Heterogeneous continuous flow synthetic system using cyclohexane-based multiphase electrolyte solutions

The discovery that supporting electrolytes can be effectively confined in typical organic solvents in a c-Hex-based multiphase electrolyte solution has led to the development of a novel heterogeneous continuous flow synthetic system. PTFE fiber functions as a separation filter that can efficiently isolate the c-Hex phase from multiphase electrolyte solutions. This system has demonstrated both electrochemical solvating and carbon-carbon bond forming reactions. Hydrophobic substrates can be introduced into the reactor as c-Hex solutions, which are then electrochemically transformed into the target hydrophobic products that pass through the PTFE fiber as c-Hex solutions.     

Evaluation of photodynamic therapy (PDT) procedures using microfluidic system

A hybrid PDMS/glass microfluidic system for evaluation of the efficiency of photodynamic therapy is presented. 5-aminolevulinic acid (ALA) was used as a precursor of photosensitizer. The geometry of the microdevice presented in this paper enables to test different concentrations of the photosensitizer in a single assay. The viability of the A549 cells was determined 24 h after PDT procedure (irradiation with light which induced a photosensitizer accumulated in carcinoma cells, λ = 625 nm). The presented results confirmed the possibility to perform the photodynamic therapy process in vitro in microscale and the possibility to assess its effectiveness. Moreover, because two identical microstructures on a single chip were performed, the microchip can be used for examination simultaneously various cell lines (carcinoma and normal) or various photosensitizers.     

分子动力学模拟研究[Bmim][PF_6]+水+醇三元体系的微观结构和分子间相互作用(英文)

研究离子液体体系的微观结构和分子间相互作用具有重要意义.本文对1-丁基-3-甲基咪唑六氟磷酸盐([Bmim][PF6])+水+乙醇和[Bmim][PF6]+水+异丙醇三元体系进行了分子模拟研究,计算了径向分布函数和不同组成的水-醇混合溶剂与离子液体阴阳离子间的相互作用能,并将其分解为库仑相互作用能和Lennard-Jones(LJ)势能.在此基础上,研究了溶液体系的微观结构、分子间相互作用和相行为.结果表明,水倾向于与离子液体阴离子和阳离子极性部分作用,醇倾向于与阴离子和阳离子非极性部分作用;库仑力主导阴离子-溶剂相互作用,色散力主导阳离子-溶剂相互作用,阴阳离子的缔合状态对色散力影响较小,对库仑力的影响非常显著.     

分子动力学模拟研究[Bmim][PF6]+水+醇三元体系的微观结构和分子间相互作用

研究离子液体体系的微观结构和分子间相互作用具有重要意义. 本文对1-丁基-3-甲基咪唑六氟磷酸盐([Bmim][PF₆])+水+乙醇和[Bmim][PF₆]+水+异丙醇三元体系进行了分子模拟研究, 计算了径向分布函数和不同组成的水-醇混合溶剂与离子液体阴阳离子间的相互作用能, 并将其分解为库仑相互作用能和Lennard-Jones(LJ)势能. 在此基础上, 研究了溶液体系的微观结构、分子间相互作用和相行为. 结果表明, 水倾向于与离子液体阴离子和阳离子极性部分作用, 醇倾向于与阴离子和阳离子非极性部分作用; 库仑力主导阴离子-溶剂相互作用, 色散力主导阳离子-溶剂相互作用, 阴阳离子的缔合状态对色散力影响较小, 对库仑力的影响非常显著.     

A Multicolumn Ion Chromatographic Determination of Nitrate and Sulfate in Waters Containing Humic Substances

Abstract

A three-column ion chromatographic system for the removal of humic substances from natural waters, and subsequent on-line concentration and determination of nitrate and sulfate using non-suppressed ion chromatography is presented. Humic substances are removed using disposable adsorption columns packed with chemically bonded amine silica material. The sample is directly transfered to an ion exchange column where the anions are concentrated ca 10 times. After reversing the flow, the ions are transferred to a third column where they are separated and quantified. The detection limit is less than 1 mg L^?1 of nitrate or sulfate in water containing 45mgL^?1 of humic acid.     

