Reversible dynamics and the macroscopic rate law for a solvable Kolmogorov system: The three bakers' reaction

We investigate a piecewise linear (area-preserving) mapT describing two coupled baker transformations on two squares, with coupling parameter 0c1. The resulting dynamical system is Kolmogorov for anyc0. For rational values ofc, we construct a generating partition on whichT induces a Markov chain. This Markov structure is used to discuss the decay of correlation functions: exponential decay is found for a class of functions related to the partition. Explicit results are given forc=2^–n. The macroscopic analog of our model is a leaking process between two (badly) stirred containers: according to the Markov analysis, the corresponding progress variable decays exponentially, but the rate coefficients characterizing this decay are not those determined from the one-way flux across the cell boundary. The validity of the macroscopic rate law is discussed.     

微波辅助-光催化降解氯酚的QSPR研究

本文运用PM3算法计算得到氯酚(CPs)的分子结构参数,并结合光解速率进行PLS分析,建立了速率与量子化参数之间的关系模型,模型的Q2cum分别为0.8776和0.9545(>0.5),具有良好的预测能力。研究结果表明,参数Ehomo、Elumo Ehomo、Elumo、N、Mw、Elumo-Ehomo、(Elumo-Ehomo)2是决定CPs光解速率的主要因素;CPs的光解速率随Ehomo、Elumo Ehomo、Elumo、Elumo-Ehomo、(Elumo-Ehomo)2的增大而增大,随N、Mw的增大而减小。     

Sample enrichment by using monolithic precolumns in microcolumn liquid chromatography

An on-line sample enrichment system was designed using monolithic precolumns in microcolumn LC. The monolithic ODS capillary columns were prepared via in situ sol-gel processes. The enrichment efficiency of the monolithic columns was tested by using phthalates as the analytes. The relative standard deviations (n = 6) for the retention time, peak area and peak height were between 0.4 and 1.2%, 0.9 and 5.5% and 0.4 and 3.9%, respectively. The system was linear (R2 > 0.99) within the working sample concentration and sample volume ranges. Comparing to 0.2 microl injection with a typical sample injector, the theoretical plate number of a same separation column was increased by 3-6-fold when the precolumn unit was used for sample injection. The recoveries of the analytes were between 88 and 120%, and the sample volume that could be injected into the system was increased up to 5000-fold. The limits of detection were improved by more than 2000-fold and were between 0.21 and 0.87 ng ml(-1) even with a UV absorbance detector. This system was applied to the determination of phthalates contained in laboratory distilled water and tap water samples.     

SHAPE MEMORY EFFECT OF PU IONOMERS WITH IONIC GROUPS ON HARD-SEGMENTS

SMPU （shape memory polyurethane） non-ionomers and ionomers, synthesized with poly（c-caprolactone） （PCL）, 4, 4＇-diphenylmethane diisocyanate （MDI）, 1,4-butanediol （BDO）, dimethylolpropionic acid （DMPA） were measured with cyclic tensile test and strain recovery test. The relations between the structure and shape memory effect of these two series were studied with respect to the ionic group content and the effect of neutralization. The resulting data indicate that, with the introduction of asymmetrical extender, the stress at 100% elongation is decreased for PU non-ionomer and ionomer series, especially lowered sharply for non-ionomer series; the fixation ratio of ionomer series is not affected obviously by the ionic group content; the total recovery ratio of ionomer series is decreased greatly. After sufficient relaxation time for samples stretched beforehand, the switching temperature is raised slightly, whereas the recovery ratio measured with strain recovery test method is lowered with increased DMPA content. The characterization with FT-IR, DSC, DMA elucidated that, the ordered hard domain of the two series is disrupted with the introduction of DMPA which causes more hard segments to dissolve in soft phase; ionic groups on hard segment enhance the cohesion between hard segments especially at high ionic group content and significantly facilitate the phase separation compared with the corresponding non-ionomer at moderate ionic group content.     

停留—催化反应速差动力学法同时测定Fe,Mo

根据Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）对Ｈ２Ｏ２氧化邻氨基酚的催化反应速率不同，结合流动注射停留技术，建立了同时测定Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）的速差动力学分光光度法．测定铁和钼的线性范围分别为０．１～２．５μｇ／ｍＬ和０．５～１５μｇ／ｍＬ．除Ｗ（Ⅵ）的允许量较小外，其它离子不干扰测定．用本法测定了合成样液中铁和钼含量，结果满意．     

原子吸收光谱法测定拉伸断口铬镍钼钛钢样品中主成分

研究了毫克级铬镍钼风样品中主成分镍的火焰原子吸收光谱法（FAAS法）和铬、钼、钒、钛、铝的塞曼恒温平台石墨炉原子吸收光谱法（ZSTPF－AAS法）。采用了微波溶样技术作为防污染样品预处理技术，采用石墨管硅涂层改进技术提高了仪器的测试精度。其中铬、镍、钼、钒、钛、铝的相对标准偏差分别为2.7%,0.97%,8.6%,7.3%,1.7%,7.3%。其加标回收率分别为96.5%,97%,96.7%,93%,98%,91%。通过分析，发现在较低温度下铬镍钼钛钢断面上有轻微的钼偏析现象，可能是拉伸断裂的主要化学影响因素。     

A modified simplex method for multifactor optimization of selectivity in gas chromatography

A computer-assisted advanced simplex method is presented for the simultaneous optimization of multifactor ( stationary phase loading, carrier gas flow rate and column temperature ) for separation of ten compounds in gas chromatography. A three factors factorial design was used. The method was based on a special polynomial established from fifteen preliminary runs, using resolution as the selection criterion, with connection to a general simplex method. Excellent agreement is found between the predicted data and the experimental results, and most of experiments required in the general simplex method can be omitted.     

全二维液相色谱（NPLC×RPLC）接口及其应用

用内径为0．53mm的填充毛细管正相液相色谱为第一维，用4．6mm（i．d．）×50mmRP-18e整体柱反相色谱为第二维，建立了定量环一阀切换接口的全二维液相色谱系统（NPLC×RPLC）．第一维色谱分离洗脱出的组分交替存储在十通阀上的两个定量环中，同时定量环中前一个组分被转移到第二维进行反相分离．因为第一维的流动相流量仅是第二维的1／500，自然解决了流动相兼容问题．采用芳香族化合物的混合物和中药丹参正己烷提取液对该全二维液相系统的分离能力进行了评价．     

烯烃加成反应活性与烷基极化效应的关系

烯烃的自由基加成和亲电加成速率受不同的因素控制.对于仅仅含烷基取代的简单烯烃:(1)与OH自由基加成速率-log kOH可由π键上烷基极化效应指数的几何平均值GMPEIπ关联:-log kOH=a bGMPEIπ c(GMPEIπ)2; (2)与亲电试剂加成速率log k可由π键两端碳原子所连基团极化效应指数PEI(L)和PEI(S)关联:log k=a bPEI(L) cPEI(S),其中的PEI(L)和PEI(S)分别表示极化效应较大和较小的一端.