孤子掺杂光纤放大的半径典模型与分析

建立了孤子掺杂光纤放大的半经典模型，给出了分布放大透明传输的泵浦条件，详细讨论了激发态吸收的影响．文中结果为Ｅｒ￣３＋掺杂光纤孤子放大器的设计提供了重要理论依据．     

Noncollinear optical parametric amplification in lithium triborate seeded by a cw Ti:sapphire laser

Experimental investigations of a type-I noncollinear phase-matched optical parametric amplification based on lithium triborate, which was pumped by a 5-ns second-harmonic pulses from a Q-switched Nd:YAG, seeded by a cw Ti:sapphire laser at 800 nm, was presented. The experiments generated 2-ns signal output pulses at 800 nm, the maximum signal output pulse energy reached 19 μJ, the corresponding parametric gain was 44 dB. Furthermore, the experiments demonstrate that the 65 nm-FWHM parametric fluorescence gain spectrum could also be observed. A quantitative account of the ultrabroadband parametric fluorescence gain spectrum was given with our theory. The experimental measurements are in agreement with theoretical calculations.     

Nonlinear rheological behavior of silica filled solution‐polymerized styrene butadiene rubber

The reinforcement and nonlinear viscoelastic behavior have been investigated for silica (SiO₂) filled solution‐polymerized styrene butadiene rubber (SSBR). Experimental results reveal that the nonlinear viscoelastic behavior of the filled rubber is similar to that of unfilled SSBR, which is inconsistent with the general concept that this characteristic comes from the breakdown and reformation of the filler network. It is interesting that the curves of either dynamic storage modulus (G′) or loss tangent (tan δ) versus strain amplitude (γ) for the filled rubber can be superposed, respectively, on those for the unfilled one, suggesting that the primary mechanism for the Payne effect is mainly involved in the nature of the entanglement network in rubbery matrix. It is believed there exists a cooperation between the breakdown and reformation of the filler network and the molecular disentanglement, resulting in enhancing the Payne effect and improving the mechanical hysteresis at high strain amplitudes. Moreover, the vertical and the horizontal shift factors for constructing the master curves could be well understood on the basis of the reinforcement factor f(φ) and the strain amplification factor A(φ), respectively. The surface modification of SiO₂ causes a decrease in f(φ), which is ascribed to weakeness of the filler–filler interaction and improvement of the filler dispersion. However, the surface nature of SiO₂ hardly affects A(φ). © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2594‐2602, 2007     

On-chip potential gradient detection with a portable capillary electrophoresis system

A portable chip-CE system with potential gradient detection (PGD) was developed and applied to the determinations of alkali metals and alkaloids. The separation efficiency appeared to be satisfactory and nonaqueous capillary electrophoresis (NACE) proved to be applicable to PGD or conductivity detection. The power supplies, separation and detection were built on a device of 3 kg in weight. A branch channel near the end of the separation channel was designed to perform PGD and make the application of relatively high field strength possible. The study is the first report on the application of PGD on the microchip platform. The design of the chip-CE system shows several advantages, such as simplicity, miniaturization and wide applicability.     

毛细管电泳中样品在线预富集方法

本文对高效毛细管电泳中样品在线预富集方法作了评述，包括瞬间等速电泳，反流速电泳，场放大进样，场放大排除基体和固相萃取等技术，引用文献81篇。     

Chiral amplification in macromolecular helicity assisted by noncovalent interaction with achiral amines and memory of the helical chirality

Poly[(4-carboxyphenyl)acetylene] (poly-1) exhibits an intense induced circular dichroism (ICD) in the UV-visible region upon complexation with excess (R)-1-(1-naphthyl)ethylamine ((R)-2), owing to the formation of a predominantly single-handed helical conformation of the polymer backbone. In the presence of a small amount of (R)-2, poly-1 showed a very weak ICD due to the lack of a single-handed helical conformation. However, we have found that the co-addition of the excess bulky, achiral 1-naphthylmethylamine (5) with a small amount of (R)-2 caused a dramatic increase in the ICD magnitude, comparable to the full ICD induced by excess (R)-2. This indicates that an almost single-handed helix can be induced on poly-1 upon complexation with a small amount of (R)-2 assisted by achiral 5. Furthermore, the induced single-handed helical poly-1 could be successfully memorized by the replacement of (R)-2 and 5 with achiral 2-aminoethanol or n-butylamine.     

