Untersuchungen zur mikroanalytischen Bestimmung der langkettigen Fetts?uren im Blut

Zusammenfassung Für die im Plasma an Albumin gebundenen sog. freien Fettsäuren (FFS) wird ein neues gas-chromatographisches Analysenverfahren vorgestellt. Das Probenvolumen beträgt 50 l Serum oder Plasma. Die Extraktion erfolgt in 1,1 ml CHCl₃/CH₃OH (21, v/v) mit n-Heptadecansäure als innerem Standard (0,05 Val C₁₇₀/ml). Nach Eindampfen am Rotationsverdampfer werden die FFS im verschlossenen Reaktionskölbchen mit 20 l CH₃J/Essigsäureäthylester (11, v/v) über festem K₂CO₃ bei 90°C 1 h verestert. Die Varianz des Verfahrens errechnet sich bei 15 Parallelbestimmungen zu 4,85%.Vortrag anläßlich der Tagung Spurenanalyse, 2. bis 5. April 1973 in Erlangen.     

A model for the etching of Si in CF4 plasmas: Comparison with experimental measurements

A model has been developed to describe the chemistry which occurs in CF₄ plasmas and the etching of Si both in the plasma and downstream. One very important feature of this model is that for discharge residence times which vary by more than an order of magnitude, the amount of CF₄ consumed is low and relatively constant. This is because the gas-phase combination reactions between F and both CF₃ and CF₂ lead to the rapid reforming of CF₄. The model predicts that CF₂ is a major species in the gas phase and that the [F] detected as a sample point downstream is a very sensitive function of [CF₂]/[F] in the discharge. Even though the calculations show that [F] in the discharge varies only slightly over the wide range of experimental conditions considered, large variations in [F] at the sample point occur because the [CF₂]/[F] ratio in the discharge changes. The concentrations of C₂F₆ and SiF₄ are predicted to within a factor of 2 over a very wide range of experimental conditions. This confirms the importance of gas-phase free radical reactions in the etching of Si.     

等离子体聚合及其聚合物的应用

本文着重综述了烃,含氮、氧的有机化合物,碳氟化合物以及有机硅化合物的等离子体聚合。同时还系统地介绍了等离子体聚合物在制备反渗透膜、分离膜、材料表面的涂层等方面的国内外的最新研究成果。     

Large-area boron carbide protective coatings for controlled thermonuclear research prepared byin situ plasma CVD

Impurity release from the first wall and components facing the hot plasma in Tokamak devices for controlled fusion research and the concomitant pollution of the plasma lead to enhanced energy losses and deuterium-tritium luel dilution. Both these effects can prevent reaching the ignition conditions. The recently developed technique for large areain situ deposition of boron carbide protective coatings by means of plasma-induced chemical vapor deposition enables one to significantly improve the purity of the fusion plasma. The prospects of approaching the scientific break-even in the large machines of the Tokarnak type has been increased.Extended version of an invited paper presented at the 10th International Symposium on Boron, Borides, and Related Compounds, Albuquerque, New Mexico, August 1990.The term Tokarnak is an abbreviation of the Russian name toroidal magnetic chamber.     

Influence of velocity and surface temperature of alumina particles on the properties of plasma sprayed coatings

In this paper are described the main characteristics of the plasma spraying process of alumina deposits, i.e., the temperature and flow field of the plasma jets obtained with the classical spraying torches, the injection of the particles into the plasma jet, the particle surface temperature and velocities in the plasma (measured for calibrated alumina particles), and the coating generation. The measurements on the alumina particles are compared with the predictions of a mathematical model. The experimental and computed particle velocities are in rather good agreement. However, this is not the case for the particle surface temperature. Possible reasons for the discrepancy are proposed (influence of the carrier gas, thermophoretic forces, and poor penetration of the particles into the plasma core even for an injection velocity twice that of the optimal calculated one, as shown by recent measurements). Finally the correlations between the particle velocities and surface temperature, and the properties of the alumina coating (porosity, crystal structure, mechanical properties) are studied.     

Gas chromatographic determination of organolead compounds with an alternating current plasma detector

The performance of the gas chromatography/alternating current plasma detector as a selective detector for organolead compounds is investigated. The helium make-up flow rate and the spatial position from which the lead emission is viewed, have an effect on the detector response. The detection limit for tetrabutyl lead was established as 130 pg/s and the lead selectivity ratio was found to exceed 13,800. Some applications of organolead determination in complex matrices were also studied in order to demonstrate the selectivity and sensitivity of the alternating current plasma detector.     

