远场超分辨随机光重建显微镜(STORM)研究进展

了解细胞内分子尺度的动态和结构的特征是生命科学迫切需要解决的问题,要求远场光学成像要求纳米或亚纳米量级的空间分辨率.介绍了一种实现打破衍射极限的远场荧光显微成像技术--随机光重建显微术(STORM),其分辨率可以达到横向分辨率20 nm,轴向分辨率50 nm,理论上这种方法的空间分辨率可以达到单分子定位的精度.具体介绍...     

The influence of interfacial barrier engineering on the resistance switching of In₂O₃:SnO₂/TiO₂/In₂O₃:SnO₂ device

The I–V characteristics of In2O3:SnO2/TiO2/In2O3:SnO2 junctions with different interfacial barriers are inves- tigated by comparing experiments. A two-step resistance switching process is found for samples with two interfacial barriers produced by specific thermal treatment on the interfaces. The nonsynchronous occurrence of conducting filament formation through the oxide bulk and the reduction in the interfacial barrier due to the migration of oxygen vacancies under the electric field is supposed to explain the two-step resistive switching process. The unique switching properties of the device, based on interfacial barrier engineering, could be exploited for novel applications in nonvolatile memory devices.     

Electrical transport and noise in semiconducting carbon nanotubes

We investigate electrical transport and noise in semiconducting carbon nanotubes. By studying carbon nanotube devices with various diameters and contact metals, we show that the ON-currents of CNFETs are governed by the heights of the Schottky barriers at the metal/nanotube interfaces. The current fluctuations are dominated by 1/f noise at low-frequencies and correlate with the number of transport carriers in the device regardless of contact metal.     

Deposition of SiOx barrier films by O2/TMDSO RF-PECVD

This paper reports that the SiOx barrier films are deposited on polyethylene terephthalate substrate by plasmaenhanced chemical vapour deposition （PECVD） for the application of transparent barrier packaging. The variations of 02/Tetramethyldisiloxane （TMDSO） ratio and input power in radio frequency （RF） plasma are carried out to optimize barrier properties of the SiOx coated film. The properties of the coatings are characterized by Fourier transform infrared, water vapour transmission rate （WVTR）, oxygen transmission rate （OTR）, and atomic force microscopy analysers. It is found that the 02/TMDSO ratio exceeding 2：1 and the input power over 200 W yield SiOx films with low carbon contents which can be good to the barrier （WVTR and OTR） properties of the SiOx coatings. Also, the film properties not only depend on oxygen concentration of the inlet gas mixtures and input power, but also relate to the surface morphology of the coating.     

氩气介质阻挡放电的发光特性

本文使用水电极介质阻挡放电装置,采用光学方法测量了氩气介质阻挡放电的发光特性。发现在驱动电压处于一定的范围内时,放电处于丝极模式,在驱动电压的每半周期内,无论是放电的总光还是单个微通道的放电发光均只有一次脉冲,单个微放电的时间为2μs,而总放电时间为2.4μs,这表明在氩气的丝极模式中,各单丝产生与熄灭的时间极其接近,各个放电丝之间有着很好的时间相关性。最后将本文的结果与空气中介质阻挡放电丝极模式的发光特性相比较,空气放电在每半周内的总光信号由多个脉冲组成,而每一个脉冲对应多个放电丝,因而氩气中各个放电微通道之间的时间相关性远强于空气的情况。     

Electroluminescence efficiency in bilayer organic light-emitting devices with LiF/Al cathode

An analytical model to calculate electroluminescence (EL) efficiency of bilayer organic light-emitting devices, considering the influence of introducing LiF insulating buffer layer at metal/organic interface on the barrier height for electron injection, was presented. The relations of EL efficiency versus the applied voltage and injection barrier or internal interfacial barrier or the thickness of organic layer were discussed. The results indicate that: (1) when δ e/δ h < 2, metal/organic (M/O) interface is ohmic contact; when δ e/δ h > 2, M/O becomes contact limited; and when δ e/δ h = 2 (Φ h ～ 0.2 eV, Φ e ～ 0.3 eV), there is a transition from ohmic contact to contact limited; (2) η EL decreases with the increase of δ′e / δ′h; however, when δ′e / δ′h > 2.5 (H ′h～ 0.2 eV, H ′e～ 0.4 eV), the changes of η EL are very small, which shows that η EL is dominated by the carrier’s injection; (3) when increasing Lh/L, η R has a descending trend at low voltage and a rising one at higher voltage. For a given Lh/L, η EL first increases and then decreases with the increasing applied voltage, and as Lh/L further increases, the variation tendency of η EL is more obvious. These conclusions are in agreement with the reported theoretic and experimental results.     

