铋镓共掺的高浓度掺铒石英基光纤中铒离子团簇率的实验研究

使用MCVD法结合溶液掺杂技术制作了铒铋镓共掺的石英基光纤.根据光纤吸收谱，得出其中铒离子浓度是5.24×10²⁵/m³.然后提出了一种新的利用透射率测定掺铒光纤的团簇率的实验方法，该方法相比于以前的方法更简单有效.利用该方法，测得了自制铒铋镓共掺光纤中团簇率.通过与前人的结果相比较，充分说明铋和镓的掺入大大提高了铒离子在石英基光纤中的溶解度，抑制了铒离子形成团簇.     

Boundary coupled dual-equation numerical simulation on mass transfer in the Process of laser cladding

The coupled numerical simulation on fluid flow, heat transfer, and mass transfer in the process of laser cladding is undertaken on the basis of the continuum model.In the simulation of mass transfer in the laser molten pool, the concentration distribution in the regions on different sides of the interface between cladding layer and substrate is calculated separately and coupled at the co-boundary.The non-equilibrium solute partition coefficient is obtained from equilibrium solute partition coefficient according to the Sobolev model.By using the developed software which is based on the commercial software PHOENICS 1.4, the distribution of Fe in laser molten pool in an experiment of cladding Stellite 6 on 12CrMoV is calculated.The obtained results well coincide with the experimental ones.     

基于可调谐二极管激光吸收光谱技术的密闭玻璃容器中水汽浓度及压力的探测

冻干法处理过的药品瓶中残存的水汽(H₂O)是药品变质的主要影响因素之一, 如何快速准确地测量瓶中的水汽浓度及压力, 是检测药瓶是否泄漏的关键. 本文报道了利用1.39 μm半导体激光器作为光源, 结合波长调制吸收光谱技术, 实现了对密闭玻璃容器(药瓶)中水汽浓度及压力的探测, 并通过转台模拟生产线对系统在动态条件下的性能进行了测试. 研究结果表明, 在0.2%-12%的H₂O浓度范围内真实值与测量值之间的相关度和标准偏差为0.9978 和4.81%, 在0.1-100 atm (1 atm=1.01325×10⁵ Pa)的压力范围内两者之间的相关度和标准偏差为0.982和5.6%, 系统对应的压力及浓度的最低检测限约为2.5 Torr (1 Torr=1.33×10² Pa)和400 ppm. 通过利用转台以及Labview编写的快速在线处理软件进行了动态条件下的测试, 一分钟可以处理300个左右的药瓶, 可以很好地满足快速实时探测的要求. 该方案可以直接应用于药瓶在线检测, 并且使用2台激光器可以实现多组分同时探测分析(如H₂O、氧气等).     

高氧空位简并锐钛矿TiO2半导体电子寿命的第一性原理研究

为了研究锐钛矿TiO₂晶体中高氧空位浓度对电子寿命的影响,利用基于局域密度泛函理论框架下的广义梯度近似平面波超软赝势方法, 用第一性原理对含高氧空位浓度的锐钛矿TiO₂晶体进行了结构优化处理、能带分布和态密度分布计算, 表明在温度一定和高氧空位浓度的条件下, 锐钛矿TiO₂的电子寿命随氧空位浓度的增大而减小;电子浓度的大小对电子寿命无影响.同时,锐钛矿TiO₂晶体中高氧空位浓度时,发现有莫特相变的现象. 关键词： 高氧空位 2半导体')" href="#">锐钛矿TiO₂半导体 电子寿命 第一性原理     

Geological influence on the activity concentration of terrestrial radionuclides 226Ra, 232Th and 40K in the Jos Plateau,Nigeria

The Jos Plateau has been reported to have elevated levels of natural background radiation. A few earlier studies have measured the levels of natural radioactivity for specific locations in the area. Our interest is to investigate how geology of the study area influences the activity concentrations of natural radionuclides. Thus, the activity concentrations of terrestrial radionuclides in soil samples collected across the geological formations of the Jos Plateau were determined by gamma spectrometry technique. The mean activity concentrations of ²²⁶Ra, ²³²Th and ⁴⁰K were found to exceed their corresponding world reference values of 35, 40 and 400?Bq?kg^?1, respectively. Data were compared using statistical methods, analysis of variance (ANOVA) and post hoc tests. The results revealed in some instances significant influences of geological types on the activity concentrations in the area. The spatial distribution maps of activity concentrations of ²²⁶Ra, ²³²Th and ⁴⁰K were geostatistically interpolated by ordinary Kriging method using ArcGIS software.     

