The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.     

密度矩阵重正化群的异构并行优化

密度矩阵重正化群方法（DMRG）在求解一维强关联格点模型的基态时可以获得较高的精度，在应用于二维或准二维问题时，要达到类似的精度通常需要较大的计算量与存储空间.本文提出一种新的DMRG异构并行策略，可以同时发挥计算机中央处理器（CPU）和图形处理器（GPU）的计算性能.针对最耗时的哈密顿量对角化部分，实现了数据的分布式存储，并且给出了CPU和GPU之间的负载平衡策略.以费米Hubbard模型为例，测试了异构并行程序在不同DMRG保留状态数下的运行表现，并给出了相应的性能基准.应用于4腿梯子时，观测到了高温超导中常见的电荷密度条纹，此时保留状态数达到10⁴，使用的GPU显存小于12 GB.     

磁性纳米结构中由激光引起的超快自旋动力学研究

以单个磁性中心的NiO以及由Co和Ni等元素构成的双磁性中心的纳米结构为例,总结了近年所做的主要工作.为了在理论上实现磁性纳米结构中的超快自旋翻转和转移,提出了一种称为Λ进程(Λ process)的超快自旋转换机理.在实际计算中,首先采用量子化学第一性原理计算得到磁性纳米结构中精确的隙间d电子态,然后考虑外加磁场和自旋轨道耦合分析磁性原子中的自旋局域化程度,最后引入激光脉冲项,研究在其作用下材料的自旋态经由Λ进程实现转换的时间历程.研究结果表明自旋翻转和转移可以在线偏振光的作用下在亚皮秒的时间尺度内完成. 关键词： 超快自旋动力学 第一性原理计算 Λ进程 磁性纳米结构     

MgB2薄膜的制备与特殊性质

本文报道了利用混合物理化学气相沉积方法(HPCVD)在SiC衬底上制备出约150 nm厚,结构均匀的MgB2薄膜.由R~T曲线知道样品TC(0)高达40.1K.由M~T曲线知道其TC=40.4K,且曲线转变十分陡峭.X射线衍射分析表明薄膜具有较好的C轴取向,没有氧污染,却存在Mg的杂峰.由M~H曲线,利用毕恩模型计算得到了5 K零场条件下JC(0T,5K)=2.7×106A/cm2,Hc2=19.5 T.这些结果表明过量的Mg对MgB2薄膜的转变温度以及有些性质有较大的影响.     

微乳液法SiO2/罗丹明B荧光杂化纳米微球的制备与表征

在甲苯存在下的反相微乳液体系中,将γ-缩水甘油醚氧丙基三甲氧基硅烷(KH560)与罗丹明B进行预反应;再与正硅酸乙酯( TEOS)经原位溶胶-凝胶反应,制备SiO2/罗丹明B荧光杂化纳米微球.通过FTIR、UV-Vis、TEM、TG和光致发光谱对杂化纳米微球进行了表征.结果表明:罗丹明B与KH560间通过酯基形成化学键...     

NIR-luminescence from ternary lanthanide [Ho, Pr and Tm] complexes with 1-(2-naphthyl)-4,4,4-trifluoro-1,3-butanedionate

The ligand 1-(2-naphthyl)-4,4,4-trifluoro-1,3-butanedionate (Htfnd) has been employed to synthesize six novel ternary-lanthanide complexes in which the synergic ligands were 1,10-phenanthroline-5,6-dione (dione) and 4,5-diazafluoren-9-one (dafone), respectively. Two series of complexes Ln(tfnd)₃dione and Ln(tfnd)₃dafone (Ln=Ho, Pr, Tm) were obtained. These complexes were characterized by elemental analysis, Fourier Transform Infrared spectra and diffused reflectance. After ligand-mediated excitation, Ln(tfnd)₃dione and Ln(tfnd)₃dafone all show the characteristic NIR luminescence of the corresponding Ln³⁺ ions (Ln=Ho, Pr, Tm). This can be attributed to the efficient energy transfer from ligands to central Ln³⁺ ions, via an antenna effect. The indirect energy transfer in the complexes has been investigated and the differences in the luminescence intensity between Ln(tfnd)₃dione and Ln(tfnd)₃dafone were discussed in detail. The excellent luminescent performances enable these NIR-luminescent complexes to have potential applications in optical amplification operating at 1300 or 1500 nm.     

Electron cyclotron resonance heating in a short cylindrical plasma system

Electron cyclotron resonance (ECR) plasma is produced and studied in a small cylindrical system. Microwave power is delivered by a CW magnetron at 2.45 GHz in TE¹⁰ mode and launched radially to have extraordinary (X) wave in plasma. The axial magnetic field required for ECR in the system is such that the first two ECR surfaces (B = 875.0 G andB = 437.5 G) reside in the system. ECR plasma is produced with hydrogen with typical plasma density n^e as 3.2 × 10¹⁰ cm^-3 and plasma temperature T^e between 9 and 15 eV. Various cut-off and resonance positions are identified in the plasma system. ECR heating (ECRH) of the plasma is observed experimentally. This heating is because of the mode conversion of X-wave to electron Bernstein wave (EBW) at the upper hybrid resonance (UHR) layer. The power mode conversion efficiency is estimated to be 0.85 for this system. The experimental results are presented in this paper.     

BILED／BILD组合回路的光学逻辑运算

利用激光二极管或发光二极管混合双稳态回路(BILD/BILED)的组合,得到了光学多稳态,光学异或逻辑门和光学R-S触发器.这种光电子学的逻辑回路与大规模集成技术完全相容,因此有希望应用于光学信息处理,光通信和光计算.     

CaTiO3:Pr3+长余辉玻璃的制备与发光性能

用二次熔融法制备了CaTiO3：Pr^3＋红色长余辉玻璃。测量了样品的发射光谱,其发射光谱峰值为611．7,614．5nm,对应于Pr^3＋的4f-4f（^1D2→^3H4）跃迁,与CaTiO3：Pr^3＋晶态长余辉发光粉的发射光谱峰值相一致。玻璃粉与发光粉的质量配比在95：5～80：20时,都可以形成玻璃态并得到红色长余辉发光。研究了气氛和熔融温度对发光性能的影响,在空气环境下,800℃即可得到性能良好的样品。     

有机-无机复合ZrO2-SiO2平面光波导

采用溶胶-凝胶法合成ZrO2-SiO2有机一无机复合光波导材料,通过改变其中ZrO2的含量来调节材料的折射率,使材料分别适用于平面光波导的导光层(ng≈1．497)和衬底层、包层(mb=nc≈1．479)。采用旋转涂膜工艺和相应的热处理,在单晶硅基片上制备衬底层、导光层和包层等薄膜,其中导光层介质因具有感光性而可通过紫外光刻来制备光路图案。所得有机一无机复合ZrO2-SiO2板型平面光波导(衬底层 导光层),用棱镜耦合截断法测试其光损耗在632．8nm波长处约为0．8dB／cm。对板型平面波导的导光层薄膜进行紫外光刻和异丙醇淋洗,制备出脊状光波导通道,在覆盖包层后,即获得埋层沟道式平面光波导。采用端耦合截断法测试了埋层沟道式平面光波导的光损耗(小于0．1dB／cm),并观察了其近场图像以及导光材料在近红外窗口的吸收光谱。