Towards the synthesis of MAX-phase functional coatings by pulsed laser deposition

Pulsed laser deposition with a Nd:YAG laser was used to grow thin films from a pre-synthesized Ti₃SiC₂ MAX-phase formulated ablation target on oxidized Si(1 0 0) and MgO(1 0 0) substrates. The depositions were carried out in a substrate temperature range from 300 to 900 K, and the pressure in the deposition chamber ranged from vacuum (10⁻⁵ Pa) to 0.05 Pa Argon background pressure. The properties of the films have been investigated by Rutherford backscattering spectrometry for film thickness and stoichiometric composition and X-ray diffraction for the crystallinity of the films. The silicon content of the films varied with the energy density of the laser beam. To suppress especially the silicon re-sputtering from the substrate, the energy of the incoming particles must be below a threshold of 20 eV. Therefore, the energy density of the laser beam must not be too high. At constant deposition energy density the film thickness depends strongly on the background pressure. The X-ray diffraction measurements show patterns that are typical of amorphous films, i.e. no Ti₃SiC₂ related reflections were found. Only a very weak TiC(2 0 0) reflection was seen, indicating the presence of a small amount of crystalline TiC.     

经纬仪二轴正交调整方法

本文叙述了经纬仪二轴正交调整的四种方法,其中对偏反射镜法作了理论分析。     

Linear calibration procedure for the phase-to-height relationship in phase measurement profilometry

Calibration of the relationship between height and phase is of uttermost importance to perform accurate 3D measurements in phase measurement profilometry. This work reports a different approach to this problem by first looking at the analytical expression for this relationship and determining the regime spanned by the fringe analysis method. The conclusions thus ascertained, amply justify confronting the analytical expression with a simple normalization procedure of the experimental data, with a remarkable matching between both results. In light of this, a linear calibration procedure with just one plane is proposed and verified experimentally.     

The hydrogen molecule in an arbitrarily oriented magnetic field

Summary The modifications induced by a magnetic field of arbitrary direction and intermediate strength (i.e not larger than 2.35·10⁵ tesla, the ?atomic tesla?) on the lowest singlet and triplet energy states of the hydrogen molecule are studied. Using a linear combination of products of field-modified atomic orbitals, it is found that increasing the field strength the depth of the singlet energy well increases and the equilibrium internuclear distance decreases, yielding more rigid and localized nuclear vibrations. For sufficiently strong fields perpendicular to the internuclear axis, the triplet state exhibits a bonding behaviour. An explanation of the above results is given in terms of the field-modified electronic-charge distributions in the internuclear region. Based on the thesis submitted by S. Basile to the University of Palermo for graduation in Physics.     

500.8 nmNd∶YAG青光激光器光学薄膜的设计与制备

从双波长激光运转及和频的机理出发，对LD泵浦Nd∶YAG，LBO腔内和频500.8 nm〖JP2〗青光激光器所使用的光学薄膜进行了设计和制备.在激光反射镜的设计上，为了达到最佳的和频输出，对膜系要求进行了深入分析.采用对谐振腔一端面反射率固定不变并通过对另一腔镜基频光的透射率进行调谐的方法, 在给出合理初始结构后，利用计算机对膜厚进行了优化.并采用双离子束溅射沉积的方法，通过时间监控膜厚法成功制备出青光激光器所使用的全介质激光反射膜, 在室温下实现946 nm和1064 nm双波长连续运转，并通过Ⅰ类临界相位匹配LBO晶体腔内和频在国内首次实现500.8 nm青色激光连续输出.当泵浦注入功率为1.4 W时和频青光最大输出达20 mW.     

