A rapid and sensitive reversed phase‐HPLC method for simultaneous determination of ibuprofen and paracetamol in drug samples and their behaviors in simulated gastric conditions

Paracetamol is a widely used drug for fever and pain relief. Ibuprofen is a common nonsteroidal anti‐inflammatory drug. In this study, a sensitive and accurate reversed phase high performance liquid chromatography method was developed for the simultaneous determination of ibuprofen and paracetamol. The chromatographic separation was achieved on a Phenomenex C18 (250 mm, 4.6 mm, 5 μm) column. Fifty milli molar phosphate buffer (pH 7.5) and methanol were used as mobile phase in a gradient elution mode. The retention times of paracetamol and ibuprofen were 5.7 and 10.4 min, respectively. The linearity of the developed method was established in the range of 0.25 – 250 mg/L with a correlation coefficient of 0.9998 for both analytes. The limit of detection/quantification values were found to be 0.06/0.19 and 0.08/0.26 mg/L for ibuprofen and paracetamol, respectively. The method was successfully applied in drug samples in the form of tablets and suspensions. The calculated concentrations matched with the claimed values on their prospectuses. The drug samples were studied under simulated gastric conditions to determine the behaviors of the analytes in the human body. The obtained results showed no change in the retention time of the analyte peak shapes throughout the 210 minutes.     

Effect of pure phase decoherence on entanglement teleportation

We study entanglement teleportation in the two‐qubit XX Heisenberg model with pure phase decoherence taken into account. For some initial entangled states, pure phase decoherence has no effect on the teleported entanglement, while for others pure phase decoherence has a pronounced effect. In addition, entanglement sudden death happens in the latter case.     

Design consideration and modelling studies of ultrasound and ultraviolet combined approach for shelf-life enhancement of pine apple juice

Although both ultraviolet (UV) radiation and ultrasound (US) treatment have their capabilities in microbial inactivation, applying any one method alone may require a high dose for complete inactivation, which may affect the sensory and nutritional properties of pineapple juice. Hence, this study was intended to analyse and optimise the effect of combined US and UV treatments on microbial inactivation without affecting the selected quality parameters of pineapple juice. US treatment (33 kHz) was done at three different time intervals, viz. 10 min, 20 min and 30 min., after which, juice samples were subjected to UV treatment for 10 min at three UV dosage levels, viz. 1 J/cm², 1.3 J/cm², and 1.6 J/cm². The samples were evaluated for total colour difference, pH, total soluble solids (TSS), titrable acidity (TA), and ascorbic acid content; total bacterial count and total yeast count; and the standardization of process parameters was done using Response Surface Methodology and Artificial Neural Network. The results showed that the individual, as well as combined treatments, did not significantly impact the physicochemical properties while retaining the quality characteristics. It was observed that combined treatment resulted in 5 log cycle reduction in bacterial and yeast populations while the individual treatment failed. From the optimization studies, it was found that combined US and UV treatments with 22.95 min and1.577 J/cm² ensured a microbiologically safe product while retaining organoleptic quality close to that of fresh juice.     

Preparation and characterization of a novel DABCO-based ionic liquid supported on Fe3O4@TiO2 nanoparticles and investigation of its catalytic activity in the synthesis of quinazolinones

In this study, quinazolinone derivatives have been synthesized via a suitable and efficient procedure by one-potmulti-component reactions of 3-amino-1,2,4-triazole or 2-aminobenzimidazole, dimedone and aromatic aldehydes in the presence of Fe₃O₄@TiO₂-IL as nanocatalyst under solvent-free condition. The products were prepared in good to excellent yields using Fe₃O₄@TiO₂-IL magnetic nanocatalyst. The Fe₃O₄@TiO₂ magnetic nanoparticles (MNPs) were prepared using beet juice extract and functionalized with IL based on DABCO. Moreover, the core-shell structured magnetic Fe₃O₄@TiO₂-IL has been characterized by different techniques such as ¹H-NMR, FT-IR, VSM, XRD, SEM, TGA, TEM and EDX. To the best of our knowledge, the prepared ionic liquid displayed a good protective and activator agent for magnetic nanocatalyst.     

Characterization of Different Salt Forms of Chitooligosaccharides and Their Effects on Nitric Oxide Secretion by Macrophages

In this paper, chitooligosaccharides in different salt forms, such as chitooligosaccharide lactate, citrate, adipate, etc., were prepared by the microwave method. They were characterized by SEM, FTIR, NMR, etc., and the nitric oxide (NO) expression was determined in RAW 264.7 cells. The results showed that pure chitooligosaccharide was an irregular spherical shape with rough surface, and its different salt type products are amorphous solid with different honeycomb sizes. In addition to the characteristic absorption peaks of chitooligosaccharides, in FTIR, the characteristic absorption of carboxyl group, methylene group, and aromatic group in corresponding acid appeared. The characteristic absorption peaks of carbon in carboxyl group, hydrogen and carbon in methyl, methylene group, and aromatic group in corresponding acid also appeared in NMR. Therefore, the sugar ring structure and linking mode of chitooligosaccharides did not change after salt formation of chitooligosaccharides. Different salt chitooligosaccharides are completely different in promoting NO secretion by macrophages, and pure chitooligosaccharides are the best.     

