A neuro-fuzzy system for X-ray spectra interpretation

A decision scheme for the interpretation of spectra from wavelength dispersive X-ray fluorescence spectrometry is described that encompasses elements from three areas of artificial intelligence: fuzzy logic, rule based expert systems and neural net technology.After transforming the recorded spectra to line spectra by appropriate background correction a reasoning scheme is applied that takes into account not only the observed spectra, but also the recording conditions and prior spectroscopic information regarding the relative emission probabilities and the usefulness of the different lines for the purpose of element identification. The latter is done on the basis of a previously described scheme to compute conditional a posteriori Bayes probabilities for a mean matrix. These different pieces of information are then assembled into a battery of fuzzy rules. The importance of the rules as well as the importance of the X-ray lines is determined in a training process, similar to the one in a feedforward back-propagation network.To further stabilize the results this network is pruned in a second training cycle. This, however, had little effect on the quality of interpretation.The advantages of this approach to the interpretation of X-ray spectra over older ones are numerous: the system adapts itself to better interpret spectra that are of greater importance to a laboratory as these are better represented in the training set; the fuzzy logic is capable of working with incomplete and uncertain knowledge, and the neural network results based on these fuzzy rules is readily interpretable by the X-ray spectroscopist as every rule can be expressed also in natural language as in any classical rule based system.On leave from Silesian University, Katowice, Poland     

Solid Phase Extraction and Simultaneous Spectrophotometric Determination of Trace Amounts of Copper and Iron Using Mixture of Ligands

 A novel sensitive and simple method for rapid and selective extraction, preconcentration and determination of iron (as its bathophenanthroline complex) and copper (as its neocuproine complex) using octadecyl silica cartridges and dual wavelength spectrophotometry is presented. The dual wavelength method (533 nm for the iron-bathophenanthroline and 454 nm for the copper-neocuproine as the analytical wavelength) is used to eliminate spectral interferences. Extraction efficiency and the influence of flow rates of sample solution and eluent, pH, amount of neocuproine, bathophenanthroline and hydroxylamine hydrochloride, type and least amount of eluent for elution of iron and copper complexes from cartridge, break-through volume and limit of detection are evaluated. The effects of various cationic and anionic interferences on percent recovery of iron and copper are also studied. Extraction efficiencies >95% are obtained by elution of cartridges with minimal amount of organic solvent. Iron and copper were determined in the range of 3–100 ng mL⁻¹. The limits of detection are 0.98 and 1.13 ng mL⁻¹ for iron and copper, respectively. The proposed method is applied successfully to the determination of both analytes in river, tap and well water samples. Author for correspondence. E-mail: yyamini@modares.ac.ir Received September 18, 2002; accepted December 12, 2002 Published online May 5, 2003     

Synthesis and characterization of hollandite-type material intended for the specific containment of radioactive cesium

The hollandite Ba₁Cs_0.28Fe_0.82Al_1.46Ti_5.72O₁₆, which has been proposed for the cesium-specific conditioning, can be synthesized either by an alcoxyde or a dry route. In both cases, a two-step protocol is applied, i.e., a calcination at 1000 °C followed by a sintering at 1200 °C. After sintering, both synthetic processes lead to a tetragonal form. According to the X-ray diffraction (XRD) patterns collected at the barium and the cesium K absorption edges, the different positions of these two elements have been evidenced with a more centered position in the oxygen cubic site of the tunnel for Ba than for Cs. On the contrary, after calcination, the two synthetic routes yield different products. The alcoxyde route gives rise to a mixture of the aforementioned Cs- and Ba-containing tetragonal I4/m hollandite, a Cs-only-containing monoclinic I2/m hollandite and an unidentified phase with a weak coherence length containing only Ba. The dry route yields a single tetragonal hollandite material containing Ba and Cs slightly different in composition from the targeted compound.     

Quantitative millimetre wavelength spectrometry at pressures approaching atmospheric: II. Determination of oxygen at atmospheric pressure

A millimetre wavelength (MMW) Fabry-Perot cavity spectrometer described in earlier work has been applied to the measurement of oxygen absorption at 60 GHz and atmospheric pressure in a gas matrix of nitrogen. The spectrometer has also been modified such that the MMW source is stabilised by a sub-harmonic microwave signal transmitted by an infrared carrier on a single mode telecommunications fibre optic. This is a step towards developing an instrument comprising minimal electronic components that can perform MMW spectrometry remotely. Oxygen determinations were achieved by monitoring the change in the quality factor (Q) of a resonant Fabry-Perot cavity due to the presence of an absorbing sample. The MMW absorption of the sample was determined by incrementing the frequency modulation (FM) deviation of the source frequency scanning the cavity resonance profile. The response curve of absorption signal versus fraction of oxygen in nitrogen was found to be linear throughout the working range of 1-100% O₂ (v/v) in N₂ with a slope of (1.407±0.007)×10⁻⁴ m⁻¹ (% O₂)⁻¹. The detection limit (3× standard deviation of the background) was found to be ∼0.8% (v/v). The MMW technique employed is advantageous since, unlike common MMW techniques, there is no vacuum requirement. Application of this method, to the monitoring of oxygen in gas mixtures of practical importance, is proposed. Values of the oxygen spectral absorption coefficients of lines between 55 and 60 GHz were measured at reduced pressure and found to be within ±2% of previous literature values. A pressure correction coefficient for O₂ absorption at 60 GHz in the 45-121 kPa range was obtained and found to be (1.354±0.014)×10⁻⁴ m⁻¹ kPa⁻¹.     

