Degradation of 4-Chlorophenol using a Gas–Liquid Gliding Arc Discharge Plasma Reactor

The gas–liquid gliding arc discharge plasma is used directly to study degradation and dechlorination of 4-Chlorophenol (4-CP) in solution. The typical AC waveforms of discharge voltage and current revealed that the discharge behavior was not definitely periodic. The chemical oxygen demand (COD) abatement of 4-CP solution with stainless steel electrode is higher than that with aluminum or brass electrode; When air was used as carrier gas the COD abated from 1,679.2 to 190 mg/L (i.e., 88.68% abatement) after 76 min plasma treatment; Increasing gas–liquid mixing rate could also increase the degradation of 4-CP; adding appropriate amounts of Fe²⁺ or iron chips to the solution were found to be favorable for 4-CP degradation. The main intermediates of 4-CP degradation are p-benzoquinone, hydroquinone, 4-chlorocatechol, p-chloronitrobenzene, and ring cleavage products (acetic acid, glycol, propanone, and others). Furthermore, possible pathways of 4-CP degradation in solution are proposed.     

Comparison of different sample preparation treatments for the analysis of wine phenolic compounds in human plasma by reversed phase high-performance liquid chromatography

Phenolic compounds are common constituents of wine. Due to their healthy properties the analysis in human fluids is interesting within bioavailability evaluation. They have been reported not to be stable in human plasma, particularly at room temperature. Most sample treatments have been reported for a single compound. Our aim in this paper is to study sample handling control conditions and improve phenolic stability in human plasma samples. We tested various sample treatments to determine whether they could be used for analysing a set of phenolic compounds usually present in wines.The compounds studied were six phenolic acids, five flavonoids, trans-resveratrol and tyrosol. The effect of the following factors was explored: temperature, pH, the addition of antioxidants and the addition of anticoagulants.The results suggest that the plasma samples should be kept at temperatures below −20 °C before analysis and that 1% ascorbic acid plus 10 μl/ml o-phosphoric acid should be added. Anticoagulants (heparin or EDTA) do not play a significant role in the stability of polyphenolic compounds.The recovery values of a number of sample treatments (solid phase extraction, extraction with methanol, deproteinization, inhibition of enzymatic plasma activity) were compared. The recovery values for most phenolic compounds were better if the enzymatic plasma activity was inhibited and acidified ethanol was used for deproteinization.     

Determination of Total Reduced Thiol Levels in Plasma Using a Bromide Substituted Quinone

The exploitation of 2‐bromo‐1,4‐naphthoquinone (NQBr) as a selective redox label for the determination of reduced thiol functionalities (RSH) has been investigated. The system is selective for RSH functionality, giving distinct voltammetric signals for glutathione and cysteine but can also be adapted for broad spectrum thiol detection. Ion chromatographic protocols based on conductimetric detection enable total RSH analysis (protein and monomolecular moieties) within human plasma. Bromide released through the reaction can be easily quantified and integrated within normal IC measurements. The efficacy of the approach has been assessed and the response validated through comparison with the standard colorimetric technique.     

医用聚氯乙烯膜的等离子体表面改性

用两种不同气氛的辉光放电等离子体工艺对医用软质聚氯乙烯（ＰＶＣ）膜进行了表面改性研究。结果表明，聚合性气氛的等离子体改性效果明显优于非聚合性气氛。平整致密的聚合膜对ＰＶＣ增塑剂——邻苯二甲酸二辛酯的迁移和扩散起了阻挡作用，也使膜表面亲水性和表面张力极性成份增大，液固相界面张力减小，生物相容性得以改善。     

Structure and properties of plasma-polymerized thin films of polyaniline

Plasma polymerization of aniline and in-situ doping of polvaniline with iodine was carried out using radio frequency glow discharge. Thin films of polyaniline were deposited on platinum and glass. The infrared spectrum shows that the aromatic ring is retained under the plasma conditions. The electrical conductivity measurements indicate that the conductivity increases by more than seven orders of magnitude when the polyaniline is doped by iodine. The scanning electron microscopic studies reveal the formation of irregular pentagons on glass substrate while on platinum, polvaniline forms a fibrillar network. In both the cases a continuous film is obtained.     

