用动态光弹性法研究炮身膛线的脱落问题

本文利用动态光弹性法研究了炮膛膛线脱落的机理。用包含五条膛线的部分炮筒横截面或扇形平面模型,在六种不同的载荷状态下进行了实验。得到了不同载荷状态下,不同瞬时的等差线条纹图的系列照片,以及膛线根部不同瞬时的应力分布曲线。结果表明:当一条或相邻数条膛线顶端受到足够大的均布冲击载荷时,将在承载膛线两侧根部的应力极值点出现膛线脱落的起裂点,而形成八字形脱落;而对非均布的其它几种冲击载荷,膛线都不会出现八字形脱落。     

Phase shifting photoelasticity in white light

The availability of image acquisition systems has led to the development of digital photoelasticity both in monochromatic and white light. In particular white light has been used mainly with the following methods: Spectral Content Analysis, RGB photoelasticity and phase shifting photoelasticity. Phase shifting photoelasticity in the colour domain has been used effectively for the determination of the isoclinic parameter in order to reduce the influence of the isochromatic fringes. The method has been also proposed for the determination of the isochromatic fringe order. This paper concerns the general characteristics of phase shifting photoelasticity in the colour domain. Special attention is drawn towards the influence of spectral content of the light source, the spectral response of the colour camera filters, the dispersion of the birefringence and the error of quarter wave plates.     

模型外载与自重并存变动外载的光弹性分析法

提出一个变动模型外载，分析大模型在外载与自重共同作用时的尤弹性法。它与用离心力模拟自重试验的传统方法完全不同，只要在大模型上变动外载，就可以获得上述两种载荷共同作用下的应力分析结果。此法避免了用离心模型自重受模型尺寸限制等诸多因素影响的缺点，为自重不可的大型复杂空间工程结构模型试验应力分析提出了一条新的途径。文中给出了本方法的基本原理及其简要的实验验证和工程应用结果。     

用动光弹性法研究材料引入的分配层对应力波传播的影响

本文用动态光弹性模拟试验分析方法，观察和分析研究了材料不同的分配层对应力波在结构中传播的影响，比较分析了冲击荷载产生的应力波在洞室结构顶部的传播及相互过程，得到指定点处的应力—时间关系曲线，为结构震塌机理的进一步的研究和防护结构的改进提供参考。     

COUPLED VARIATIONAL PRINCIPLES AND GENERALIZED COUPLED VARIATIONAL PRINCIPLES IN PHOTOELASTICITY

ＦｕＢａｏｌｉａｎ（付宝连）（ＲｅｃｅｉｖｅｄＮｏｖ．２２，１９９３；ＣｏｍｍｕｎｉｃａｔｅｄｂｙＣｈｉｅｎＷｅｉｚａｎｇ）ＣＯＵＰＬＥＤＶＡＲＩＡＴＩＯＮＡＬＰＲＩＮＣＩＰＬＥＳＡＮＤＧＥＮＥＲＡＬＩＺＥＤＣＯＵＰＬＥＤＶＡＲＩＡＴＩＯＮＡＬＰＲＩ...     

An experimental study of impact-induced failure events in homogeneous layered materials using dynamic photoelasticity and high-speed photography

The generation and the subsequent evolution of dynamic failure events in homogeneous layered materials that occur within microseconds after impact were investigated experimentally. Tested configurations include three-layer and two-layer, bonded Homalite specimens featuring different bonding strengths. High-speed photography and dynamic photoelasticity were utilized to study the nature, sequence and interaction of failure modes. A series of complex failure modes was observed. In most cases, and at the early stages of the impact event, intra-layer failure (or bulk matrix failure) appeared in the form of cracks radiating from the impact point. These cracks were opening-dominated and their speeds were less than the crack branching speed of the Homalite. Subsequent crack branching in several forms was also observed. Mixed-mode inter-layer cracking (or interfacial debonding) was initiated when the intra-layer cracks approached the interface with a large incident angle. The dynamic interaction between inter-layer crack formation and intra-layer crack growth (or the so-called “Cook–Gordon Mechanism”) was visualized for the first time. Interfacial bonding played a significant role in impact damage spreading. Cracks arrested at weak bonds and the stress wave intensity was reduced dramatically by the use of a thin but ductile adhesive layer.     

工艺应力模拟技术中的热相似律

分析了热处理及焊接的热过程，从热传导的基本方程及边界条件出发，结合不同工艺过程的特点，提出了用光弹法模拟整体淬火热应力，表面淬火热应力和焊接过程热应力及残余应力的热相似律。     

拱形试件动态断裂的动光弹分析

本文采用动光弹方法,分析了对带边裂纹的拱形三点弯曲试件在抢击加载条件下的瞬态反应。从多火花动光弹仪记录下来的16幅断裂过程的照片和微机输出的电火花光信号图上,得到了各时刻的等差线图形和裂纹长度。使用运动裂纹尖端附近的应力场解,去计算动应力强度因子。对环氧树脂材料,测定了动态应力强度因子与裂纹扩展速度之间的关系,并给出了当裂纹扩展速度达到410m/s时,为裂纹产生分叉的条件。     

Near-Boundary Stress Wave Field in Anisotropic Plates under Impulsive Load

The stress wave field and the behavior of waves near the free boundary in an orthotropic plate and at the interface between two anisotropic media are studied. The results presented were obtained using the dynamic photoelastic method and optically sensitive fibrous models. Experimental data for impulsively loaded plates with various boundary conditions are analyzed     

吊车压轨器强度的实验测试

宽厚板厂房的行车轨道在行车运行时承受来自行车水平导向轮的水平推力，该水平推力可能导致压轨器破坏，为确保压轨器的安全设计，采用平面光弹性、三维光弹性进行实验测试，分析在最不利工况下，各种压轨器所承担的水平推力份额，压轨器的变形和应力分布，给出强度分析评估，确定系统中各个压轨器以及固定螺栓的关键部位的应力水平。