光纤型宽带可调连续波差频产生中红外激光器转换效率的研究

以掺镱光纤激光器为抽运源、掺铒光纤激光器后接掺铒光纤放大器为信号源,利用周期极化掺镁铌酸锂晶体,研究了全光纤化差频产生中红外激光器的转换效率特性。结果表明,抽运光和信号光偏振态影响差频产生过程的转换效率,利用偏振控制器,可将抽运光和信号光偏振方向调节到与晶体光轴方向平行,以获得高的转换效率。抽运光和信号光的光束质量既影响差频产生过程的转换效率,又决定晶体纵向位置的容限,当聚焦系统由自聚焦透镜和焦距100mm平凸透镜组成时,相对转换效率达0.717mW-2,晶体纵向位置容限为44mm。此外,差频光在3126.36~3529.6nm范围内调谐时,转换效率基本保持不变。     

蓝绿光敏感的非水溶性光致聚合物特性研究

报导了一种新型蓝绿光敏感的非水溶性光致聚合物材料,这种材料以聚醋酸乙烯酯为成膜物,9-乙烯基咔唑(NVC),甲基丙烯酸2-苯氧乙脂(POEA)和双季戊四醇五丙烯酸酯为单体,Dye3和Dye4为光敏剂,邻氯代六芳基双咪唑(O-CL-HABI)为共引发剂.本材料能同时对蓝光和绿光敏感,用蓝光和绿光分别或同时对该材料曝光,可得到清晰图像.测得的两种衍射效率分别不低于80%.     

空间频率对透射式全息图衍射率的影响

为研究干涉条纹空间频率与透射式全息图衍射率的关系,在相同条件下,拍摄以平面波、发散的和会聚的球面波分别作参考光、物光的透射式全息图,通过实验测量其衍射效率,同时计算了干涉条纹的空间频率。然后以会聚的球面波为物光,平面波为参考光,分别改变入射角和球面波会聚点到记录面的距离制作另外4块透射式全息图,并计算了它们的空间频率,测量了其衍射效率。结果表明：在相同条件下制作透射式全息图时,衍射效率只由空间频率决定,与使用何种参考光和物光无关,空间频率仅随参考光和物光的夹角变化而变化。     

高功率光纤激光器二级抽运技术的理论分析

从理论上分析了高功率光纤激光器直接抽运和二级抽运的斜率效率和热管理问题. 计算结果表明:波长为975 nm的激光直接抽运产生波长为1070 nm的激光时,理论斜率效率为80%,但当抽运光功率为10 kW时,在强制水冷条件下纤芯极值温度也难以降到150 ℃以下;在二级抽运技术中,波长为1018 nm的激光抽运产生波长为1070 nm的激光时,若采用传统的包层抽运技术,其斜率效率不足20%,如果抽运功率填充因子由0.0025提高到0.1,则理论上斜率效率可由18.5%提高到80.9%,从而总斜率效率由15.5 关键词： 二级抽运 功率填充因子 斜率效率 热管理     

Enhancement of light-emitting efficiency using combined plasmonic Ag grating and dielectric grating

Based on the analysis of the near-field evanescent wave in total internal reflection, the flip-chip light-emitting diode (LED) structure was proposed by placing a plasmonic Ag grating and a perforated sapphire grating in the substrate. The finite difference time domain (FDTD) method has been applied to study the spectral properties of the hybrid structure and the enhancement factor of light extraction efficiency of the LED model. From the computation examples, the effects of structure parameters on the extraction enhancement have been investigated. The results indicate that the plasmonic grating can enhance the near-field evanescent wave and couple it to propagation wave in the specific wavelength bands, which leads to the photons emitting out of the LED chip with high extraction efficiency. Due to the combined gratings used, the enhancement factor of the light extraction efficiency can reach approximately 4 times at a relatively longer wavelength.     

过渡金属卤化物改性非碳基吸附剂脱汞研究

以6种大比表面积非碳基成分为载体,经过渡金属卤化物改性处理后制成汞吸附剂,并对其不同烟气气氛和温度下的汞吸附性能及汞氧化率进行了研究。CuCl_2改性氧化铝在各种烟气条件下均表现出较好的汞吸附性能。FeCl_3改性沸石的汞脱除率相对略低,但它制作成本较低。这两种非碳基吸附剂在未来有较好的应用前景。改性吸附剂的最适宜反应温度100～200℃。     

不同金属在催化脱硝过程中作用研究

采用共浸渍法和分步浸渍法在氧化铝载体上通过调节金属元素的负载量和负载顺序制备了多种催化剂,测试了其在NH3作为还原剂条件下的低温催化脱硝活性,研究各种活性组分在脱硝过程中的作用,考察浸渍顺序对脱硝性能的影响。在(?)(NO)=500×10~(-6),n(NH_3):n(NO)=1:1和(?)(O_2)=3.6%的条件下进行试验,结果表明,Mn在脱硝反应中是主要的活性组分,而Fe和Zr是助催化组分;浸渍顺序对催化剂脱硝活性有一定影响;当Fe负载量达到10%时,制备的催化剂5Zr-5Mn-10Fe/Al_2O_3脱硝活性最佳。     

广义不可逆Braysson热机的性能优化

建立了一个考虑热阻、热漏和内不可逆性且热源和工质之间满足牛顿传热规律的不可逆Braysson热机模型。导出了该模型下输出功率、效率和生态学目标函数的表达式。计算了最大输出功率、最大效率和最大生态学目标函数及它们对应的参数值并通过图来反映它们的变化情况。讨论了热漏、内不可逆性对该热机各种性能参数的影响同时给出了一些重要参数的优化范围。所得结果对实际Braysson热机的优化设计提供了理论依据。     

Millimeter wave beams diffracted from reflecting gratings

According to the angular-spectrum method, a radiation beam of an antenna horn in the Fresnal region is decomposed into the plane waves with the fast Fourier transform algorithm and the waves diffracted from a reflection grating are superposed as a diffracted beam. Compared with the reflected beam from the same size mirror, the radiation half width of the diffracted beam from a grating is narrower and its lateral shape is shift. These performances have been experimentally verified at Ka-band by: (1). The relative diffraction efficiencies in the first order with two triangular gratings which is put along propagating direction of a beam produced by a conical lens-horn. (2). H-plane lateral width with power—3dB lapsed of the focus beam from a grating and a mirror in a grating spectrometer for millimeter waves (25–100 GHz).     

Efficiency of connected binary block designs when a single observation is unavailable

In this paper the problem of finding the design efficiency is considered when a single observation is unavailable in a connected binary block design. The explicit expression of efficiency is found for the resulting design when the original design is a balanced incomplete block design or a group divisible, singular or semiregular or regular with ₁>0, design. The efficiency does not depend on the position of the unavailable observation. For a regular group divisible design with ₁>0, the efficiency depends on the position of the unavailable observation. The bounds, both lower and upper, on the efficiency are given in this situation. The efficiencies of designs resulting from a balanced incomplete block design and a group divisible design are in fact high when a single observation is unavailable.The work of the first author is sponsored by the Air Force Office of Scientific Research under Grant AFOSR-90-0092.On leave from Indian Statistical Institute, Calcutta, India. The work of the third author was supported by a grant from the CMDS, Indian Institute of Management, Calcutta.