Influence of the Excited States of Atomic Nitrogen N(<Superscript>2</Superscript>D) and N(<Superscript>2</Superscript>P) on the Transport Properties of Nitrogen. Part I: Atomic Nitrogen Properties

In this paper, calculated values of the viscosity and thermal conductivity of atomic nitrogen, taking into account three species (the ground and two excited states), are presented. The calculations, which assume that the temperature dependent probability of occupation of the states is given by the Boltzmann factor, are performed for atmospheric-pressure in the temperature range from 1,000 to 20,000 K. Six collision integrals are used in calculating the transport coefficients and we have introduced new averaged collision integrals where the weight associated at each interacting species pair is the probable collision frequency. The influence of the collision integral values and energy transfer between two different species is studied. These results are compared which those of published theoretical studies.     

等离子体聚合及其聚合物的应用

本文着重综述了烃,含氮、氧的有机化合物,碳氟化合物以及有机硅化合物的等离子体聚合。同时还系统地介绍了等离子体聚合物在制备反渗透膜、分离膜、材料表面的涂层等方面的国内外的最新研究成果。     

Mode selective directional couplers for overmoded waveguide systems

Two types of directional couplers for transverse electric (TE) modes are described: short and multihole couplers, respectively. They selectively pick one mode out of a mode mixture in an overmoded circular waveguide system. Unwanted modes are either statistically kept at low level or are suppressed by destructive interference in the coupling waveguide. Mode selectivity and directivity in multihole couplers oscillate up and down with an increasing number of holes, finally reaching a minimum of approximately 20 dB, unless there are competing modes with rational fractions of the beat wavelength. A multihole coupler for the TE₀₂ mode (28 GHz, 63.4 mm waveguide diameter, 41 holes) and a length of 1.6 m shows a calculated directivity of 68 dB and suppresses the unwanted modes TE₀₁ with 34 dB (24 dB), TE₂₂ with 37 dB (45 dB), and further modes TE_m (<5, m<6) with 17 dB to 34 dB in forward direction (figures in parentheses are for unwanted modes propagating in backward direction).A short directional coupler for the TE₀₁ mode (28 GHz, 63.4 mm waveguide diameter) with 16 holes and a length of 230 mm shows a directivity of 55 to 100 dB between 27.9 and 28.1 GHz, suppressing the TE₀₂ mode with 35 to 80 dB, the TE₀₃ mode with 30 to 65 dB, and the TE₂₂ mode with 30 to 70 dB.     

Liquid chromatographic/electrospray mass spectrometric determination (LC/ESI-MS) of chelerythrine and dihydrochelerythrine in near-critical CO2 extracts from real and spiked plasma samples

Two polar benzo[c]phenanthridine alkaloids, chelerythrine (CHE) and dihydrochelerythrine (DHCHE), were extracted at 35 °C and 10 MPa (15 MPa for real samples) from real and spiked plasma samples with acceptable recoveries (95.1% and 81.0%, respectively) using near-critical CO₂ modified with aqueous (1:1, v/v) methanol. The alkaloids were quantified by a liquid chromatographic/electrospray mass spectrometric (LC/ESI-MS) method on a Zorbax SB-CN column (75 mm × 4.6 mm, 3.5 μm particle size) using methanol (organic phase) and 50 mM ammonium formiate (aqueous phase) as a mobile phase. A linear gradient 0-1 min, isocratic at 60% organic phase (v/v); from 1.0 to 7.0 min, 60-71% organic phase (v/v); from 7.0 to 18.0 min, 71-60% organic phase (v/v) was applied. The limit of detection was 1.22 ng (3.50 pmol) for CHE and 0.95 ng (2.72 pmol) for DHCHE per 1 ml of the sample. The linearity of the calibration curves was satisfactory as indicated by coefficients of determination 0.9979 and 0.9995 for CHE and DHCHE, respectively. Repeatability and intermediate precision (average R.S.D.s) were 1.0-1.5%, accuracy was in the range 99.7-100.3%. Average recovery was 100.1% for both, standard solutions and spiked plasma extracts. Three samples of real rat plasma were extracted and analysed to test the method.     

Curing of liquid epoxy resin in plasma discharge

Epoxy resins in the solid state, liquid state and during polymerisation were treated by microwave oxygen plasma and analysed by FTIR spectra. Curing, etching and oxidation kinetics of epoxy resin were observed. In the liquid resin and polymerising mixture the effect of structure modification was observed more intensively than in the case of solid sample due to a mixing process. A modification of bulk layers of liquid epoxy resin was observed under plasma action. The polymerisation reaction of epoxy resin with amine hardening agent can be released in plasma discharge at low pressure.