Determination of polar organic compounds by potentiometry at an anodically pretreated nickel oxide electrode

The open-circuit potential drop of an oxidatively pretreated nickel electrode in 0.1 M NaOH was used to develop a technique for the determination of alcohols, amino acids, carbohydrates, etc., in aqueous solution. The electrode pretreatment consisted of the formation of nickel hydrated oxides on the electrode surface with an oxidation state > 2. Both electrochemical and chemical pre-oxidation of the electrode surface were examined. The analytical signal was the enhancement of the potential drop corresponding to analyte concentration. The analytical signal was linearly related to the logarithm of the analyte concentration. The limits of determination ranged from 1 mM for low-molecular-weight to 0.02 mM for alkyl polyether alcohols. The flow-injection technique allows convenient pretreatment and direct observation of the analytical signal. Interferences from chloride and calcium can be readily eliminated by excluding them during electrode pretreatment. Potentiometric measurements were correlated with amperometric anodic responses at the nickel oxide electrode, allowing an unusual direct comparison of the two methods.     

Preparation and application of cryptand-coated piezoelectric crystal gas-chromatographic detector

A re-usable and sensitive cryptand-22-coated quartz-crystal membrane piezoelectric sensor with a homemade computer interface for signal acquisition and data processing was prepared and applied as a gas-chromatographic (GC) detector for various organic molecules. The oscillating frequency of the quartz crystal decreased due to the adsorption of organic molecules on cryptand-22. Effects of functional group, molar mass, steric hindrance and polarity of organic molecules on frequency responses of the cryptand-coated piezoelectric crystal detector were investigated. The cryptand-coated piezoelectric crystal GC detector had demonstrated high sensitivity for various polar organic molecules and good reproducibility when re-used. The frequency responses of the cryptand-coated crystal for various molecules were in the following order: carboxylic acids (RCOOH)primary amines (R-NH₂)>alcohols (ROH)>secondary amines (R₂NH)>tertiary amines (R₃N)>ketones. More polar molecules exhibited better frequency responses. The effect of temperature and amount of coating on the frequency responses of cryptand-coated crystal GC detector were also investigated. The cryptand-coated piezoelectric crystal GC detector compared well with the commercial thermal conductivity detector (TCD).     

氧弹燃烧灰化法测定有机物中磷

用氧弹燃烧法灰化有机物进行元素测定，操作简便，快速，无污染，该方法用于有机物中磷的分析，结果可靠。     

双(6-溴代-9-乙基-咔唑-3-基)甲苯基碘盐的合成

双(9-乙基-咔唑-3-基)甲苯基碘盐是一种性能优良的有机光电导体增感剂.本文合成了双(6-溴代-9-乙基-咔唑-3-基)甲苯基碘盐,其分子结构通过红外、核磁、质谱和元素分析得到证实.初步实验表明该染料具有较宽范围的光谱响应,与聚 N-乙烯基咔唑(简称 PVK)相配合具有优良的光敏性能.     

Simultaneous extraction of organotin, organolead and organomercury species from soils and litter

Extracting organotin compounds (OTC) from soils is difficult due to the high cation exchange and complexation capacity of soils, and little information about OTC in soils is available. In this study, a new extraction method, combining 1 M CaCl₂, 0.1% tropolone, and glacial acetic acid was developed. Recoveries of mono-substituted OTC from spiked plant litter, and soil samples were improved substantially to 40% compared to classical glacial acetic acid extraction commonly used in sedimentology, yielding <10% recovery in C-rich soil samples. Simultaneously, the recovery of other OTC, trimethyllead and monomethylmercury was satisfactory. The recoveries of most species from the spiked litter, upland and wetland soils exceeded 70%. The new method extracted much more organometallics from unspiked organic soils and litter than microwave- and ultrasound-assisted extraction and accelerated solvent extraction, most likely due to exchange of organometallics from the solid phase by Ca²⁺. The method is simple, highly efficient and with low contamination. Together with GC-ICP-mass spectrometry, the method allows the detection of these organometallics in the pg g⁻¹ range and it is particularly suitable for soil and plant materials with low organometallics contents.     