便携式微波等离子体离子化检测器气相色谱仪用于气体分析的研究

本文使用自制的便携式微波诱导等离子体离子化检测器气相色谱仪对可燃气体中N_2、O_2、H_2和CH_4的测定方法进行了研究。以氩气为载气和工作气体,考察了改进后的微波诱导等离子体离子化检洲器(MIPID)的工作参数对测定的影响。对煤气和乙炔中的O_2、N_2、H_2和CH_4进行了测定,分析结果与热导池检测器(TCD)的气相色谱法一致。讨论了高电离电位(>11.7ev)气体组分在MIPID中响应特性。     

Shot noise sets the limit of quantification in electrochemical measurements

Detection of single molecules, particles, and rapid redox events is a challenge of electrochemical investigations and requires either an amplification strategy or significant averaging for the electrochemical current to exceed the noise level. We consider the minimum number of electrons required to reach the limit of quantification in these electrochemical measurements. A survey of the literature indicates that the state-of-the-art limit in current detection for different types of measurements (e.g. voltammetry, single-molecule redox cycling, ion channel recordings of single molecules, metal nanoparticle collision, and phase nucleation) is independent of the nature of the measurement and increases linearly with reciprocal response time, Δt^?1, over ～5 orders of magnitude (from ～10 to ～10⁶ s^?1). We demonstrate that the practical limit of quantification requires cumulative measurement of ～2100 electrons during Δt and is determined by statistics of counting electrons, that is, the shot noise in the current.     

聚丙烯表面的生物相容性修饰: 表面氨基放大还原胺化接枝磷酰胆碱

在氨气氛中对聚丙烯薄膜表面进行等离子处理, 获得了不同浓度的表面氨基. 表面氨基的数量经1,6-己二异氰酸酯键合三(2-氨乙基)胺可成倍增加. 用还原胺化法将磷酰胆碱醛共价接枝到表面氨基上获得了磷酰胆碱改性的聚丙烯薄膜. X射线光电子能谱(XPS)测定结果表明, 接枝磷酰胆碱基团的表面覆盖率可达20%～40%. 衰减全反射傅立叶变换红外(ATR-FTIR)和动态接触角测定结果也都说明磷酸胆碱基团被成功地接枝于聚丙烯表面. 还原胺化法结合等离子处理及表面氨基放大技术, 有望成为获取新型生物材料的一种有效途径.     

Automatic analysis of multiplex ligation-dependent probe amplification products (exemplified by a commercial kit for prenatal aneuploidy detection)

For use in routine prenatal diagnostics, we developed software and methods for automatic aneuploidy detection based on a commercial multiplex ligation-dependent probe amplification (MLPA) kit. Software and methods ensure a reliable, objective, and fast workflow, and may be applied to other types of MLPA kits. Following CE of MLPA amplification products, the software automatically identified the peak area for each probe, normalized it in relation to the neighboring peak areas of the test sample, computed the ratio relative to a reference created from normal samples, and compensated the ratio for a side effect of the normalization procedure that scaled all chromosomally normal DNA peak areas slightly up or down depending on the kind of aneuploidy present. For the chromosomes 13, 18, 21, X, and Y, probe reliability weighted mean ratio values and corresponding SDs were calculated, and the significance for being outside a reference interval around ratio 1.0 was tested. p < or = 1% suggested aneuploidy and 1 < p < or = 5% suggested potential aneuploidy. Individual peaks, where the normalized area was situated more than 4 SD from the corresponding reference, suggested possible partial deletion or gain. Sample quality was automatically assessed. Control probes were not required. Having used the software and methods for two years, we conclude that a reliable, objective, and fast workflow is obtained.