Investigation on the Extraction Mechanism of Au（I） from Cyanide Solution with Quaternary Ammonium System

During the past decades, there has been a renewed interest in the application of solvent extraction to the recovery of Au (I) from cyanide solutions1,2. Among those various extractants, the amine extractants with the addition of organic phosphorus oxide as cosolvent have been widely investigated3,4. Various diluents and modifiers have been selected to optimize the extraction system so as to increase the loading capacity, improve the selectivity and/or reduce emulsification5. Quaternary amm…     

A MORPHOLOGICAL STUDY OF POLY（DIVINYLBENZENE-co-ACRYLIC ACID） IN CROSSLINKING PRECIPITATION POLYMERIZATION

Divinylbenzene-80 （DVB-80） and polar monomer acrylic acid （AA） having hydrogen bonding at a total monomer loading of 5 vol% were precipitated-copolymerized in a variety of organic solvents with 2,2＇-azobis（isobutyronitrile） （AIBN） as initiator. The experiments were investigated from a two-dimensional matrix, i.e., the actual crosslinking degree of DVB varying from 0 to 80% and the solvent composition varying from 0 to 100% of toluene mixture with acetonitrile, when the mixture of acetonitrile and toluene was used as the reaction solvent. Under various reaction conditions, six distinct morphologies including soluble polymers, swellable microgels, coagulum, irregular microparticles, and nano-/micrometer microspheres were formed and the structures of these polymer architectures were described. A morphological map was utilized to discuss the effects of both crosslinking degree of DVB and composition of solvent on the transitions between morphology domains. The results demonstrated that the microspheres are formed by an internal contraction due to the marginal solvency of the continuous phase and the crosslinking of the polymer network through the covalent bonding from DVB as well as the interchain hydrogen-bonding between the carboxylic acid units.     

毛细管气相色谱法测定兰索拉唑中有机溶剂残留量

以N,N-二甲基甲酰胺(DMF)为溶剂,丁酮为内标,采用PV-101毛细管色谱柱 (30 m×0．22 mm),氢火焰离子化检测器,建立兰索拉唑中五种有机溶剂甲醇、乙醇、丙酮、二氯甲烷、乙酸乙酯残留量的定量分析方法。五种有机溶剂检出限分别为0．002 4％,0．002 4％, 0．001 2％,0．000 6％,0．000 6％;在10-1000 mg·L-1浓度范围内,各组分线性关系良好;对应的平均回收率分别为100．8％±3．6％,102．1％±2．3％,99．97％±4．1％,99．63％±2．7％, 102．3％±3．5％。     

Application of Liquid Crystalline NMR Solvents to a Mixture of Ketones

A series of dilute liquid crystalline solvents are used to study the effect of slight anisotropy caused by partial alignment on chemical shift and residual dipolar coupling (RDC) in small molecules. The residual dipolar couplings between protons in solutes are found to be almost independent of the local environment. It is also found that the chemical shift does not change over the concentration range observed. A linear relationship between residual dipolar coupling and liquid crystal concentration is observed at relatively low concentrations, but is severely violated at high concentrations.     

Solvent effect on heats of protonation of some amines

The heats of protonation of n-pentylamine, dipentylamine, tributylamine and heats for the first protonation step of 1,8-diamino-3,6-dioxaoctan, diazacrownether 22 and cryptand 222 in pure acetonitril and propylene carbonate and of diazacrownether 22 and dibenzosubstituted ligand 22BB in water + acetonitrile mixtures have been measured at 298.15 K using calorimetric titrations. The values of the reaction enthalpies in the solvents as well as the data in aqueous and methanol solutions reported in literature are analysed in terms of the simple electrostatic model and thermodynamic parameters of transfer (solvation) of the reactants. Estimation of the electrostatic and covalent contributions to standard enthalpy of transfer of the reactions from water to non-aqueous and mixed solvents has been made.     