Tuning the properties of a black TiO2-Ag visible light photocatalyst produced by a rapid one-pot chemical reduction

A highly efficient black TiO₂-Ag photocatalytic nanocomposite, active under both UV and visible light illumination, was synthesized by decorating the surface of 25 nm TiO₂ particles with Ag nanoparticles. The material was obtained via a rapid, one-pot, simple (surfactant and complexing agent free) chemical reduction method using silver nitrate and formaldehyde as a metal salt and reducing agent, respectively. The nanocomposite shows an increase of over 800% in the rate of photocatalytic methylene blue dye degradation, compared to commercial unmodified TiO_2, under UV-VIS illumination. Unlike pure TiO₂, the nanocomposite exhibits visible light activation, with a corresponding drop in optical reflectance from 100% to less than 10%. The photocatalytic properties were shown to be strongly enhanced by post-reduction annealing heat treatments in air, which were observed to decrease, rather than coarsen, silver particle size, and increase particle distribution. This, accompanied by a variation in the silver surface oxidation states, appear to dramatically affect the photocatalytic efficiency under both UV and visible light. This highly active photocatalyst could have wide ranging applications in water and air pollution remediation and solar fuel production.     

Metabolic fingerprinting of high-fat plasma samples processed by centrifugation- and filtration-based protein precipitation delineates significant differences in metabolite information coverage

Metabolomics and metabolic fingerprinting are being extensively employed for improved understanding of biological changes induced by endogenous or exogenous factors. Blood serum or plasma samples are often employed for metabolomics studies. Plasma protein precipitation (PPP) is currently performed in most laboratories before LC–MS analysis. However, the impact of fat content in plasma samples on metabolite coverage has not previously been investigated. Here, we have studied whether PPP procedures influence coverage of plasma metabolites from high-fat plasma samples. An optimized UPLC-QTOF/MS metabolic fingerprinting approach and multivariate modeling (PCA and OPLS-DA) were utilized for finding characteristic metabolite changes induced by two PPP procedures; centrifugation and filtration. We used 12-h fasting samples and postprandial samples collected at 2 h after a standardized high-fat protein-rich meal in obese non-diabetic subjects recruited in a dietary intervention. The two PPP procedures as well as external and internal standards (ISs) were used to track errors in response normalization and quantification. Remarkably and sometimes uniquely, the fPPP, but not the cPPP approach, recovered not only high molecular weight (HMW) lipophilic metabolites, but also small molecular weight (SMW) relatively polar metabolites. Characteristic SMW markers of postprandial samples were aromatic and branched-chain amino acids that were elevated (p < 0.001) as a consequence of the protein challenge. In contrast, some HMW lipophilic species, e.g. acylcarnitines, were moderately lower (p < 0.001) in postprandial samples. LysoPCs were largely unaffected. In conclusion, the fPPP procedure is recommended for processing high-fat plasma samples in metabolomics studies. While method improvements presented here were clear, use of several ISs revealed substantial challenges to untargeted metabolomics due to large and variable matrix effects.     

Micellar electrokinetic biofluid analysis of biogenic amines using on-line sample concentration and UV laser-induced native fluorescence detection

A simple and sensitive sweeping micellar electrokinetic chromatography method coupled with UV laser-induced native fluorescence detection has been developed for quantitative analysis of biogenic amines in biofluids. The background electrolyte comprised 30 mmol L⁻¹ phosphoric acid and 20 mmol L⁻¹ sodium dodecyl sulfate. The concentration limits of detection of analytes using sweeping-micellar electrokinetic chromatography (sweeping-MEKC) were in the range 7–100 nmol L⁻¹, which were 250–3600-fold improvement for dopamine, DOPA and epinephrine compared with conventional capillary zone electrophoresis. An improvement of approximately 20-fold was observed for all analytes compared with typical micellar electrokinetic chromatography conditions. Baseline separation was achieved for the all analytes within 12 min and migration-time and peak-area repeatability were better than RSD 0.35% and 5.68%, respectively. The developed method was applied to measure the biogenic amines in biofluids extracted from wheat phloem sap, human plasma and human urine.