Design of an electron gun for terahertz radiation source

An EC-ITC(External-Cathode Independently Tunable Cells) RF gun was employed with the aim of obtaining short-pulse bunches with high peak current for a terahertz radiation source. A gridded DC gun plays a key role as the external injecting electron source of the ITC RF gun, the performance of which determines the beam quality in the injector and transport line. In order to make the beam well compressed in the ITC RF gun, the energy of the electrons acquired from the gridded DC gun should be 15 keV at most. A proper structure of the gridded gun with double-anode is shown to overcome the strong space- charge force on the cathode, which is able to generate 6 μs beam with 4.5 A current successfully.     

全三维35 GHz双阳极磁控注入式电子枪数值模拟研究

基于trade-off平衡方程组得到35GHz双阳极磁控注入式电子枪的初始参数,通过编程对其主要参数进行优化设计,并经由自主研发的PIC粒子模拟软件CHIPIC中的电子枪计算模块对其进行全三维的数值模拟研究,最终获得了具有横纵速度比为1.5,最大速度零散约为5.4%的高性能电子枪,能够很好地满足35GHz-100kW回旋振荡管对电子束的要求。     

X波段盘圈加速结构热阴极微波电子枪的研究

介绍了采用盘圈(DAW)加速结构在11.43GHz下研制的热阴极微波电子枪注入器，分析了注入器中DAW加速结构支撑杆对于微波特性的影响以及加速结构中的模式重叠问题. 针对该结构的强腔间耦合以及次临近耦合不能忽略的特点，对其调谐方法进行了分析研究.给出了该长腔链热阴极微波电子枪注入器的物理设计及粒子动力学计算结果，电子能量为5—6MeV，脉冲流强为40mA，电子束发射度为3.4πmm.mrad. 该微波电子枪的加工焊接已经完成，文中给出了其冷测结果.     

Cu/TiOx复合薄膜的电子态分析及其对亲水性的影响

在室温下,采用射频磁控溅射法制备了Cu/TiO_x纳米晶复合薄膜.利用X射线粉末衍射（XRD）、X射线光电子能谱（XPS）对其结构进行表征,并研究了Cu/TiO_x复合薄膜的UV-vis吸收谱和亲水性.结果表明,退火前后薄膜中钛元素皆以Ti³⁺形式存在.薄膜在可见区有吸收,吸收限为600 nm左右.Cu/TiO_x复合薄膜具有良好的亲水性.这主要是由于Cu的掺杂,使得薄膜的性能的亲水性变好. 关键词： x复合薄膜')" href="#">Cu/TiO_x复合薄膜 射频磁控溅射 XPS 亲水性     

Design study of a L-band photocathode RF injector

In the proposal of the Beijing Advanced Light Source, a compact combination of XERL and XFEL using a common SC linac is being considered. In the meantime, an ERL-FEL test facility is being proposed and will be used for THz radiation. In this test facility, a L-band photocathode RF injector is needed. In this paper, we give the physical design of the L-band photocathode RF injector for the test facility.     

Ultra-low emittance X-band photocathode RF gun

In this paper, we present the simulation results of a 1.6 cell X-band photocathode RF gun for ultra-low emittance electron beams. It will work at 9.3 GHz. The emittance, bunch length, electron energy and energy spread at the gun exit are optimized at bunch charge of 1pC using PARMELA. Electron bunches with emittance about 0.1 mm·mrad and bunch length less than 100 fs can be obtained from this gun. A PITZ type coupler is adopted in this gun and an initial simulation by MAFIA is also given in this paper.     

