Segmental and secondary dynamics in hydrogen‐bonded poly(4‐vinylphenol)/poly(methyl methacrylate) blends

Broadband dielectric spectroscopy was used to study the segmental (α) and secondary (β) relaxations in hydrogen‐bonded poly(4‐vinylphenol)/poly(methyl methacrylate) (PVPh/PMMA) blends with PVPh concentrations of 20–80% and at temperatures from ?30 to approximately glass‐transition temperature (T_g) + 80 °C. Miscible blends were obtained by solution casting from methyl ethyl ketone solution, as confirmed by single differential scanning calorimetry T_g and single segmental relaxation process for each blend. The β relaxation of PMMA maintains similar characteristics in blends with PVPh, compared with neat PMMA. Its relaxation time and activation energy are nearly the same in all blends. Furthermore, the dielectric relaxation strength of PMMA β process in the blends is proportional to the concentration of PMMA, suggesting that blending and intermolecular hydrogen bonding do not modify the local intramolecular motion. The α process, however, represents the segmental motions of both components and becomes slower with increasing PVPh concentration because of the higher T_g. This leads to well‐defined α and β relaxations in the blends above the corresponding T_g, which cannot be reliably resolved in neat PMMA without ambiguous curve deconvolution. The PMMA β process still follows an Arrhenius temperature dependence above T_g, but with an activation energy larger than that observed below T_g because of increased relaxation amplitude. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3405–3415, 2004     

Hydroxylation-induced modifications of the Al2O3/NiAl(0 0 1) surface at low water vapour pressure

STM, STS, LEED and XPS data for crystalline θ-Al₂O₃ and non-crystalline Al₂O₃ ultra-thin films grown on NiAl(0 0 1) at 1025 K and exposed to water vapour at low pressure (1 × 10⁻⁷-1 × 10⁻⁵ mbar) and room temperature are reported. Water dissociation is observed at low pressure. This reactivity is assigned to the presence of a high density of coordinatively unsaturated cationic sites at the surface of the oxide film. The hydroxyl/hydroxide groups cannot be directly identify by their XPS binding energy, which is interpreted as resulting from the high BE positions of the oxide anions (O_1s signal at 532.5-532.8 eV). However the XPS intensities give evidence of an uptake of oxygen accompanied by an increase of the surface coverage by Al³⁺ cations, and a decrease of the concentration in metallic Al at the alloy interface. A value of ∼2 for the oxygen to aluminium ions surface concentration ratio indicates the formation of an oxy-hydroxide (AlO_xOH_y with x + y ∼ 2) hydroxylation product. STM and LEED show the amorphisation and roughening of the oxide film. At P(H₂O) = 1 × 10⁻⁷ mbar, only the surface of the oxide film is modified, with formation of nodules of ∼2 nm lateral size covering homogeneously the surface. STS shows that essentially the valence band is modified with an increase of the density of states at the band edge. With increasing pressure, hydroxylation is amplified, leading to an increased coverage of the alloy by oxy-hydroxide products and to the formation of larger nodules (∼7 nm) of amorphous oxy-hydroxide. Roughening and loss of the nanostructure indicate a propagation of the reaction that modifies the bulk structure of the oxide film. Amorphisation can be reverted to crystallization by annealing under UHV at 1025 K when the surface of the oxide film has been modified, but not when the bulk structure has been modified.     

Complementary spectroscopic techniques to model the association of contaminant uranium with structural surfaces

Contaminant uranium poses unique problems for decontamination of former weapons processing and nuclear power facilities, as well as chemical plants, waste storage sites and former mining facilities. In addition, dealing with the possibility of intentional (i.e., a terrorist act) or accidental release of radioactive material in a populated area requires an accurate understanding of the nature of the association of such material with structural surfaces. These surfaces must also be considered in the context of repeated contamination, and the importance of atmospheric exposure, interaction with other possible contaminants, and corrosion or surface degradation due to such exposure must be taken into account. Complementary spectroscopic techniques, especially surface spectroscopies, are essential in developing models for the interaction of contaminants with surfaces and interfaces. In this review (which also presents new data on uranium association with corroding steel surfaces), we collect models of this association as determined by spectroscopic techniques, assess the important considerations in the development of more accurate models, and address some of the questions which remain.     

