Synthesis and electrochemical properties of Zn3V3O8 as novel anode material

Zn₃V₃O₈ two-dimensional micro sheets are successfully synthesized by combination of solvothermal method and heat treatment. The Zn₃V₃O₈ has better electrochemical performances after calcinations.     

Organic fuelled flames in selective ionization detectors for chromatography

Summary The selectivities of two flame-based ionization detectors identified as a Remote FID (RFID) and a Flame Thermionic Ionization Detector (FTID) have been improved by introducing methane as a fuel for the flame. Both the RFID and FTID feature a detector struture in which the ionization polarizer and collector are located several centimeters downstream of an oxygen-rich flame, rather than immediately adjacent to the flame as in a flame ionization detector. The RFID detects long-lived negative ions produced in the flame by the combustion of lead, tin, phosphorus, or silicon compounds. The FTID re-ionizes and detects neutral electronegative products generated by combustion of nitrogen, halogen, or phosphorus compounds. An organic-fuelled RFID can detect 1 pg Pb (Sn, P)/sec with a selectivity of the order of 10⁶ versus hydrocarbons. An organic fuelled FTID is applicable to detection of compounds at nanogram and higher levels. FTID selectivity for PCB compounds in a transformer oil matrix is of the order of 10⁵1. The improved selectivity achieved by using an organic-fuelled flame is also applicable to the detection of phospholipid and other non-volatile N, P, or Cl compounds using an FID/FTID detector accessory for a TLC/FID analyser.     

Determination of partition behavior of organic surrogates between paperboard packaging materials and air

The suitability of recycled paperboard packaging materials for direct food contact applications is a major area of investigation. Chemical contaminants (surrogates) partitioning between recycled paper packaging and foods may affect the safety and health of the consumer. The partition behavior of all possible organic compounds between cardboards and individual foodstuffs is difficult and too time consuming for being fully investigated. Therefore it may be more efficient to determine these partition coefficients indirectly through experimental determination of the partitioning behavior between cardboard samples and air. In this work, the behavior of organic pollutants present in a set of two paper and board samples intended to be in contact with foods was studied. Adsorption isotherms have been plotted and partition coefficients between paper and air have been calculated as a basis for the estimation of their migration potential into food. Values of partition coefficients (Kpaper/air) from 47 to 1207 were obtained at different temperatures. For the less volatile surrogates such as dibutyl phthalate and methyl stearate higher Kpaper/air values were obtained. The adsorption curves showed that the more volatile substances are partitioning mainly in air phase and increasing the temperature from 70 to 100 degrees C their concentrations in air (Cair) have almost doubled. The analysis of surrogates was performed with a method based on solvent extraction and gas chromatographic-flame ionization detection (GC-FID) quantification.     

Determination of polar organic compounds by potentiometry at an anodically pretreated nickel oxide electrode

The open-circuit potential drop of an oxidatively pretreated nickel electrode in 0.1 M NaOH was used to develop a technique for the determination of alcohols, amino acids, carbohydrates, etc., in aqueous solution. The electrode pretreatment consisted of the formation of nickel hydrated oxides on the electrode surface with an oxidation state > 2. Both electrochemical and chemical pre-oxidation of the electrode surface were examined. The analytical signal was the enhancement of the potential drop corresponding to analyte concentration. The analytical signal was linearly related to the logarithm of the analyte concentration. The limits of determination ranged from 1 mM for low-molecular-weight to 0.02 mM for alkyl polyether alcohols. The flow-injection technique allows convenient pretreatment and direct observation of the analytical signal. Interferences from chloride and calcium can be readily eliminated by excluding them during electrode pretreatment. Potentiometric measurements were correlated with amperometric anodic responses at the nickel oxide electrode, allowing an unusual direct comparison of the two methods.     