Analysis of organic acids in wines by Fourier-transform infrared spectroscopy

Fourier-transform infrared (FTIR) spectroscopy has been a major point of development in many wine laboratories in recent years. It enables almost instant analysis of several properties of wine, usually with very good precision and accurate results. Nevertheless, validation procedures should not be forgotten and should be fully performed. Recovery experiments were performed by spiking wine samples with different amounts of organic acids (tartaric, malic, lactic, acetic and citric—the most prominent in wines). After FTIR analysis of the total acidity and of each organic acid concentration, recoveries were calculated. For total acidity recovery results were, in general, good and very close to 100% (64–111%). On the other hand, for individual organic acid concentrations, the recovery results were lower than 100% (11–73%) for all spiking additions. These results could be explained by spectroscopic interferences between the organic acids. Because they have similar infrared spectra, it is not easy to distinguish between them and, therefore, to achieve accurate calibration. When total acidity, with a different infrared spectrum from the other abundant compounds in the wine, was taken as a single property the recovery results were acceptable.     

Organic acid solutions in the chromatography of inorganic ions VIII. Cation-exchange of Mn(II), Cd(II), Co(II), Ni(II), Zn(II), Cu(II), Fe(III), Sc(III), Y(III), Eu(III), Dy(III), Ho(III), Yb(III), Ti(IV) and Nb(V) in malate media

Summary The cation-exchange behaviour of Mn(II), Cd(II), Co(II), Ni(II), Zn(II), Cu(II), Fe(III), Sc(III), Y(III), Eu(III), Dy(III), Ho(III), Yb(III), Ti(IV) and Nb(V) in malate media at various concentrations and pH, was studied with Dowex 50 WX8 resin (200–400 mesh) in the ammonium form. Separation of Fe(III)/Cu(II), Fe(III)/Cu(II)/Zn(II), Fe(III)/Co(II)/Mn(II), Cu(II)/Ni(II)/Mn(II), Fe(III)/Cu(II)/Co(II)/Mn(II), Fe(III)/Cu(II)/Ni(II)/Cd(II), Yb(III)/Eu(III), Sc(III)/Y(III),Sc(III)/Yb(III)/Dy(III) and Nb(V)/Yb(III)/Ho(III) has been achieved, among others.This work was supported by C.N.R. of Italy.     

Robust interface on ENR-50/TiO2 nanohybrid material based sol-gel technique: Insights into synthesis,characterization and applications in optical

In this work, the sol–gel technique was used to prepare a new organic–inorganic hybrid from Epoxidized Natural Rubber (ENR-50) and Titanium dioxide (TiO₂) by blending different content of titania precursors (10, 30, and 50 wt%) with an ENR-50 matrix. A wide range of analyses was conducted to understand the nature of this hybrid and also to evaluate its potential uses in applications required high refractive index such as micro optical and optoelectronic devices. Results indicated that the ring-opening reaction of epoxide groups in ENR-50 increased with the increase of titania content in the hybrid resulting a strong bonding between titania and ENR-50 through TiOC bond, which was observed in FTIR spectrum at 1027–1028 cm⁻¹. It is also observed a slight decrease in the intensity of the amorphous peak along with a new crystalline peak appeared at 2θ = 23 and 27° due to the crystalline nature of titania. The hybrids showed three thermal degradation steps in the range of temperature 76 to 769 °C due to the existence of the Ti moieties with the mixture of polymer chains, which in turn shifted the T_g at 24.3, 26.9 and 28.1 °C for the hybrid at 10, 30, and 50 wt% TiO₂ compared to the T_g of ENR-50 at −18.4 °C respectively. The morphology of the ENR-50 showed clear changes during of the synthesis of ENR-50/TiO₂ hybrids, these changes were proven by SEM, TEM, and AFM analyses. Uv–Vis results showed that the higher wavelength peak at 293 nm has shifted to 296, 298 and 300 nm for the hybrid at 10, 30, and 50 wt% TiO₂ respectively due to the strong interaction between titania precursors and ENR-50 matrix. Furthermore, the hybrids showed good optical transparency in the visible light range.     

速差动力学分析及其应用进展

速差动力学分析是不经分离同时或连续测定混合物中性质密切相关的多组份的重要方法。本文综述了该法在１９８９－１９９２年间国内外新进展，尤着重其在有机，生物混合物中多组份分析的应用及新的计算方法，化学计量学的引入。引用最新文献６７篇。