Lorentz-Compton佯谬与一个双赢判决性散射实验设计

通过对“可见光区域是否存在Compton效应”的讨论而进一步深化到经典条件下“光的量子理论能否包含光的经典电磁理论”的实验验证,发现了Lorentz-Compton佯谬,并基于逆Compton散射设计了一个敏感而又可行的双赢判决性散射实验来解决此佯谬。     

Synthesis and structures of nitroxyalkyl methylphosphonates

The reactions of ethylene glycol mononitrate and glycerol 1,3-dinitrate with methylphosphonic dichloride afforded new nitroxyalkyl methylphosphonates.     

Mössbauer and X-ray diffraction characterization of Fe60Al40 coatings prepared by thermal spraying

Microstructured (atomized) and nanostructured (milled) Fe₆₀Al₄₀ powders together with their corresponding coatings synthesized by High Velocity Oxy-fuel (HVOF) or Atmospheric Plasma Spray (APS) thermal spraying techniques have been characterized by Mössbauer Spectroscopy (MS) and X-ray Diffraction (XRD). The evolution of the microstructure and the atomic ordering degree in the powders and coatings are discussed at the light of the various processing conditions. The operational correlation between the parameters of the duplex morphology of coatings and the processing parameters is discussed.     

A detailed analysis of the photoemission spectra of basic thioaromatic monolayers on noble metal substrates

Analysis of photoemission spectra of complex thioaromatic self-assembled monolayers (SAMs) requires the knowledge and understanding of such spectra for the basic systems. Keeping this goal in mind, synchrotron-based high-resolution X-ray photoelectron spectroscopy was used to characterize SAMs formed from the simplest thioaromatic compounds, namely thiophenol, 1,1′-biphenyl-4-thiol and 1,1′;4′,1″-terphenyl-4-thiol on evaporated Au(1 1 1) and Ag(1 1 1) substrates. The acquired S 2p and C 1s spectra were analyzed in terms of fine structure and initial and final state effects in the photoemission process. The assignment of the individual spectral features was considered in detail. Conclusions on quality and chemical and structural homogeneity of the investigated SAMs were derived.     

Investigation of chemical decomposition of CCl4 on TiO2 near room temperature

Dissociative adsorption of CCl₄ on TiO₂ at 35 °C has been studied by Fourier-transform infrared spectroscopy, X-ray photoelectron spectroscopy, and electron spin resonance. CCl₄ decompose to form CO, CO₂, and CO₃ on the surface, at such a low temperature, in which CO₂ formation is not from CO oxidation on TiO₂, but CO₃ can be produced by CO and CO₂ adsorption. The Cl generated from CCl₄ decomposition is left on the surface and bonded to titanium ions. Mineralization of CCl₄ on TiO₂ involves the lattice oxygens. Thermodynamical driving force and possible reaction routes for CO and CO₂ formation in the CCl₄ decomposition on TiO₂ are discussed.     

Effects of trapped electrons on the line shape in emission Mössbauer spectra

To explain line broadening in emission Mössbauer spectra as compared to the corresponding absorber measurements, the model of trapped electrons has been proposed. Auger electrons (emitted, e.g. after electron capture by ⁵⁷Co or after the converted isomeric transition of ^119mSn), as well as secondary electrons, may be trapped in the proximity to the nucleogenic ion. Electrons captured by lattice traps at different distances from the daughter ion induce an asymmetric distribution of quadrupole splitting in the resulting emission spectra, as shown in a few examples. This model is supported by estimates of quadrupole splitting values which may be caused by such trapped electrons located at specified distances from the nucleogenic atom.     

Analysis of reflectance and modulation spectroscopic lineshapes in optoelectronic device structures

We discuss the spectral lineshapes of reflectance and modulated reflectance (MR) measurements on optoelectronic device structures such as epi-layers, quantum wells (QWs), vertical-cavity surface emitting-lasers (VCSELs) and resonant-cavity light-emitting diodes (RCLEDs). We consider the various methods for the extraction of built-in electric fields and band-gap energies from Franz-Keldysh oscillations (FKO), using the example of a tensilely strained InGaAs QW system, whose InGaAsP barriers yield strong FKO. We describe how critical point transition energies can be easily obtained by eye from Kramers-Kronig (KK) transforms of low field or QW modulation spectra, using the example of the modulated transmittance spectra of dilute-nitrogen InGaAsN p-i-n structures. We also discuss how the ordinary reflectivity spectrum, usually acquired at the same time as the MR signal, may also be exploited to extract layer thicknesses and compositions, and information about the active QW absorption spectrum in VCSEL and RCLED structures.