高精度的光纤衰减系数测试系统的设计

利用常规仪器设备，设计了一套集光、机、电为一体的光纤衰减测量,实现了数字化监测显示，并可与微机接口；采用双光路法，消除了由于光源光强不稳定产生的误差。     

An ASE Reduction Filter Using Cascaded Optical Fiber Grating Couplers in EDFA Repeater

A new configuration for an ASE reduction filter in EDFA repeaters for WDM optical transmission systems using optical fiber grating couplers (FGCs) was proposed and first demonstrated. The filtering characteristics of the proposed filter for amplified single wavelength signal and 2-channel WDM signals using EDFA were identified. It was found that the filter was effective to improve SNR in optical domain by reducing ASE noise. The required FGC characteristics for the filter were theoretically predicted under the condition that the total filter loss did not exceed 3 dB. More than 70% of drop efficiency was required in each FGC for the application of the proposed filter to an 8-channel WDM system using EDFA repeaters.     

Low noise double pass L-band erbium-doped fiber amplifier

A new double pass long wavelength band erbium-doped fiber amplifier with enhanced noise figure characteristics is demonstrated. The noise figure is improved by about 2.6 dB with the incorporation of broadband conventional-band fiber Bragg grating (FBG) in between the two segments of erbium-doped fiber. By incorporating both the pre-amplifier and the FBG, the noise figure is further improved, which varies from 4.0 to 5.0 dB in the flat gain region from 1570 to 1600 nm. The gain varies from 32.0 to 33.4 dB within this region. The new amplifier with high gain and low noise figure can be useful as an inline amplifier in a wavelength division multiplexing transmission system.     

光放大器前置可调光学滤波器

介绍Ｆ－Ｐ干涉滤波器实现中心波长可调的两种机理，给出通过改变腔距来改变中心波工的滤波器的典型结构，并且给出了相应的电压驱动电路，实验表明选择合适的光放大器前置滤波器可以提高系统的灵敏度。     

椭圆波导FEM放大器的非线性特性研究

 以椭圆波导、平板摇摆器为FEM放大器的模型，导出了自洽的注波互作用三维非线性方程组。在此基础上编制了相应的程序。利用该程序分析了FEM放大器的饱和功率、效率以及带宽等高频特性。考虑了摇摆器渐变、空间电荷波、电子初始速度零散对高频特性的影响。     

具有高机械强度的掺Er~(3 )∶TeO_2-Nb_2O_5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-X)TeO2-XNb2O5(X=5,10,15,20mol%),测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt(t=2,4,6)和受激发射截面σemi的大小,研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性,并与典型的碲锌钠玻璃(75TeO2-20ZnO-5Na2O)在热学、机械强度、光谱性质和放大品行四个方面进行了比较.     

A 24-GHz Patch Array with a Power Amplifier/Low-Noise Amplifier MMIC

This paper presents an active patch array designed at 24 GHz. It can be used as a front-end component for a phased array. A series resonant array structure is chosen which is compact and easy excite. With 5 elements, the array proved a 12-dB antenna gain. A power amplifier and a low noise amplifier are designed on a single GaAs chip (PALNA). Bias switch is used in the PALNA, which greatly reduces the switch loss in a transceiver and increases the efficiency. 20-dB small signal gain is achieved in both power amplifier and low noise amplifier. The active patch array is built by the combination of the patch array and PALNA. The measured active gain of this antenna is 35-dB for the PA mode and 31-dB for the LNA mode. This active patch array can obtain an EIRP of 34 dBm with a total radiated power of 22dBm and a maximum PAE of 32%. To check the noise performance, we applied sources at both normal temperature and 77K (liquid nitrogen) and extracted the noise figure (3.5 dB) of the active antenna by the Y factor method. The results proved that the active antenna is working efficiently as both a transmitting and receiving antenna.     

Broadband spectral shaping in a Ti:sapphire regenerative amplifier

A birefringent crystal quartz plate of known thickness has been used as a spectral filter for spectral shaping in a Ti:sapphire regenerative amplifier. The spectral profile of the amplified pulse ejected from the regenerative amplifier was observed while adjusting the birefringent crystal plate in the cavity. By altering the gain spectrum, the bandwidth of the regeneratively amplified pulse was increased from 18 to 35 nm by using a 0.34-mm thick birefringent plate. The output pulse spectrum from the regenerative amplifier neared the bandwidth of the seed pulse. As a comparison, we used a coated filter outside the regenerative amplifier cavity, and the bandwidth of the regeneratively amplified pulse was stretched to 28 nm. When the bandwidth was stretched to 35 nm, the pulse was compressed to 35 fs.     

相对论速调管放大器辐射频率可调性机理

 用场方法研究了相对论速调管放大器辐射频率的可调性。发现调制电流频率的可调性与一阶Bessel函数的周期相关，对应相同的一阶Bessel函数值，可以有多个不同数值的宗量，调制电流的频率与Bessel函数宗量数值包括中间腔与提取腔之间的距离和电子束的传输速度等因素相联系。理论估计的调制电流频率可调范围与实验测得的结果符合得很好。相对论速调管放大器辐射频率的可调性还取决于提取腔的设计。     

开关型霍尔传感器的原理与工程实现

介绍了开关型霍尔传感器的工作原理，设计了适用于工程测量的具体线路，并分析了该线路的特点。