Design and application of phase photon sieve

The imaging principle of Fresnel zone plate and photon sieve were analyzed in this paper. The design and fabrication of phase photon sieve were discussed. The feasibility of using phase photon sieve to realize nano-lithography was analyzed, a novel lithography experiment system based on phase photon sieve was presented, which not only has higher resolution and image contrast than the Fresnel zone plate lithography but also have higher diffractive efficiency than the amplitude photon sieve lithography.     

Annihilation and creation of rotating waves by a local light pulse in a protoplasmic droplet of the Physarum plasmodium

Pattern dynamics plays a fundamental role in biological functions from cell to organ in living systems, and the appearance of rotating waves can lead to pathological situations. Basic dynamics of rotating waves of contraction-relaxation activity under local perturbation is studied in a newly developed protoplasmic droplet of the Physarum plasmodium. A light pulse is applied by irradiating circularly a quarter of the droplet showing a single rotating wave. The oscillation pattern changes abruptly only when the irradiation is applied at a part of the droplet near the maximal contraction. The abrupt changes are as follows: the rotating wave disappears or is displaced when the irradiation area is very close to the center of the rotating wave, while new rotating waves are created when the irradiation area is far from the center of the rotating wave. These results support the hypothesis that the phase response curve has a discontinuous change (type 0 resetting) from delay to advance around the maximal contraction. The significance of the results is discussed in relation to “vulnerability” in excitable media and biological systems in general.     

An investigation of structural phase transformation and electrical resistivity in Ta films

In this work, we report the effect of substrate, film thickness and sputter pressure on the phase transformation and electrical resistivity in tantalum (Ta) films. The films were grown on Si(1 0 0) substrates with native oxides in place and glass substrates by varying the film thickness (t) and pressure of the working gas (p_Ar). X-ray diffraction (XRD) analysis showed that the formation of α and β phases in Ta films strongly depend on the choice of substrate, film thickness t and sputter pressure p_Ar. A stable α-phase was observed on Si(1 0 0) substrates for t ≤ 200 nm. Both α and β phases were found to grow on glass substrates at all thicknesses except t = 100 nm. All the films grown on Si(1 0 0) substrates for p_Ar ≤ 6.5 mTorr had α-phase with strong (1 1 0) texture normal to the film plane. The glass substrates promoted the formation of β-phase in all p_Ar except p_Ar = 5.5 mTorr. The resistivity ρ was observed to decrease with t, whereas ρ was increased with p_Ar on Si(1 0 0) substrates. In all films, the measured resistivity ρ was greater than the bulk resistivity. The resistivity ρ was influenced by the effects of surface roughness and grain size.     

Solvothermal synthesis and characterization of CdSe nanocrystals with controllable phase and morphology

Zinc blende (ZB) CdSe hollow nanospheres were solvothermally synthesized from the reaction of Cd(NO₃)₂·4H₂O with a homogeneously secondary Se source, which was first prepared by dissolving Se powder in the mixture of ethanol and oleic acid at 205 °C. As Se power directly reacted with Cd(NO₃)₂·4H₂O in the above mixed solvents, wurtzite (W) CdSe solid nanoparticles were produced. Time-dependent experiments suggested that the formation of CdSe hollow nanospheres was attributed to an inside-out Ostwald ripening process. The influences of reaction time, temperature and ethanol/oleic acid volume ratio on the morphology, phase and size of the hollow nanospheres were also studied. Infrared (IR) spectroscopy investigations revealed that oleic acid with long alkene chains behaved as a reducing agent to reduce Se powder to Se²⁻ in the synthesis. Photoluminescence (PL) measurements showed that the ZB CdSe hollow nanospheres presented an obvious blue-shifted emission by 42 nm, and the W CdSe solid nanoparticles exhibited a band gap emission of bulk counterpart.     

Intermediate-temperature polymorphic phase transition in KH2PO4: A synchrotron X-ray diffraction study

We have used synchrotron X-ray diffraction to investigate the structural and chemical changes undergone by polycrystalline KH₂PO₄ (KDP) upon heating within the 30-250 °C temperature interval. Our data show evidence of a polymorphic transition at T∼190 °C from the room-temperature tetragonal KDP phase to a new intermediate-temperature monoclinic KDP modification (spacegroup P2₁/m and lattice parameters a=7.590, b=6.209, c=4.530 Å, and β=107.36°). The monoclinic RDP polymorph remains stable upon further heating to 235 °C, and is isomorphic to its RbH₂PO₄ and CsH₂PO₄ counterparts.     