双波长分光光度法同时测定贵金属钯和锇

本文提出了在对羟基苯基荧光酮和溴化十六烷基三甲烷基甲胺存在下，双波长分光光度法同时测定微量和锇的新方法，在ｐＨ＝７．６～８．０的磷酸盐介质中，钯和锇的对羟基苯基荧光酮－ＣＴＭＡＢ配合物吸收光谱相互重叠，选择测定钯配合物的波长对为５８０．５ｎｍ与５３０．５ｎｍ，测定锇配合物的波长对为５５３．５ｎｍ与６０４．５ｎｍ，钯含量在０～７．０μｇ／１０ｍＬ范围内，锇含量在０～９．０μｇ／ｍＬ范围内，与ΔＡ值呈     

Wavelength effect on the photoinduced reaction of polymethylmethacrylate

Polymethylmethacrylate (PMMA) containing benzophenone (BP) was photo-irradiated with monochromatic radiation of wavelength 260–360 nm using the Okazaki Large Spec-trograph (OLS). On irradiation of PMMA films containing BP in air, the sensitized main-chain scission and photocrosslinking of PMMA took place simultaneously. These reactions are dependent on irradiation wavelength. The threshold wavelength for both reactions is found to be ca. 380 nm. The number of main-chain scission and amount of gel increased with the increase of BP concentration in PMMA. Photosensitized main-chain scission favors the irradiation of radiation at ca. 280 nm and photocrosslinking takes place efficiently with the exposure of 340 nm radiation. A possible mechanism for photosensitized reaction is proposed. © 1995 John Wiley & Sons, Inc.     

邻二甲苯…Ar, N2, NH3(ND3)范德华复合物的共振双光子电离光谱

在超声分子束中，使用双光子共振电离光谱技术和飞行时间质谱技术研究了复合物邻二甲苯…Ar．N2，NH3(ND3)．通过理论计算及同位素光谱效应．合理地归属了这些复合物的光谱．并由此获得这些复合物分子问各种模式的振动频率．     

火焰原子吸收光谱法测定茶叶中的锰

介绍悬浮液进样-次灵敏线火焰原子吸收光谱法测定茶叶中的锰的方法。以琼脂为悬浮剂，将茶叶样品均匀、稳定地悬浮于琼脂溶胶中，直接喷入空气-乙炔火焰中，利用锰280.1nm次灵敏线，以工作曲线或标准加入法测定锰的含量，方法简便、快速，用于测定茶叶和桃叶样品中的锰，结果准确。     

双波长分光光度法测定湿法炼锌净化液中的痕量锗

选择水杨基荧光酮－乳化剂ＯＰ－盐酸为显色体系，应用双波长分光光度法扣除硫酸锌的基体干扰，不分离直接测定了湿法炼锌过程中硫酸锌净化液中的痕量锗。测定范围在０－４０ｍｇ／Ｌ。本法应用于株洲冶炼厂锌净化液中锗的测定，结果与该厂长期的萃取－比色法结果相吻合，而测定速度较萃取－比色法至少提高了一倍。     

Enhancement of signal-to-noise level by synchronized dual wavelength modulation for light emitting diode fluorimetry in a liquid-core-waveguide microfluidic capillary electrophoresis system

The signal-to-noise level of light emitting diode (LED) fluorimetry using a liquid-core-waveguide (LCW)-based microfluidic capillary electrophoresis system was significantly enhanced using a synchronized dual wavelength modulation (SDWM) approach. A blue LED was used as excitation source and a red LED as reference source for background-noise compensation in a microfluidic capillary electrophoresis (CE) system. A Teflon AF-coated silica capillary served as both the separation channel and LCW for light transfer, and blue and red LEDs were used as excitation and reference sources, respectively, both radially illuminating the detection point of the separation channel. The two LEDs were synchronously modulated at the same frequency, but with 180°-phase shift, alternatingly driven by a same constant current source. The LCW transferred the fluorescence emission, as well as the excitation and reference lights that strayed through the optical system to a photomultiplier tube; a lock-in amplifier demodulated the combined signal, significantly reducing its noise level. To test the system, fluorescein isothiocyanate (FITC)-labeled amino acids were separated by capillary electrophoresis and detected by SDWM and single wavelength modulation, respectively. Five-fold improvement in S/N ratio was achieved by dual wavelength modulation, compared with single wavelength modulation; and over 100-fold improvement in S/N ratio was achieved compared with a similar LCW-CE system reported previously using non-modulated LED excitation. A detection limit (S/N = 3) of 10 nM FITC-labeled arginine was obtained in this work. The effects of modulation frequency on S/N level and on the rejection of noise caused by LED-driver current and detector were also studied.