Simplified analytic solutions and a novel fast algorithm for Yb-doped double-clad fiber lasers

In this paper, continuous wave Yb³⁺-doped double-clad fiber lasers (DCFLs) with linear-cavity are investigated theoretically and numerically using the rate equations. Under the steady state conditions, the simplified analytic solutions of Yb³⁺-doped DCFLs under considering the scattering loss are deduced in the strongly pump condition. Compared with the known analytic solutions in published literatures, our analytic solutions are more accurate, especially, at higher reflectivity of output mirror. In addition, a fast and stable algorithm based on the Newton-Raphson method is proposed to simulate numerically Yb³⁺-doped DCFLs. The results by simplified analytic solutions are in good agreement with those by the numerical simulation. Moreover, we have performed the optimization of an Yb³⁺-doped DCFL using the simplified analytic solutions and the numerical simulations, respectively.     

拖曳线列阵用光纤水听器的研究

报道了光纤水听器用于拖曳线列阵的研究结果。在保证光纤水听器声相位灵敏度的前提下, 优化设计了光纤水听器的结构,降低了光纤水听器的加速度灵敏度36dB。实验测得在20-1600Hz 频段,该光纤水听器的相位灵敏度为-162．7dB,频段内灵敏度的起伏为±0．7dB,加速度灵敏度小于-30dB。     

掺铒光纤放大器中上转换过程的影响

掺杂浓度的提高影响了掺铒光纤放大器(EDFA)的性能,对经典Giles模型提出了新的要求。首先研究了高掺杂下铒离子距离较小引起的上转换过程的机理,通过优化速率方程模型分析了上转换过程对EDFA的影响,得出了在泵浦光和信号光远远大于ASE光的假设下泵浦光和信号光沿光纤长度变化的近似表达式,并将该近似分析解与解析解进行了比较。仿真结果表明上转换过程会降低随光纤传输的信号光和泵浦光,影响EDFA的放大性能,并得出了当掺铒浓度大于2.95×1025m-3时,上转换过程的影响不能忽略的结论。     

Isomorphisms of fiber spaces over Teichmüller spaces

We will be mainly concerned with some important fiber spaces over Teichmuller spaces, including the Bers fiber space and Teichmuller curve, establishing an isomorphism theorem between "punctured" Teichmuller curves and determining the biholomorphic isomorphisms of these fiber spaces.     

分析布拉格光栅破坏的两纤芯不同的光纤耦合器

进一步推广了描述纤芯不同光纤耦合器的耦合模理论，用于解释被布拉格光栅破坏的两纤芯不同光纤耦合器的耦合现象，理论分析的结果与已报道的实验结果相符，与单独的布拉格光栅所起的反射作用不同,这里布拉格光栅所起的作用主要是引入了强烈的色散，在光栅的频谱范围内使耦合器不再同步，在被布拉格光栅破坏的光纤耦合器的选择性频谱中，其边缘部分出现非常弱的波动，而在其阻带内出现非常强的凹陷。     

Widely tunable long-period fiber grating with nm-thick higher refractive index film overlay

By introducing a four-layer step-index waveguide modeling, the characteristics of long-period fiber grating (LPFG) with an nm-thick film overlay, which has higher refractive index than that of fiber cladding are investigated in detail. The influence of both the overlay thickness and refractive index on the tuning ability of LPFG is analyzed. The numerical results demonstrate that spectral response of LPFG is divided into three distinct regions as the overlay deposition increases and the shift of resonant wavelength is drastic in some special thickness range. In conjunction with higher-order cladding mode coupling and fiber cladding etching, the sensitivity of LPFG to the overlay refractive index is enhanced significantly and over 120 nm resonant wavelength tunable range is achieved.     

Simultaneous Measurement of Particle Size and Particle Velocity by the Spatial Filtering Technique

The objective of this study was to compare the measuring results of a fiber‐optical probe based on a modified spatial filtering technique with given size distributions of different test powders and also with particle velocity values of laser Doppler measurements. Fiber‐optical spatial filtering velocimetry was modified by fiber‐optical spot scanning in order to determine simultaneously the size and the velocity of particles. The fiber‐optical probe system can be used as an in‐line measuring device for sizing of particles in different technical applications. Spherical test particles were narrow‐sized glass beads in the range 30–100 μm and irregularly shaped test particles were limestone particles in the range 10–600 μm. Particles were dispersed by a brush disperser and the measurements were carried out at a fixed position in a free particle‐laden air stream. Owing to the measurement of chord lengths and to the influence of diffraction and divergent angle, the probe results show differences from the given test particle sizes. Owing to the particle‐probe collisions, the mean velocity determined by the probe is smaller than the laser Doppler mean velocity.     

应用LiNbO_3声表面波驱动的全光纤声光频移器

介绍一种工作在10.7MHz的全光纤声光频移器.它由在LiNbO_3基片上制作的叉指电极换能器产生的声表面波驱动.当驱动电功率1.5W时,频移光转换效率达35％.     

Acousto-optic mode coupling of partially coherent light in two-mode optical fibers

An acoustic pulse propagating on a two-mode fiber can act as a beam splitter in a scanning interferometer. When this device is employed in white-light interferometry, the effects of distributed coupling and dispersive interferometer arms need to be considered. A theory suitable for treating acousto-optic interaction of partially coherent light in a moving interaction region was developed. It was found that differential optical dispersion should be negligible and the acoustic pulse length short. Also the coherence time should be short but long compared to the intermodal group delay difference over a pulse length. Experiments with long acoustic pulses were performed, and fairly good agreement with theory was obtained.     

时分复用倍乘光脉冲重复率的新型光纤耦合器环状连接法分析

提出并详细分析了一种基于时分复用技术倍乘光脉冲重复率的方法：在２×２光纤耦合器的一个输入口与一个输出口间，接入时延为脉冲列半周期奇数倍的一段光纤使之形成环状连接循环耦合，而在另一输出口获得光脉冲。详细分析了该系统中光纤耦合器耦合比、插入损耗、时延光纤长度的要求，偏差的影响及其调节法，给出了理论公式、结果的计算机模拟与实验介绍；与经典的马赫陈德尔干涉仪接法及近年提出的Ｓａｇｎａｃ环接法进行了比较。该方法特别适用于对窄脉冲列进行串接复用实现重复率的多次倍乘，从而得到数千兆赫至上百千兆赫的高重复率光脉冲