Preparation and application of cryptand-coated piezoelectric crystal gas-chromatographic detector

A re-usable and sensitive cryptand-22-coated quartz-crystal membrane piezoelectric sensor with a homemade computer interface for signal acquisition and data processing was prepared and applied as a gas-chromatographic (GC) detector for various organic molecules. The oscillating frequency of the quartz crystal decreased due to the adsorption of organic molecules on cryptand-22. Effects of functional group, molar mass, steric hindrance and polarity of organic molecules on frequency responses of the cryptand-coated piezoelectric crystal detector were investigated. The cryptand-coated piezoelectric crystal GC detector had demonstrated high sensitivity for various polar organic molecules and good reproducibility when re-used. The frequency responses of the cryptand-coated crystal for various molecules were in the following order: carboxylic acids (RCOOH)primary amines (R-NH₂)>alcohols (ROH)>secondary amines (R₂NH)>tertiary amines (R₃N)>ketones. More polar molecules exhibited better frequency responses. The effect of temperature and amount of coating on the frequency responses of cryptand-coated crystal GC detector were also investigated. The cryptand-coated piezoelectric crystal GC detector compared well with the commercial thermal conductivity detector (TCD).     

Using capillary electrophoresis for the determination of organic acids in Port wine

The simultaneous separation and determination of organic acids in several samples of white and red Port wines was performed by capillary zone electrophoresis using indirect UV detection with 2,6-pyridinedicarboxylic acid as a background electrolyte buffer. Operational parameters like migration time, temperature, voltage and capillary length were optimized. Sixteen samples of red wine and four samples of white wine were used to analyze for tartaric, malic, lactic, succinic and acetic acids using glyoxylic acid as the internal standard. The method is rapid, sensitive and quantitative, and time-consuming sample preparation, such as solid-phase extraction or liquid-liquid extraction procedure, is not required.     

氧弹燃烧灰化法测定有机物中磷

用氧弹燃烧法灰化有机物进行元素测定，操作简便，快速，无污染，该方法用于有机物中磷的分析，结果可靠。     

电极材料对NPB/Alq3有机电致发光器件性能的影响

采用不同材料作为有机电致发光器件(OELDs)的电极, 制备了基本结构为[阳极/NPB(40 nm)]/Alq3(50 nm)/阴极]的异质结双层器件, 并通过改变OELDs器件的阴极或阳极来研究电极材料对器件光电性能的影响. 研究结果表明, 各器件电流-电压(I-V)关系的基本特征与陷阱电荷限制电流(TCLC)机制的拟合情况相符. 由于有机材料本身能级的无序性以及载流子迁移率对温度和电场的依赖性, 不同电极的载流子注入能力与其功函数并无直接关系. 双层器件中由于空穴传输层的引入, 使得载流子复合区域位于有机层异质结界面处, 降低了金属阴极对激子的猝灭作用, 从而大大提高了器件性能. 此外, 金属电极OLEDs器件结构具有的微腔效应会导致发射光谱的位移和谱峰宽度变窄, 这表明通过对金属电极的表面改性和优化可使器件性能超过常规结构的器件.     

双(6-溴代-9-乙基-咔唑-3-基)甲苯基碘盐的合成

双(9-乙基-咔唑-3-基)甲苯基碘盐是一种性能优良的有机光电导体增感剂.本文合成了双(6-溴代-9-乙基-咔唑-3-基)甲苯基碘盐,其分子结构通过红外、核磁、质谱和元素分析得到证实.初步实验表明该染料具有较宽范围的光谱响应,与聚 N-乙烯基咔唑(简称 PVK)相配合具有优良的光敏性能.     

Simultaneous extraction of organotin, organolead and organomercury species from soils and litter

Extracting organotin compounds (OTC) from soils is difficult due to the high cation exchange and complexation capacity of soils, and little information about OTC in soils is available. In this study, a new extraction method, combining 1 M CaCl₂, 0.1% tropolone, and glacial acetic acid was developed. Recoveries of mono-substituted OTC from spiked plant litter, and soil samples were improved substantially to 40% compared to classical glacial acetic acid extraction commonly used in sedimentology, yielding <10% recovery in C-rich soil samples. Simultaneously, the recovery of other OTC, trimethyllead and monomethylmercury was satisfactory. The recoveries of most species from the spiked litter, upland and wetland soils exceeded 70%. The new method extracted much more organometallics from unspiked organic soils and litter than microwave- and ultrasound-assisted extraction and accelerated solvent extraction, most likely due to exchange of organometallics from the solid phase by Ca²⁺. The method is simple, highly efficient and with low contamination. Together with GC-ICP-mass spectrometry, the method allows the detection of these organometallics in the pg g⁻¹ range and it is particularly suitable for soil and plant materials with low organometallics contents.