关于meso—四苯基卟啉在冰醋酸中的存在形式

前言卟啉在生物化学、分析化学、药物化学等领域有着广泛研究和重要应用［１～３］。近年来虽然对卟啉类化合物的研究报道很多［４～６］，但对卟啉在酸性介质中的研究很少。较早期的研究工作认为卟啉类化合物在酸性介质中仅以其二酸形式存在［７］。本文实验结果显示ｍｅ...     

Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

2-三氰基乙烯基蒽及其旋转异构体的量子化学研究

用量子化学从头算方法 ,在RHF/STO - 3G水平上 ,对 2_三氰基乙烯基蒽 (2_TCVA)分子进行了理论计算 ,优化得到了它的平衡几何构型 ,并计算了它的谐振动频率 .结果表明 :2_TCVA存在两种旋转异构体 :2_TCVA(1)和 2_TCVA(2 ) ,2_TCVA(2 )的总能量比 2_TCVA(1)的略高 .在PM3/CIS水平上计算了它们的电子光谱 ,得到了由基态到各激发态的垂直跃迁能和相应的振子强度 .研究表明 :2_TCVA(1)和 2_TCVA(2 )的强度最大的吸收波长分别为 2 4 9.72nm和 2 89.4 1nm ,2_TCVA(2 )的强度最大的吸收波长比 2_TCVA(1)的要长 .计算结果与实验结果符合得较好     

Improved accuracy of quantitative XPS analysis using predetermined spectrometer transmission functions with UNIFIT 2004

The accuracy of quantitative XPS analysis can be improved using predetermined transmission functions. Two different calibration methods are used for estimating the transmission function T(E) of a photoelectron spectrometer, applying a survey spectra approach (SSA) and a quantified peak‐area approach (QPA) to minimize the quantification error. For the SSA method, Au, Ag and Cu spectra measured with the Metrology Spectrometer II have been used. The new QPA method was built up from Au 4f, Au 4d, Au 4p_3/2, Ag 3d, Ag 3p_3/2, Cu 3p, Cu 2p_3/2, Ge 3p and Ge 2p_3/2 standard peak areas, applying adequate ionization cross‐sections and mean free path lengths for different pass energies (10 and 50 eV), lens modes (large area, large area XL, small area 150) and x‐ray sources (Al/Mg Twin and Al Mono). In the energy range 200–1500 eV a transmission function T(E) = a₀ + b₁E (where a₀, b₁ and b₂ are variable parameters) was found to give an appropriate approximation for eight tested spectrometer settings, implementing the largest changes in the case of pass energy variations. Determination and application of the transmission functions were integrated in the XPS analysis software (UNIFIT 2004) and tested by means of an Ni90Cr10 alloy. The results demonstrate the practicability of the SSA and QPA methods, giving decreased errors of <8% in comparison with errors up to 38% obtained using Wagner's sensitivity factors. Copyright © 2005 John Wiley & Sons, Ltd.     

钙钛矿型CaSiO_3解压缩和重压缩过程的分子动力学模拟

用分子动力学模拟方法 (MD)研究了 3 0 0K时钙钛矿型CaSiO3 ,从高压到负压的解压缩过程 .MD模拟获得的P V关系与实验数据相近 ,与已报道的MD模拟数据基本一致 ,所得体积模量也在实验数据分布范围内 .减压缩和重压缩的MD模拟数据与实验结果相似 .钙钛矿型CaSiO3 解压缩成非晶态时 ,存在两个结构破坏阶段 :破坏硅氧八面体和破坏钙氧二十面体 .当钙氧二十面体被破坏后 ,重压缩不能得到钙钛矿型结构 .只要钙氧二十面体未被破坏 ,重压缩可恢复钙钛矿型结构 .本研究得到的结果尚未见相关报道 .由MD模拟数据计算了CaSiO3 系统的红外光谱 ,分析这些数据可知钙钛矿型CaSiO3 解压缩非晶化是一个二阶软模相变 .研究表明钙钛矿型CaSiO3 结构存在一个等容的亚稳极限 ,其解压缩非晶化是一个受动力学控制的亚稳状态 .     

5,9,14,18,23,27,32,36-八烷氧基2,3-萘酞菁镍(Ⅱ)的结构与光谱性质关系的研究

测定了一组八烷氧基萘酞菁镍（Ⅱ）配合物Ni（Ⅱ）（RO）8NPC（R＝C4H9，C8H17，C12H25，NPC＝C48H16N8）在5种有机溶剂（Py、DMSO、DMF、CH2Cl2、C6H12）中的电子吸收光谱和荧光光谱，研究了这些配合物的结构与光谱的关系。结果表明该系列RO取代萘酞菁镍（Ⅱ）配合物的Q带吸收光谱比无取代的红移75nm左右，荧光光谱屯相应红移50～80nm，而溶剂对其影响不大。     

2-(N'-乙基咔唑-3'-烯基)-8-羟基喹啉的合成及理论研究

设计合成了2-(N'-乙基咔唑-3'-烯基)-8-羟基喹啉. 以UV-Vis, ¹H NMR, FT-IR, 元素分析和MS进行了结构表征, 并测定了产物的光致发光(PL)性质. 运用Gaussian98量子化学程序包, 采用B3LYP密度泛函(DFT)的方法, 在6-31G(d,p)水平上对分子的几何构型进行结构优化; 预测目标产物的振动光谱, 结果表明与实验值相符.     

足球分子及有关碳笼的电子结构

本文评述了激光气化产生的碳原子簇的电子结构和活性。足球分子具有球面芳香性。我们用INDO/2和INDO/CI系列方法。研究了足球分子及其异构体的电子结构和UV谱。足球分子的计算结果是只有一条低频带(366.4nm),与实验结果(386.0nm)符合得很好。     

一种新型联萘基旋光共轭聚合物的圆二色谱和圆偏振荧光光谱

众所周知 ,聚合物的光电性质依赖于聚合物链的构象和 (或 )组成 ,通过在聚合物上引入手性单元 ,采用圆二色谱 ( CD)和圆偏振荧光光谱 ( CPL)等方法可表征聚合物结构 [1] .近年来 ,由于圆偏振光可用作光数据存储和液晶显示器背景光 [2 ] ,人们开始注重共轭聚合物圆偏振光材料的研究 .共轭聚合物的光致和电致圆偏振光的现象由一种带手性侧链的聚噻吩[3 ] 和一种带手性侧链的聚 (对苯撑乙烯 ) [4 ]产生 ,但它们的圆偏振荧光度 (用不对称因子 glum=2 ( IL-IR) / ( IL+IR)表示 ,IL 和 IR 分别指左圆偏振光强度和右圆偏振光强度 )相对较低 …     

2-芳基硫杂脯氨酸结构特征的研究

对12种2-芳基硫杂脯氨酸进行了红外光谱和核磁共振谱测定,对其中两个化合物作了质谱测定。结果表明,这类化合物固态时主要以两性离子形式存在;有较强的分子离子峰,是一类较稳定的化合物。它们还存在一对非对映异构体,芳环上的取代基对芳环电子云密度的影响较大,而对四氢噻唑环的影响较小。