中等pd值介质阻挡放电中等离子体温度研究

近大气压条件下,在介质阻挡放电系统中得到了氩气和空气混合气体在300～800 nm范围内的发射光谱,研究了中等pd值(约6.4×103 Pa·cm) 氩气和空气混合气体中电子激发温度与分子振动温度。实验选用两条ArⅠ谱线763.51 nm(2P₆→1S₅)与772.42 nm(2P₂→1S₃),用强度对比法测量电子激发温度,利用氮分子第二正带系(C 3Π_u→B 3Π_g)计算氮分子振动温度。实验结果表明：电子激发温度和分子振动温度均随电压的增加而增加,并且电子激发温度随电压的变化速率大于分子振动温度的变化速率。     

Ultrasonic emulsification of parenteral valproic acid-loaded nanoemulsion with response surface methodology and evaluation of its stability

Response surface methodology (RSM) was used to optimize the formulation of a nanoemulsion for central delivery following parenteral administration. A mixture of medium-chain triglyceride (MCT) and safflower seed oil (SSO) was determined as a sole phase from the emulsification properties. Similarly, a natural surfactant (lecithin) and non-ionic surfactant (Tween 80) (ratio 1:2) were used in the formulation. A central composite design (CCD) with three-factor at five-levels was used to optimize the processing method of high energy ultrasonicator. Effects of pre-sonication ultrasonic intensity (A), sonication time (B), and temperature (C) were studied on the preparation of nanoemulsion loaded with valproic acid. Influence of the aforementioned specifically the effects of the ultrasonic processing parameters on droplet size and polydispersity index were investigated. From the analysis, it was found that the interaction between ultrasonic intensity and sonication time was the most influential factor on the droplet size of nanoemulsion formulated. Ultrasonic intensity (A) significantly affects the polydispersity index value. With this optimization method, a favorable droplet size of a nanoemulsion with reasonable polydispersity index was able to be formulated within a short sonication time. A valproic acid loaded nanoemulsion can be obtained with 60% power intensity for 15 min at 60 °C. Droplet size of 43.21 ± 0.11 nm with polydispersity index of 0.211 were produced. The drug content was then increased to 1.5%. Stability study of nanoemulsion containing 1.5% of valproic acid had a good stability as there are no significant changes in physicochemical aspects such as droplet size and polydispersity index. With the characteristisation study of pH, viscosity, transmission electron microscope (TEM) and stability assessment study the formulated nanoemulsion has the potential to penetrate blood–brain barrier in the treatment of epilepsy.     

光谱学方法研究介质阻挡沿面放电辉光模式的电场分布

利用介质阻挡沿面放电装置,在低气压空气中实现了辉光放电模式。利用光电倍增管对放电发光信号进行检测,发现外加电压每半周期出现一个发光脉冲,并且正负半周期的光脉冲是不对称的。利用Photoshop软件处理放电的照片,研究发现平行于高压电极不同位置的发光强度基本相同,然而距离高压电极越远,发光强度减小。放电中总电场由外加电场和电介质积累的壁电荷电场共同决定,确定该电场具有重要意义。通过分析放电的发射光谱中N+₂(B 2Σ+_u→X 2Σ+_g)谱线391.4 nm和N₂的第二正带系(C 3Π_u→B 3Π_g)谱线337.1 nm的比值,可以定性地说明电场的分布。研究发现电场在高压电极附近较大而远离高压电极处较小。这些研究结果对沿面放电的数值模拟和工业应用具有重要的价值。     

基于扩散势能和自由体积的自扩散系数模型

在考虑自由体积和局部临界扩散势能的基础上,提出一种新的计算自扩散系数模型,并给出新模型中各个因子物理含义．同时还提出一种计算局部临界扩散势能的新方法,并应用于新模型．另外将衍生van der Waals状态方程应用于求解自由体积,式中所需径向分布函数由Morsali-Goharshadi方程得到．在相同条件下,新模型比原自由体积模型更准确．