Accuracy analysis and stabilization design of the Fabry–Perot frequency discriminator in double-edge wind lidars

The measurement error of a double-edge wind lidar caused by a disturbed Fabry–Perot interferometer (FPI) is analyzed. Several error sources such as air pressure variations, temperature changes, and mechanical vibrations are considered in the measurement-error model. The simulation results show that a double-edge wind lidar is so sensitive to environmental variations that the measurement error reaches ±60 m/s if the FPI is not stabilized. In order to compensate the external disturbance acting on the FPI, a nonlinear proportional–integral–derivative (PID) control scheme is designed based on the transmission measurement of the calibration channel. An arc tangent function is used to improve the feedback gain of the usual PID control design. The results show that with the new controller the measurement accuracy of the wind lidar can be improved 4–5 times in comparison with the usual control design, and the range of the measurement error is only ±3 m/s.     

System for measuring optical admittance of a thin film stack

A new method based on the polarization interferometer structure has been applied to measure the optical admittance, the refractive index and thickness of a thin film. The structure is a vibration insensitive optical system. There is one Twyman-Green interferometer part to induce a phase difference and one Fizeau interferometer part to induce the interference in the system. The intensities coming from four different polarizers were measured at the same time to prevent mechanical vibration influence. Using the polarization interferometer, the optical admittance, the refractive index and thickness of a single layer of Ta₂O₅ thin film has been measured. The measurement results were compared with the results obtained by ellipsometer. The results meet reasonable values in both refractive index and thickness.     

光声互作用模型中的Pancharatnam相位

通过解析求解简单极化激元模型的Pancharatnam相位, 研究了温度、耦合强度、声子与光子频率差、平均光子数等对其演化的影响. 结果表明,Pancharatnam相位随时间振荡,且振荡频率和振荡波形随时间变化,这种变化随着温度升高和耦合强度、声子与光子频率差增加而加大. 系统Pancharatnam相位随时间的演化在平均光子数较小时表现比较有规律,但随着平均光子数的增加,它趋于混沌化. 关键词： 极化激元 Pancharatnam 相位 Mach-Zehnder干涉仪 相干态     

模拟大气风场及其数据处理技术的研究

热层大气风速的测量可以采用干涉法来进行,由于光源（气辉辐射谱线）的强度很弱,故干涉法对测量系统要求很高。利用半导体激光器（LD）的调制特性和法布里-帕罗干涉仪(FPI)的高光谱分辨能力设计了一种用简单设备进行大气风场模拟与测量的方法。改变LD的驱动电流使其输出激光频率改变,从而模拟气辉辐射的多普勒频移,通过分析FPI获得的干涉图可检测出该频移,进而得到等效风速。模拟风速的相对误差不超过6.5%,最小模拟风速为20.01m/s,且测量结果与LD的线性调制特性很相符。使用该方法可以有效地对多普勒风速测量原理、数据处理方法、系统性能以及测量误差进行分析和评估。     

Stable multiwavelength fiber ring laser with equalized power spectrum based on a semiconductor optical amplifier

We experimentally demonstrated a new structure of a multiwavelength semiconductor optical amplifier (SOA) ring laser based on a fiber Sagnac loop filter that can generate up to 25 stable output lasing wavelengths at room temperature. By varying the length of a polarization-maintaining (PM) fiber within the Sagnac loop filter, the wavelength spacing between the output lasing wavelengths can be changed to a desired value. By tuning a polarization controller (PC) within the Sagnac loop filter, stable multiwavelength 1550-nm operation with up to 17 lasing lines within 3 dB power level variation and with a wavelength spacing of ∼0.8 nm was achieved. The optical signal-to-noise ratios (OSNRs) of all the lasing wavelengths are greater than 40 dB.     