Frequency Domain Fluorescence Lifetime Study of Crude Petroleum Oils

Frequency domain (FD) fluorescence lifetime data was collected for a series of 20 crude petroleum oils using a 405 nm excitation source and over a spectral range of ~426 to ~650 nm. Average fluorescence lifetimes were calculated using three different models: discrete multi-exponential, Gaussian distribution, and Lorentzian distribution. Fitting the data to extract accurate average lifetimes using the various models proved easier and less time consuming for the FD data than with Time Correlated Single Photon Counting (TCSPC) methods however the analysis of confidence intervals to the computed average lifetimes proved cumbersome for both methods. The uncertainty in the average lifetime was generally larger for the discrete lifetime multi-exponential model when compared to the distribution-based models. For the lifetime distributions, the data from the light crude oils with long lifetimes generally fit to a single decay term. Heavier oils with shorter lifetimes required multiple decay terms. The actual value for the average lifetime is more dependant on the specific fitting model employed than the data acquisition method used. Correlations between average fluorescence lifetimes and physical and chemical parameters of the crude oils were made with a view to developing a quantitative model for predicting the gross chemical composition of crude oils. It was found that there was no significant benefit gained by using FD over TCSPC other than more rapid data analysis in the FD case. For the FD data the Gaussian distribution model for fluorescence lifetime gave the best correlations with chemical composition allowing a qualitative correlation to some bulk oil parameters.

Reduction of surface coverage of finite systems due to geometrical steps

The coverage of vicinal, stepped surfaces with molecules is simulated with the help of a two-dimensional Ising model including local distortions and an Ehrlich-Schwoebel barrier term at the steps. An effective two-spin model is capable to describe the main properties of this distorted Ising model. It is employed to analyze the behavior of the system close to the critical points. Within a well-defined regime of bonding strengths and Ehrlich-Schwoebel barriers we find a reduction of coverage (magnetization) at low temperatures due to the presence of the surface step. This results in a second, low-temperature transition besides the standard Ising order-disorder transition. The additional transition is characterized by a divergence of the susceptibility as a finite-size effect. Due to the surface step the mean-field specific heat diverges with a power law.     

Simplification of formulas for compression wave and oscillating flow in circular pipe

We had already obtained the analytical solutions for the compression wave and steady-state oscillating flow in a pipe with a circular cross section [Sato Y, Kanki H. Formulas for compression wave and oscillating flow in circular pipe. To be published in Appl Acoust [accepted 11 Sept. 2006]]. This work contains three key-components. The first key is to simplify the formulas using the unique mathematic technique without losing the accuracy. Simplifying the formulas is the one of the most important factors for formulas used in engineering use. The results will enable us to greatly reduce the work and computation costs. The second is to verify the flow distribution calculated by our formulas. The third is to study the possibility of application of our method to the analysis in turbulent flow region. Kawata et al. have represented the validity of one-dimensional quasi-analysis in turbulent flow region, using the method of D’Souza et al. and the shear viscosity. Therefore, in this paper the validity of the analysis in a turbulence region was verified by proving theoretically that the methods of D’Souza et al. and ours are intrinsically equivalent. The proof of equivalence was accomplished using the formulas simplified in this paper.     

On the mechanism of the zircon-reidite pressure induced transformation

We report first principles results of a detailed investigation directed to elucidate mechanistic aspects of the zircon-reidite phase transition in ZrSiO₄. The calculated thermodynamic boundary is located around 5 GPa, and the corresponding thermal barrier, estimated from temperatures at which the transition is observed at zero and high pressure, is 133 kJ/mol. Under a martensitic perspective, we examine two different transition pathways at the thermodynamic transition pressure. First, the direct, displacive-like, tetragonal I4₁/a energetic profile is computed using the c/a ratio as the transformation parameter, and yields a very high activation barrier (236 kJ/mol). Second, a quasi-monoclinic unit cell allows us to characterize a transition path from zircon (β=90^°) to reidite (β=114.51^°) with an activation barrier of around 80 kJ/mol at β=104^°. This energy is somewhat lower than our previous estimation and supports the reconstructive nature of the transformation at the thermodynamic transition pressure.     

Optical properties of layered superconductor LixZrNCl

We investigated band-insulator-to-superconductor transition in Li_xZrNCl driven by carrier doping by means of magnetization, resistivity, and optical reflectivity measurements. The magnetization and the resistivity measurements showed that the transition occurs at around x=0.05. The pristine β-ZrNCl exhibited reflectivity and optical conductivity spectra typical of an insulator, whereas in the spectrum of Li_0.37ZrNCl, Drude-like high reflectance band and associated plasma edge are apparently observed. This is the direct spectroscopic evidence of insulator-to-metal transition of Li_xZrNCl.