纳米CoSe修饰氮掺杂多孔碳的可控制备及其锂硫电池多硫化物的催化转化效应

锂硫电池中较差的循环稳定性和倍率性能是实现锂硫电池商业化的技术障碍,其主要原因之一是多硫化物在硫电极内的电化学转化动力学较为缓慢。为此,我们以ZIF-9为前驱体,采用先碳化,再酸化刻蚀,最后硒化的方法合成了含少量催化剂的CoSe修饰氮掺杂多孔碳(CoSe/NC)电极材料,以期提高硫电极内多硫化物的电化学转化动力学性能,并通过流动液相三电极体系对该材料进行电化学动力学表征。结果显示,相较于对比材料,CoSe/NC能够加快多硫化物的氧化还原反应速率,在 0.2mA·cm^-2电流密度下,多硫化物氧化还原反应在CoSe/NC电极上有最小的反应过电位;同时,在0.1 V过电位下,各氧化还原反应也有最大的响应电流。因此,将 CoSe/NC作为硫宿主材料组装电池展现了优异的电化学性能：在 1C(1C=1 675 mA·g^-1)下初始放电比容量为1 068 mAh·g^-1,经过500次循环后,可逆容量仍保持在693 mAh·g^-1。另外,在3C的高电流密度下,放电比容量可高达819 mAh·g^-1。     

十二烷基伯胺盐酸盐与十二烷基聚氧乙烯硫酸钠复配体系中的表面性质

研究了十二烷基胺盐酸盐(DAC)和十二烷基聚氧乙烯硫酸钠(AES)复配体系的表面性质与胶束化行为.发现该体系在广泛的复配比例区间和温度区间内保持了极为优异的表面活性,测定了该体系的临界胶束浓度(cmc)与其对应的表面张力(γcmc)的具体值,并研究了温度、pH值和离子强度等环境因素对相关体系的影响.     

陈化体系组成对Ce0.65Zr0.35O2储氧材料性能的影响

采用共沉淀法制备了Ce_0.65Zr_0.35O₂(CZ)储氧材料, 在传统的水陈化体系中引入了乙醇, 研究了乙醇的加入对CZ储氧材料性能的影响. 对所制备样品进行了傅里叶变换红外(FTIR)光谱、X射线光电子能谱(XPS)、粉末X射线衍射(XRD)、扫描电镜(SEM)、N₂吸附-脱附、储氧量(OSC)和H₂程序升温还原(H₂-TPR)的表征, 并考察了以CZ储氧材料为载体制备的单钯催化剂的三效性能. 结果表明, 乙醇引入陈化体系对样品的结构和性能有显著影响. 以醇水共存体系陈化制备的CZ储氧材料颗粒小、堆积松散、孔径分布宽、孔容大, 具有优异的储氧性能和热稳定性, 经1000 °C焙烧后, 比表面积为29.3 m²·g^-1, 储氧量仍高达520 μmol·g^-1. 以此为载体制备的单钯催化剂, 空燃比操作窗口宽, 对C₃H₈、CO、NO的转化明显优于水陈化体系制备的储氧材料所制备的催化剂.     

温控聚乙二醇两相体系中纳米钯催化肉桂醛选择性加氢反应

将具有“高温混溶、室温分相”功能的聚乙二醇4000(PEG₄₀₀₀)与甲苯-正庚烷组成的两相体系用于纳米钯催化的肉桂醛选择性加氢反应中.在优化的反应条件下,肉桂醛转化率和氢化肉桂醛选择性分别为99%和98%.钯纳米催化剂经简单分相即可与产物分离,且循环使用8次,其活性和选择性基本保持不变.     

Sample Injection for Capillary Electrophoresis on a Micro Fabricated Device/On Chip CE Injection

Abstract

Reproducible injection for capillary electrophoresis on a micro device/Lab on chip is not an easy task. Different injection designs (e.g., T‐type, double T‐type, cross) and different injection modes have been applied (pinched injection, gated injection, optically gated injection, pressure/pneumatic injection, double L injection) with various analytes. Problems and properties of the different modes are described.