光纤热极化过程的实时测试研究

通过热极化可以使中心对称的熔石英光纤中产生二阶非线性效应和线性电光效应。为了解各热极化过程参量对热极化产生的线性电光效应的影响,利用全保偏光纤马赫一曾德尔干涉仪构造了一套光纤热极化的实时线性电光效应测试系统,并利用其进行了光纤热极化全过程的监控测试。在线测试了热极化过程的一些参量,例如极化电压、极化时间、以及极化温度等对热极化光纤中产生的线性电光效应的影响。实时测试研究表明,在光纤中施加尽可能高的极化电场将可能在光纤中产生较高的线性电光效应。对侧边抛磨光纤结构的热极化器件,考虑到器件的抗强电场击穿能力,可选用3．o～4．0kV左右的极化直流电压。当施加3．0kV左右的极化电压时,热极化优化时间约为16min,最佳热极化加热温度约为190℃。     

一种新的白光光纤传感系统波长解调方法

提出了一种新的白光非本征法布里-珀罗干涉（EFPI）光纤传感系统的干涉谱处理方法,在白光法布里-珀罗干涉光纤传感系统中,一个中心波长为850nm的发光二极管（LED）作为宽谱光源,HR2000高分辨力微型光谱仪用来测量返回的干涉光谱。通过跟踪干涉光谱中的特定谱峰点,法布里-珀罗干涉传感器的腔长值可以被解调出来。应用反向传播神经网络,解决了单峰测量方式的级次模糊问题。反向传播神经网络能够分辨出干涉谱中不同谱峰的干涉级次,因而可以进行多个谱峰的连续跟踪。从而实现了高精密度、大动态范围的测量。进行了基于这种干涉谱处理方法的白光法布里-珀罗干涉传感系统的应变测量实验。利用该传感系统实现了精密度达0．1με,500με范围的应变测量。     

输入光特性对超快非线性干涉仪开关窗口的影响

就超快非线性干涉仪(UNI)的输入光特性对其开关窗口的影响进行了数值模拟和实验研究,输入光包括控制光脉冲和探测光脉冲。在数值模拟中,调节控制光脉冲和探测光脉冲的功率及脉宽,功率越高和脉宽越窄,窗口的形状越好。在调节过程中发现控制光脉冲和探测光脉冲都存在一个最佳的功率点使窗口的形状达到最优。如果继续增大控制光脉冲功率,会使窗口的顶部倾斜,窗口形状恶化;而继续增大探测光脉冲功率,窗口的消光比开始下降。在数值模拟的基础上进行了10Gb／s的超快非线性干涉仪全光开关实验,在实验中用连续光代替探测光脉冲以观察窗口形状。通过改变控制光脉冲和连续光功率来验证它们对超快非线性干涉仪开关窗口的影响。实验表明,应选用短而强的控制光脉冲和最优功率点的连续光,这与模拟结果吻合。     

光纤连接器端面几何参量自动测量仪

报道了一种高精度测量光纤连接器端面几何参量的自动测量仪。叙述了光纤连接器的端面几何参量的测量原理。由光纤连接器端面形貌和纤芯中心坐标,可以高精度得到曲率半径、顶点偏移量、端面倾斜角和光纤高度等影响连接器性能的关键端面几何参量。该仪器体积小,自动化程度高,用户界面友好,使用方便,可测量物理接触、角度式物理接触等类型的光纤连接器端面几何参量。实际测量证明,该测量仪有很好的重复测量精度。该测量仪与美国Dorc公司ZX-1 mini PMS测量仪和Norland公司NC3000测量仪相比,测量精度水平相当。该仪器样机已通过华东国家计量测试中心的测试。     

F-P干涉仪腔镜的不平行度对高斯光束透射特性的影响

基于多光束干涉原理,推导出了高斯光束经过两腔镜不严格平行的F P干涉仪后透射光强度的表达式。在此基础上,数值研究了F P干涉仪腔镜的不平行度对高斯光束透射特性的影响。结果表明:随着F P两腔镜不平行度的增大,透射光的峰值强度总体呈现下降的趋势,且在下降的过程中会出现波动;峰值强度位置将发生移动;光斑的均方根宽度将发生变化。