TDLAS测量CO2的温度影响修正方法研究

可调谐二极管激光吸收光谱(TDLAS)技术测量CO₂浓度时,由于测量氛围温度变化的影响引起气体吸收谱线的线强和线型发生变化,最终导致浓度测量存在较大误差。为了克服温度变化对浓度测量的影响,选用中心波长在1 580 nm的DFB激光器,基于直接吸收法,模拟电厂尾部烟道内的高浓度二氧化碳气体环境,研究了在常温(298 K)和变温(298~338 K、间隔10 K)不同温度工况下CO₂浓度的测量。结果显示,常温浓度测量的最大相对误差为-5.26%,最小相对误差为1.25%,相对误差均方值为3.39%,验证了TDLAS测量系统在常温下有着良好的测量精度和稳定性,但其在变温测量时浓度测量结果误差较大,其最大相对误差已经超过25%。为了修正温度变化对浓度测量结果的影响,适应工业测量的需要,在变温测量基础上利用最小二乘法拟合出测量系统在不同温度下的浓度与气体吸收的修正关系式。经过修正后,CO₂浓度测量的相对误差降到5%以下,相对误差均方值降到3.5%以下。修正结果表明,所提出的修正方法可以有效抑制温度变化对浓度测量结果的影响,显著提高了测量系统在变温环境下的测量精度和稳定性,为TDLAS系统测量CO₂浓度的现场应用提供了理论支持和技术保障。     

基于ZigBee的煤矿井下甲烷浓度检测系统设计

针对传统煤矿井下甲烷浓度采用工业总线检测方法的不灵活和存在盲点等问题,本文提出了一种基于ZigBee的煤矿井下甲烷浓度检测系统。系统采用ZigBee协议栈构建无线传感器通讯网络,该网络的终端节点感知和采集矿井甲烷的浓度,并将浓度数据通过无线传输至协调器,协调器再经过串口传输到地面的监控中心。详细介绍了检测系统的软硬件设计,并对系统进行了测试验证。     

微波辅助对生物溶液超滤过程的影响

为验证微波场强化植物提取的膜超滤假说机理,以聚醚砜超滤膜为研究对象,以膜通量为考察指标,结合膜和黄芪饮片显微结构的扫描电镜(SEM)表征,讨论了微波辐射对黄芪水提液超滤过程的影响。结果表明,驱动压力相同,微波辅助超滤30 min时,膜通量下降到初始值的57.36%,且膜表面观察不到凝胶层;而常规超滤30 min,膜通量已下降到初始值的30.29%,且膜表面覆盖一层约20μm的凝胶层。说明微波辐射能够减弱浓差极化现象,促进膜超滤过程中的物质传递。     

表面张力系数随氯化钠离子浓度的变化规律实验研究

液体表面张力系数是表征表面张力大小的重要物理量,它的存在可以解释物质处于液态时所特有的许多现象。本文使用拉脱法测定不同浓度氯化钠(Na Cl)溶液的表面张力系数,实验结果表明表面张力系数伴随Na Cl浓度的增加而变大。     

Effective electrodeposition of Co-Ni-Cu alloys nanoparticles in the presence of alkyl polyglucoside surfactant

The effect of alkyl polyglucoside (APG) surfactant on the electrodeposition Co-Ni-Cu alloys nanoparticles has been investigated. In a typical electrodeposition experiment, it was found that as prepared Co-Ni-Cu alloys nanoparticles characteristics, such as size homogeneity, density, dispersion on the electrode substrate and the chemicals composition, depended strongly on the concentration of APG used in the reaction as well as the applied deposition potential. For the case of chemicals composition, low APG concentration (below CMC) was found to be effective for the preparation of excellent composition of the nanoalloys. Meanwhile, for the case of size homogeneity, density, and dispersion on the surface, high APG concentration (above CMC) and high deposition potential were preferred. It was also found that, at concentration above the CMC, the APG surfactant showed a metals ions deposition inhibition characteristic that caused increasing in the electrodeposition overpotential of the entire metals ions, namely cobalt, nickel and copper. As the result the copper was found to place a high percentage in the nanoalloys deposits. Owing to its simple procedure in controlling the composition and the nanoalloys growth characteristic, present approach should find a potential application in preparing Co-Ni-Cu magnetic nanoparticles for used in currently existing applications.