Large set of P3‐decompositions

Let G=(V(G),E(G)) be a graph. A (n,G, λ)‐GD is a partition of the edges of λK_n into subgraphs (G‐blocks), each of which is isomorphic to G. The (n,G,λ)‐GD is named as graph design for G or G‐decomposition. The large set of (n,G,λ)‐GD is denoted by (n,G,λ)‐LGD. In this work, we obtain the existence spectrum of (n,P₃,λ)‐LGD. © 2002 Wiley Periodicals, Inc. J Combin Designs 10: 151–159, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/jcd.10008     

Monte Carlo study of interfacial silicon suboxide layers and oxidation kinetics

A simple simulation scheme that simultaneously describes the growth kinetics of SiO₂ films at the nanometer scale and the SiO_x/Si interface dynamics (its extent, and spatial/temporal evolution) is presented. The simulation successfully applies to experimental data in the region above and below 10 nm, reproduces the Deal and Grove linear-parabolic law and the oxide growth rate enhancement in the very thin film regime (the so-called anomalous region). According to the simulation, the oxidation is governed mainly by two processes: (a) the formation of a transition suboxide layer and (b) its subsequent drift towards the silicon bulk. We found that it is the superposition of these two processes that produces the crossover from the anomalous oxidation region behavior to the linear-parabolic law.     

PVK∶DBVP掺杂体系的能量转移及发光性质的研究

研究了不同比例的PVK与齐聚PPV衍生物DBVP掺杂体系的能量转移和发光特性.通过对PVK,DBVP及PVK:DBVP掺杂体系的UV-vis,PL和PLE光谱的研究,分析了PVK与DBVP之间的能量转移过程.利用PVK在体系中类似于溶剂的分散作用,制备了结构为ITO/PEDOT/PVK:DBVP/LiF/Al的电致发光器件,研究了掺杂体系的电致发光性能.结果表明,在掺杂体系的光致发光和电致发光中,PVK的发射被有效地抑制,PVK与DBVP之间发生了非常有效的能量转移,通过调节PVK与DBVP的比例,可以获得蓝色和绿色发光,同时可以改善器件的发光性能,当PVK与DBVP的重量比为1∶2时,器件的绿色发光效率达到1·06cd/A,此时发光亮度为52cd/m2.     

用能量法求多自由度振动系统的角频率

利用简谐振动能量方程，通过分析振幅矢量的关系，用能量法求多自由度振动系统的角频率或简正振动频率。     

Simple, expedient methods for the determination of water and electrolyte contents of cellulose solvent systems

The concentrations of water, W, and electrolytes present in solutions of LiCl in N,N-dimethylacetamide, LiCl/DMAc, and of tetrabutylammonium fluoride. x-hydrate in DMSO, TBAF.xW/DMSO can be accurately and expediently determined by three independent methods, UV–vis, FTIR and EMF measurement. The first relies on the use of solvatochromic probes whose spectra are sensitive to solution composition. It is applicable to W/LiCl/DMAc solutions but not to TBAF.xW/DMSO, because the charge-transfer complex bands of the probes are suppressed by strong interactions with the latter electrolyte. Integration of ν_OH band of water may be employed in order to determine [W], hence [electrolyte] by weight difference. EMF measurement uses ion-selective electrodes in order to determine [electrolyte], hence [W] by weight difference. Results of the latter method were in excellent agreement with those of FTIR. The reason for the failure of Karl Fischer titration is addressed, and the relevance of the results obtained to functionalization of cellulose under homogenous solution conditions is briefly commented on.     

Modification of the surface state of rough substrates by two different varnishes and influence on the reflected light

Modification of the visual appearance when a rough surface is covered by a varnish is mostly attributed to the levelling of the substrate surface, which depends on the molecular weight of the varnish. The topography of varnished surfaces, however, has never been measured directly. Surfaces of varnishes applied over glass substrates of varying roughness were studied, therefore, using mechanical profilometry. Two different varnishes made with a low and a high molecular weight resin were studied. Both varnishes lower the r.m.s. roughness of the substrates and filter the high spatial frequencies. These results are amplified for the varnish containing the low molecular weight resin. The light reflected by the varnished samples is modelled from these topographical data. Its angular distribution, calculated from the probability density of slopes is presented, taking into account separately the air/varnish and the varnish/substrate interfaces. These analyses are presented in a back-scattering configuration. They show that varnishing significantly reduces the angular width of the reflected light and that this effect is magnified for the low molecular weight resin. Modelling furthermore shows that the influence of the roughness of the varnish/substrate interface is negligible in the total reflected light.     

中国股市长记忆的修正R/S分析

本文在比较各种长记忆检验方法优缺点的基础上,采用修正的R/S分析检验我国沪深两股市日收益和日绝对收益序列的长记忆性。结果表明在0.05的显著水平下,两股市的日收益序列均无长记忆,但深圳成指日收益序列的记忆长度比上证综指日收益序列的记忆长度长;以日绝对收益序列为代表的波动序列具有较强的长记忆性。     

化整为零:聚合物/粘土纳米复合材料的微观结构和阻隔性能

在聚合物基体中掺入少量的层状硅酸盐所制备的聚合物／粘土纳米复合材料，其阻隔性能明显地优于纯聚合物及其传统的复合材料。实验及分析结果表明，聚合物／粘土纳米复合材料的微观结构和阻隔性能主要受控于粘土剥离后的径厚比．一简单的重整化群模型被用来评估粘土几何因素（诸如径厚比、取向、剥离程度等）对聚合物／粘土纳米复合材料阻隔性能的影响，所得到的逾渗阈值及最佳粘土含量与实验结果吻合。     

A dynamical test of phase transition order: New things in old places or old wine in new bottles

We first discuss nonlinear aspects of phase transition theory applied to a particular liquid crystal phase transition. A simple derivation is given to show how two coupled Goldstone modes (one appearing as gauge fluctuations of the ordered phase) can force a phase transition, against all expectations, to take place discontinuously (theory of Halperin, Lubensky, and Ma)-but the discontinuity may be immeasurably small. Then, we describe a new dynamical test of phase transition order, developed by Cladiset al., that turns out to be more sensitive than x-ray diffraction and adiabatic calorimetry. Quantitative data found by this new method are in excellent agreement with the measurements of adiabatic calorimetry and x-ray diffraction as well as expectations implicit in the predictions of HLM.This is the text of an after-banquet talk given at the CNLS Workshop on the Dynamics of Concentrated Systems.     

Rehabilitation of the Gauss-Jordan algorithm

Summary In this paper a Gauss-Jordan algorithm with column interchanges is presented and analysed. We show that, in contrast with Gaussian elimination, the Gauss-Jordan algorithm has essentially differing properties when using column interchanges instead of row interchanges for improving the numerical stability. For solutions obtained by Gauss-Jordan with column interchanges, a more satisfactory bound for the residual norm can be given. The analysis gives theoretical evidence that the algorithm yields numerical solutions as good as those obtained by Gaussian elimination and that, in most practical situations, the residuals are equally small. This is confirmed by numerical experiments. Moreover, timing experiments on a Cyber 205 vector computer show that the algorithm presented has good vectorisation properties.