FTS-20E富里叶红外光谱仪数据系统改造

报道了ＦＴＳ－２０Ｆ富里叶红外光谱仪数据系统改造的工作采用ＩＢＭ４８６计算机及新的数据接口取代了陈旧的ＮＯＶＡ４数据系统，文章详细描述了其硬件设计和软件编辑，改造不仅更新了ＦＴＳ－２０Ｅ里叶红外光谱仪，而且还使其达到９０年代的水平。     

Thermal Stability Of Folic Acid in the solid-state

This study attempts to identify the degradative process which folic acid undergoes in the solid-state under thermal stress. In order to facilitate the process, the various pieces of the chemical structure, namely, p-amino benzoic acid, pterin and glutamic acid as both its d- and l-isomers were investigated as separate entities. These structured solid-state pieces were then compared to the composite solid state folic acid degradative curves in order to identify the peaks seen and provide direction for the interpolation of the degradative mechanism. It was observed that none of the structural pieces could be superimposed as assumed earlier and hence an attempt was made to identify the decomposition products using various analytical techniques such as infrared spectroscopy, mass spectroscopy and X-ray diffraction which suggested that the glutamic acid fragment is lost first as evidenced by acid loss and amide enhancement in the IR spectra. The vitamin was ultimately degrading to carbon fragments and that further identification was not necessary. This revised version was published online in August 2006 with corrections to the Cover Date.     

傅立叶变换红外光谱对灰指甲组织结构的研究

对健康指甲和灰指甲的红外光谱特征吸收峰进行了指认,并对其相应官能团的吸收峰进行了对比分析.结果表明,灰指甲增厚、变脆的原因系α-角蛋白螺旋结构遭到破坏,肽链伸展并发生断裂,形成了不同化学环境的氨基酸,同时蛋白质分子的有序排列也发生了改变.     

原位漫反射红外光谱研究氮氧化物在Ag-ZSM-5催化剂上的吸附态及选择性催化还原反应机理

利用原位分析方法对催化剂表面吸附态进行动态表征，对了解催化反应机理具有重要的意义。漫反射红外光谱是一种理想的原位方法，应用该方法在298－773K范围原位考察了以丙烯为还原剂，NO在Ag-ZSM-5催化剂上的吸附态及选择性催化还原过程。认为NO的选择性催化还原符合直接作用机理，还原的关键是形成有机－氮氧化物（R－NO2或R－ONO）中间体。O2的作用是使C3H6充分活化，并是有效产生有机－氮氧化物不可缺少的条件。     

XPS,AFM, ATR and TPD evidence for terraced,dihydrogen terminated, 1×1 (100) silicon

Heating (100) silicon at high temperature (say, higher than 850 °C) in H₂, cooling to 670–700 °C in the same ambient, and quenching to room temperature in N₂ results in environmentally robust, terraced 1 × 1 (100) SiH₂. Evidence for this conclusion is based on angle‐resolved x‐ray photoelectron spectroscopy, atomic force microscopy, infrared absorption spectroscopy in the attenuated total reflection mode, thermal programmed desorption, and reflection high‐energy electron diffraction. Copyright © 2005 John Wiley & Sons, Ltd.     

脱蜡剂DF-1的气相色谱-傅里叶变换红外光谱联用分析

脱蜡剂ＤＦ－１是一种含多种有机成分的碳氢化合物，经气相色谱－红外光谱联用分析后，确定了这些组分的组成与含量。     

Thermal decomposition and indirect structural determination of rare earth element picrates with the dtso ligand

The complexes [Ln(pic)₃(DTSO)₃] (Ln=La, Lu and Y; pic=picrate; DTSO=1,3-dithiane-1-oxide) were synthesized and characterized. Indirect structural determination by far infrared spectroscopy is presented. Results from thermal decomposition of these complexes by TG/DTG and DSC techniques are reported. This revised version was published online in August 2006 with corrections to the Cover Date.     

Thermal decomposition of struvite

Struvite (NH₄MgPO₄·6H₂O) is a mineral often found in urinary tracts and kidneys. Thermal decomposition using slow low heating shows that the 'kidney' stone can be decomposed at temperatures below 40°C. At this temperature both ammonia and water are evolved. If more rapid heating is employed the decomposition occurs at around 80°C. The implication of this work rests with the use of low slow heat for the decomposition of the kidney stones. This revised version was published online in July 2006 with corrections to the Cover Date.     

钙钛矿型CaSiO_3解压缩和重压缩过程的分子动力学模拟

用分子动力学模拟方法 (MD)研究了 3 0 0K时钙钛矿型CaSiO3 ,从高压到负压的解压缩过程 .MD模拟获得的P V关系与实验数据相近 ,与已报道的MD模拟数据基本一致 ,所得体积模量也在实验数据分布范围内 .减压缩和重压缩的MD模拟数据与实验结果相似 .钙钛矿型CaSiO3 解压缩成非晶态时 ,存在两个结构破坏阶段 :破坏硅氧八面体和破坏钙氧二十面体 .当钙氧二十面体被破坏后 ,重压缩不能得到钙钛矿型结构 .只要钙氧二十面体未被破坏 ,重压缩可恢复钙钛矿型结构 .本研究得到的结果尚未见相关报道 .由MD模拟数据计算了CaSiO3 系统的红外光谱 ,分析这些数据可知钙钛矿型CaSiO3 解压缩非晶化是一个二阶软模相变 .研究表明钙钛矿型CaSiO3 结构存在一个等容的亚稳极限 ,其解压缩非晶化是一个受动力学控制的亚稳状态 .     

Nanoporous TiO2 Coatings for Infrared Detectors

In GaAs based infrared detectors, a considerable part of the incident light will be reflected at the surface, thus it decreases the detectors sensitivity considerably. In this paper, a TiO₂ nanoporous coating was prepared successfully on the GaAs substrate by sol-gel method. The optical parameters of the coating were also controlled successfully. It was proved that the coating could greatly improve the transmittance of the incident light, which agrees with the theoretical results quite well. In the 2.5–6.0 m waveband, the maximum transmittance of GaAs substrate is 56%, while the transmittance of the GaAs substrate coated with a nanostructured TiO₂ coating is about 94%.