Thermodynamic parameters ΔΔH and ΔΔS as probes for the transition state in the reaction of N-phenyltriazolinedione with alkenes in nucleophilic solvents

The thermodynamic parameters, ΔΔH^# and ΔΔS^#, were determined for the interception of an intermediate, with the structural characteristics of an aziridinium imide, by nucleophilic solvents during the reaction of 2-methyl-2-butene with N-phenyltriazolinedione. The experimentally measured parameters were found to be in favor of an S_N2-‘like’ transition state and showed strong dependence on the bulkiness of the incoming molecule of the nucleophile-solvent.     

Sunlight assisted solvent free synthesis of tert-butylperesters

Abstract

A green and efficient methodology has been developed for the direct conversion of aryl aldehydes to the corresponding tert-butyl peresters. The reaction has been carried out in absence of any solvent and the sunlight is used as the green source of energy. In this reaction tetrabutylammonium iodide (TBAI) acts as the mild organo catalyst and tert-butyl hydroperoxide (TBHP) serve as the source of tert-butyl group.     

顶空气相色谱法测定卷烟包装材料中的溶剂残留

采用顶空气相色谱法对卷烟包装材料中溶剂残留(乙酸乙酯、乙酸丁酯、甲苯、乙苯等)进行分析,并讨论了各种条件对测定的影响。分析结果表明,该方法对上述4种溶剂残留的检出限范围分别为乙酸乙酯0.4~120 mg.L-1,甲苯0.4~120 mg.L-1,乙酸丁酯1.2~600 mg.L-1,乙苯0.5~150 mg.L-1,测定结果的相对标准偏差为2.5%~3.1%,样品的回收率为90%~95%;方法用于卷烟包装材料实样中溶剂残留的分析。     

Coupling of flow injection wetting-film extraction without segmentation and phase separation to flame atomic absorption spectrometry for the determination of trace copper in water samples

A flow injection wetting-film extraction system without segmentor and phase separator has been coupled to flame atomic absorption spectrometry for the determination of trace copper. Isobutyl methyl ketone (MIBK) was selected as coating solvent and 8-hydroxyquinoline (oxine) as the chelating reagent. By switching of a 8-channel valve and alternative initiation of two peristaltic pumps, MIBK, sample solution containing copper chelate of oxine, and air-segment sandwiched eluting solution (1.0 mol l⁻¹ nitric acid) were sequentially aspirated into an extraction coil made of PTFE tubing of 360 cm length and 0.5 mm i.d. The formation of organic film in the wall of the extraction coil, extraction of the copper chelate into the organic film and back-extraction of the analyte into the eluting solution occurred consecutively when these zones aspirated into the extraction coil were propelled down the extraction coil by a carrier solution at a flow rate of 2 ml min⁻¹. After leaving the extraction coil, the concentrated zone was transported to the nebulizer at its free uptake rate for atomization. Under the optimized conditions, an enrichment factor of 43 and a detection limit of 0.2 μg l⁻¹ copper were achieved at a sample throughput rate of 30 h⁻¹. Eleven determinations of a standard copper solution of 60 μg l⁻¹ gave a relative standard deviation of 1.5%. Foreign ions possibly present in tap water and natural water did not interfere with the copper determination. The developed method has been successfully used to the determination of copper content of tap water and river water.     

Flow system to gas capture from a nebulized solution

The use of aerosol produced in a nebulization chamber is proposed as an alternative to gas sample capture in flow systems. This paper describes the coupling of a sampling interface with a flow system, for in situ gas monitoring. Aspects related with the behavior of aerosol formation and gas solubilization in liquid drops are discussed. The method is applied to the determination of residual lime in acidic soils. Aliquots of 5.0 ml of 1.0 mol l⁻¹ HCl were mixed with soil samples (1 g). The CO₂ released from these samples was captured by a nebulized aerosol and determined conductivity. The analytical curve from 1.0×10⁻² to 5.0×10⁻² mol kg⁻¹ CaCO₃ was ploted applying the matrix matching approach. This proposition, allowed an increase in the sensibility with detection limit of 6.0×10⁻³ mol kg⁻¹. The precision was good (R.S.D. <3%) for an analytical frequency of 22 determinations per hour. A fair agreement, at 95% confidence level, was found between the results from the proposed method and certified values of the investigated samples.