溅射气压对非晶Hg1-xCdx Te薄膜微观结构和化学组分的影响（英文）

采用射频磁控溅射制备了非晶态结构的Hg1-xCdxTe薄膜,并利用台阶仪、XRD、原子力显微镜、EDS等分析手段对薄膜生长速率、物相、表面形貌、组分比例进行了研究。实验结果表明,溅射气压对薄膜生长速率、微观结构、表面形貌和化学组分有直接影响。随着溅射气压增大,其生长速率逐渐降低。当溅射气压高于1.1 Pa时,薄膜XRD图谱上没有出现任何特征衍射峰,只是在2θ=23°附近出现衍射波包,具有明显的非晶态特征;当溅射气压小于1.1 Pa时,XRD谱表现为多晶结构。另外,随着溅射气压的增加,薄膜表面粗糙度逐渐减小,而且溅射气压对薄膜组成的化学计量比有明显影响,当溅射气压为1.1 Pa时,薄膜中Hg的组分比最低,而Cd组分比最高。     

Error and jitter effect studies on the SLED for the BEPC Ⅱ-linac

An RF pulse compressor is a device used to convert a long RF pulse to a short one with a much higher peak RF magnitude. SLED can be regarded as the earliest RF pulse compressor to be used in large-scale linear accelerators. It has been widely studied around the world and applied in the BEPC and BEPC linac for many years. During routine operation, error and jitter effects will deteriorate the performance of SLED, either on the output electromagnetic wave amplitude or phase. The error effects mainly include the frequency drift induced by cooling water temperature variation and the frequency/Q 0 /β unbalances between the two energy storage cavities caused by mechanical fabrication or microwave tuning. The jitter effects refer to the PSK switching phase and time jitters. In this paper, we re-derive the generalized formulae for the conventional SLED used in the BEPC linac, and the error and jitter effects on SLED performance are also investigated.     

导电玻璃上室温沉积钛膜及TiO2纳米管阵列的制备与表征

在掺氟的杂nO2(FTO)导电玻璃衬底上采用射频磁控溅射的方法室温沉积纯Ti薄膜, 以NH4F/甘油为电解液, 经电化学阳极氧化得到结构有序、微米级的TiO2纳米管阵列/FTO复合结构, 并通过场发射扫描电子显微镜(FESEM)、X射线衍射(XRD)以及光电化学的方法对纳米管阵列进行了表征. 研究表明, 在氩气气压为0.5 Pa, 功率为150 W, 时间为0.5 h条件下在导电玻璃上室温沉积获得钛膜的结构为晶带T型组织, 表面均匀性好且致密度较高; 在电压为30 V下, 随着阳极氧化时间从1 h延长至3 h, 纳米管的管径从50 nm增加到75 nm, 纳米管的长度从750 nm增至1100 nm后减至800 nm, 管壁由平滑变为波纹状; 随氧化电压的升高, 纳米管管径逐渐增大, 而表面覆盖物逐渐减少, 可通过在稀的HF溶液(0.05%(w, 质量分数))中超声清洗去除; 此外, 瞬态光电流测试表明结晶的电极表现出更好的光电转换性能, 紫外光照射下能促进TiO2光生载流子有效分离, 在热处理温度为450 ℃时, 具有较高的光电化学性能.     

In silico prediction and screening of γ‐secretase inhibitors by molecular descriptors and machine learning methods

γ‐Secretase inhibitors have been explored for the prevention and treatment of Alzheimer's disease (AD). Methods for prediction and screening of γ‐secretase inhibitors are highly desired for facilitating the design of novel therapeutic agents against AD, especially when incomplete knowledge about the mechanism and three‐dimensional structure of γ‐secretase. We explored two machine learning methods, support vector machine (SVM) and random forest (RF), to develop models for predicting γ‐secretase inhibitors of diverse structures. Quantitative analysis of the receiver operating characteristic (ROC) curve was performed to further examine and optimize the models. Especially, the Youden index (YI) was initially introduced into the ROC curve of RF so as to obtain an optimal threshold of probability for prediction. The developed models were validated by an external testing set with the prediction accuracies of SVM and RF 96.48 and 98.83% for γ‐secretase inhibitors and 98.18 and 99.27% for noninhibitors, respectively. The different feature selection methods were used to extract the physicochemical features most relevant to γ‐secretase inhibition. To the best of our knowledge, the RF model developed in this work is the first model with a broad applicability domain, based on which the virtual screening of γ‐secretase inhibitors against the ZINC database was performed, resulting in 368 potential hit candidates. © 2009 Wiley Periodicals, Inc. J Comput Chem, 2010