [TPPFeCl]^? species formed considered during the reduction sweep. Similarities and difference to voltammetry in purely homogeneous media are noted and the use of droplet voltammetry provides complimentary information.     

Improving the lower detection limit of potentiometric sensors by covalently binding the ionophore to a polymer backbone

The lower detection limit of polymeric membrane ion-selective electrodes (ISEs) is impaired by zero-current ion fluxes through the organic phase. This adverse effect is largely eliminated by covalently attaching the ionophore to a polymer backbone. To this purpose, the Pb²⁺-selective ligand, 4-tert-butylcalix[4] arene-tetrakis(N,N′-dimethylthioacetamide) is substituted on its upper rim by a diol derivative which is subsequently copolymerized with poly(tetrahydrofuran)diol and 2,2,4-trimethylhexamethylene diisocyanate to the corresponding polyurethane. By measurements on sandwich membranes, it is shown that through binding the ionophore to the polymer, the mobility of Pb²⁺ in the ISE membrane is strongly reduced. As a consequence, the response range of such an ISE is extended by several orders of magnitude. This is the case even when using an internal electrolyte that with an ISE based on a mobile ionophore leads to strong deviations from the linear response because of ion uptake from the sample into the membrane or ion release from the membrane into the sample. With a conventional inner filling solution of 10⁻¹ M Pb(NO₃)₂, a lower detection limit of 1.7×10⁻⁹ M Pb²⁺ has been achieved in the presence of 10⁻⁴ M Na⁺.