纤维复合材料透射式光弹性方法中的偏振光学问题

本文总结了用显微激光分析仪对一般纤维增强复合材料进行透射式光弹性研究的近期工作。针对纤维复合材料违反传统光弹理论的偏振光学行为,讨论了纤维、基体的双折射率不同以及由纤维与基体的界面两侧出射的光在Airy斑重叠区发生干涉等问题,从更一般的角度探讨了最近的文章中所提出的新光弹公式中所含两个滞后量的存在性。      

双轴应力状态下正交异性动态光弹性应力——光性定律研究

基于静态下Ｈｙｅｒ和Ｌｉｕ表述的正交异性应力－光性定律，在前文中，提出了正交异性光弹性复合材料的动态应力－光性定律并证明了其在单轴应力状态下的正确性。本文旨在进一步考察在双轴应力状态下正交异性动态应力－光性定律的适用性，采用的方法是对纤维增强光弹性复合材料制作的平板模型施加冲击荷载，加载方向与材料纤维方向分别成０°、９０°及４５°角，同时进行正交异性动态光弹性实验和动态应变测量，另外，对该模型进行相应的各向异性介质时域边界元计算。把动态应变测量推算出的应力分量以及时域边界元计算出的应力分量分别代入正交异性动态应力－光性定律，得到随时间变化的双折射条纹级数历程，将其与正交异性动态光弹性实验的结果进行比较。实验及计算结果表明，在三个加载方向下，由这三种方法得到的双折射条纹级数历程均吻合良好，从而证明了前文提出的正交异性动态应力－光性定律在双轴应力状态下的正确性。     

沟槽对建筑物减震作用的动光弹研究

本文用动光弹方法实验研究了沟槽对爆炸地震波的衰减作用和对建筑物的保护作用分析表明:在模型实验条件下,当槽深大于20mm时,地震波的大部分能量被槽挡住,地震波对槽后的建筑物影响甚小,当槽深小于15mm时,槽与建筑物之间应力场较强,临界深度在15～20mm左右,这一深度大约是爆生瑞利波波峰深度的3～4倍。槽宽度对地震波衰减作用不大。     

吊车压轨器强度的实验测试

宽厚板厂房的行车轨道在行车运行时承受来自行车水平导向轮的水平推力，该水平推力可能导致压轨器破坏，为确保压轨器的安全设计，采用平面光弹性、三维光弹性进行实验测试，分析在最不利工况下，各种压轨器所承担的水平推力份额，压轨器的变形和应力分布，给出强度分析评估，确定系统中各个压轨器以及固定螺栓的关键部位的应力水平。     

Digital shifting photoelasticity with optical enlarged unwrapping technology for local stress measurement

In this paper, photoelasticity combined with phase shifting technology is used to obtain stress distribution within the stress concentration zone. Both the optical enlarged unwrapping technology and the combined path shear difference technology are provided for evaluating the local stress information. By means of a phase shifting photoelastic experiment of a diametric-compressed disc, the stress components surrounding the local loading zone are determined. The results show not only a good improvement compared with conventional photoelastic analysis but also a good agreement with theoretical data.     

Photoelastic stress pattern analysis using Fourier transform with carrier fringes: influence of quarter-wave plate error

The Fourier transform method, widely applied in photomechanics for the automated analysis of interferometric fringe patterns, has been recently extended to the photoelastic isochromatic fringe patterns analysis. Unfortunately, its use in photoelasticity involves some limitations that have not been completely highlighted in literature. This work deals with the influence of the quarter-wave plate tolerance on the evaluation of the retardation. Both theoretical and experimental analyses have shown that the quarter-wave plate error does not affect the retardation only if the principal stress directions in the model and in the carrier are aligned. In general, instead, the tolerance of the quarter-wave plates leads to an amplification of the retardation error due to the influence of the isoclinics with a subsequent restriction of the field in which the method can be applied. For instance, using common quarter-wave plates and tolerating a maximum retardation error of about 0.03 fringe order, than the Fourier transform method cannot be applied as a full-field technique but only in the model zones in which the misalignment between the principal stresses in the model and in the carrier is less than 15°.     

Photoelasticity in polycrystalline aggregates

A theory for the photoelastic behaviour of transparent polycrystalline aggregates consisting of randomly oriented anisotropic crystallites has been developed. Such an aggregate is isotropic but it becomes birefringent under the influence of a uniaxial load. The photoelastic constants of the aggregate are given by the components of the spatial average of the photoelastic tensor of the single crystal, and are worked out by assuming either the strain to be continuous (Voigt approximation) or the stress to be continuous (Reuss approximation). The components of the average photoelastic tensor are very different for these two limits. The elastic and the photoelastic constants of alkali halide aggregates have been evaluated for both the stress continuity and the strain continuity conditions. The maximum variation of the elastic constants in going from the Voigt to the Reuss condition is 50 per cent while the photoelastic birefringence can vary by as much as 300 per cent in alkali halides. In the case of KI and rubidium halides even the sign of the photoelastic birefringence is different for the two limits.     

Orientational birefringence of uniaxially compressed PMMA networks in the unswollen state

Swollen PMMA networks show significant deviations from the theory of rubber elasticity. The unusual mechanical, optical and swelling properties have been explained by the existence of associations, well known for PMMA solutions.Unswollen PMMA networks show stress optical properties which are very similar to the networks swollen in carbon tetrachloride which is known as a strong complexing solvent. This indicates that associations exist in the bulk material. Swelling in carbon tetrachloride does not change the content of associations, only the glass transition temperature is reduced.Increasing the amount of crosslinking agent proves that the stress optical coefficient depends on the crosslinking density. This is contrary to the theoretical predictions. An explanation given by the effect of short network chains is not satisfactory. However, the consideration of a crosslinking chain instead of a crosslinking point gives a sufficient explanation. An oriented crosslinking chain gives a positive contribution to the total optical anisotropy while a PMMA chain shows a change from negative values (hindered rotation) to positive values (free rotation).Part I in Colloid & Polym Sci 262:182 (1984)Deceased Sept. 4, 1984     

图像比色法测定有色溶液

根据溶液中有色物质颜色值与其质量浓度成正比的原理及数字图像红绿蓝色彩模式,通过采集样品溶液的图像信息,采用图像比色法对有色溶液进行定量分析。以蓝色硫酸铜溶液为研究对象,在实验箱内采集图像和建立统计回归模型。结果表明:方法测量误差为5%,线性范围为10.0~50.0g·L-1,相关系数大于0.990。     

热光弹性法在残余热应力场分析上的运用

本文用热光弹性法对金属构件因热疲劳裂纹扩展而引起的残余应力场进行分析,并针对具体实验采用实验中途调节参数的方法满足了相似准则,使结果具有良好的精度.