Bouncing and Coalescence of Bubble Pairs Rising at High Reynolds Number in Pure Water or Aqueous Surfactant Solutions

The encounter of bubble pairs of O(1 mm) in both pure water and aqueous surfactant solutions was studied experimentally. In pure water, two equally sized bubbles were found to coalesce if the Weber number, W = V² R/, based on the velocity of approach, V, was below a critical value, W_cr = 0.18, where and are the density and surface tension of the liquid respectively and R the equivalent radius of the bubbles. After coalescence bubbles perform volume and shape oscillations.When W_cr is exceeded, bubbles bounce. After bouncing, bubbles can either coalesce or separate without coalescing. This was found to depend on the Weber number, based on the rise velocity U, We = U² R/. If this number was below a critical value, bubbles coalesced after bouncing. The relative motion of the bubbles was found to be damped out by acoustic damping due to surface oscillations rather then by viscosity.If We was above a critical value, which was close to that for path instability of a single bubble (We = 3.3), the bubbles separated after bouncing. This is probably caused by shedding of vortices which dominate the relative motion of the bubbles. This mechanism may cause bubbles in bubbly flows not aggregating in horizontal planes, as was found in calculations based on potential flow theory. For modelling bubbly flows it will therefore be essential to incorporate the influence of vorticity.When surfactants are added to the water it was found that bubbles are prevented to coalesce above a critical concentration, which is nearly identical to that of single rising bubbles. Above this critical concentration, bubbles behave as rigid spheres and trajectories cannot be predicted by potential flow theory.     

Turbidity of pulpy fruit juice: A key factor for predicting cross-flow microfiltration performance

To determine the technical and economic feasibility of cross-flow microfiltration on an industrial scale, the expected decline of permeation flux must be predicted taking into account the variability of juice's fouling potential. However, the main difficulty is finding representative parameters. Two semi-empirical models – gel polarisation and mechanistic – were used to fit experimental permeation flows using initial juice turbidity as surrogate for the volumetric concentration of particles in the feed juice. The experimental data of different banana, pineapple, and blackberry juices fitted well in both models. Although the mechanistic model more accurately estimated the permeation flux density, for practical application, the simpler polarisation model was preferred. Because this method uses a factor (i.e. turbidity) that reflects juice's fouling potential, it allows the optimisation of processing parameters and the prediction of permeation flux range in real industrial conditions.     

Critical comparison of radiometric and mass spectrometric methods for the determination of radionuclides in environmental, biological and nuclear waste samples

The radiometric methods, alpha (α)-, beta (β)-, gamma (γ)-spectrometry, and mass spectrometric methods, inductively coupled plasma mass spectrometry, accelerator mass spectrometry, thermal ionization mass spectrometry, resonance ionization mass spectrometry, secondary ion mass spectrometry, and glow discharge mass spectrometry are reviewed for the determination of radionuclides. These methods are critically compared for the determination of long-lived radionuclides important for radiation protection, decommissioning of nuclear facilities, repository of nuclear waste, tracer application in the environmental and biological researches, these radionuclides include ³H, ¹⁴C, ³⁶Cl, ⁴¹Ca, ^59,63Ni, ^89,90Sr, ⁹⁹Tc, ¹²⁹I, ^135,137Cs, ²¹⁰Pb, ^226,228Ra, ²³⁷Np, ²⁴¹Am, and isotopes of thorium, uranium and plutonium. The application of on-line methods (flow injection/sequential injection) for separation of radionuclides and automated determination of radionuclides is also discussed.     

Highly improved electrocatalytic behavior of sulfite at carbon ionic liquid electrode: application to the analysis of some real samples

The electrocatalytic oxidation of sulfite was investigated at carbon ionic liquid electrode (CILE). This electrode is a very good alternative to previously described electrodes because the electrocatalytic effect is achieved without any electrode modification. Comparative experiments were carried out using carbon paste electrode (CPE) and glassy carbon electrode (GCE). At CILE, highly reproducible and well-defined cyclic voltammograms were obtained for sulfite with a peak potential of 0.55 V vs. Ag/AgCl. Sulfite oxidation at CILE does not result in deactivation of the electrode surface. The kinetic parameters for this irreversible heterogeneous electron transfer process were determined. Under optimal experimental conditions, the peak current response increased linearly with sulfite concentration over the range of 6-1000 μM. The detection limit of the method was 4 μM. The method was applied to the determination of sulfite in mineral water, grape juice and non-alcoholic beer samples.     

高压熔渗生长法制备金刚石聚晶中碳的转化机制研究

在6 GPa和1500 ℃的压力和温度范围内, 利用高压熔渗生长法制备了纯金刚石聚晶, 深入研究了高温高压下金刚石聚晶生长过程中碳的转化机制. 利用光学显微镜、X-射线衍射、场发射扫描电子显微镜检测, 发现在熔渗过程中金刚石层出现了石墨化现象, 在烧结过程中金刚石颗粒表面形貌发生了变化. 根据实验现象分析, 在制备过程中存在三种碳的转化机制: 1)金属熔渗阶段金刚石颗粒表面石墨化产生石墨; 2)产生的石墨在烧结阶段很快转变为填充空隙的金刚石碳; 3)金刚石直接溶解在金属溶液中, 以金刚石形式在颗粒间析出, 填充空隙. 本文研究碳的转化机制为在高温高压金属溶剂法合成金刚石的条件下(6 GPa和1500 ℃的压力和温度范围内)工业批量化制备无添加剂、无空隙的纯金刚石聚晶提供了重要的理论指导.