Study of the structural and optical properties of GaN/AlN quantum dot superlattices

We study GaN/AlN Quantum Dot (QD) superlattices utilizing the STREL environment which allows the building of atomistic models, relaxation of the structures, the calculation of the electronic states and optical transitions and the visualization of the results. The forces are calculated using an appropriate Keating or Stillinger–Weber interatomic potential model and the electronic states and optical transitions using a tight-binding formulation which is economical and produces realistic electronic properties. The relaxed structure has strains mainly in the GaN region which are compressive and small tensile strains in the AlN region, mainly below the QD. In the calculation of the electronic states and of the optical transitions the strains are included realistically at the atomistic level. The study of the wavefunctions close to the fundamental gap show how these strains influence the form and spatial extent of the wavefunction. Very close to the fundamental gap the valence and some conduction states are confined in the QD and have considerable oscillator strength.     

Electrolytical production of Ni + Mo + Si composite coatings with enhanced content of Si

Ni + Mo + Si composite coatings were prepared by co-deposition of nickel with molybdenum and silicon powders from a nickel solution in which Mo and Si particles were suspended by stirring. The layers have been deposited on a carbon steel substrate (St3S) under galvanostatic conditions. The content of Si in deposited layers was about 2-5 wt.% depending on deposition current density and the value of electric charge. For comparison Ni + Mo composite coatings were obtained under analogous current conditions. Composite coatings of enhanced Si content (15 wt.%) were deposited from an electrolyte in which 40 g/dm³ of Si covered with electroless plated nickel was dispersed. Deposition current density was equal 0.1 A/cm² and the value of electric charge Q = 500 C/cm². The thickness of the coatings was about 100-300 μm depending on their kind, electric charge and the deposition current density. Surface and cross-section morphology were investigated by scanning electron microscope (SEM). All deposited coatings are characterized by great, developed surface area. No internal stresses causing their cracking were observed. Chemical composition of the layers was determined by X-ray fluorescence spectroscopy (XRF) method and quantitative X-ray analysis (QXRD). It was stated, that the content of molybdenum and silicon in Ni + Mo + Si coatings depends on deposition current density and the amount of the powder in bath. The results of structural investigation of the obtained layers by the X-ray diffraction (XRD) method show, that they consist in crystalline Mo or Mo and Si phases built into Ni matrix. Moreover, Ni + Mo + Si composite coatings were modified by thermal treatment. It has been found that the thermal treatment of Ni + Mo + Si composite coatings caused that the new phases (NiSi, Mo₂Ni₃Si and Ni₆Mo₆C_1.06) were obtained.     

Optical spectroscopy of Yb/Er codoped NaY(WO4)2 crystal

Erbium and ytterbium codoped double tungstates NaY(WO₄)₂ crystals were prepared by using Czochralski (CZ) pulling method. The absorption spectra in the region 290-2000 nm have been recorded at room temperature. The Judd-Ofelt theory was applied to the measured values of absorption line strengths to evaluate the spontaneous emission probabilities and stimulated emission cross sections of Er³⁺ ions in NaY(WO₄)₂ crystals. Intensive green and red lights were measured when the sample were pumped by a 974 nm laser diode (LD), especially, the intensities of green upconversion luminescence are very strong. The mechanism of energy transfer from Yb³⁺ to Er³⁺ ions was analyzed. Energy transfer and nonradiative relaxation played an important role in the upconversion process. Photoexcited luminescence experiments are also fulfilled to help analyzing the transit processes of the energy levels.     

The origin of the formation of cavities in galvanized coatings

The role of water‐soluble corrosion products on galvanized wires was examined. The samples used were industrial hot‐dip galvanized wires, which were exposed to the open air under all weather conditions for a relatively short time (6 and 12 months), in an urban environment close to the sea. The samples were studied by different methods, i.e. scanning electron microscopy (SEM), transmission electron microscopy (TEM), X‐ray diffraction (XRD) and optical microscopy (OM). Several phases were detected because of the galvanization procedure and the steel substrate. Furthermore, phases which were formed as a result of the reaction of zinc with the atmosphere were also detected. These were oxides like ZnO, carbonates like ZnCO₃ and hydrated Zn and Fe sulfates. Their presence influences the corrosion resistance of the wires, which finally, strongly depends on the solubility of the wires in water. The SO₄^2? compounds especially are very soluble and consequently are easily removed from the coating surface, leading to its degradation by the formation of cavities. In any case, their presence, even after a short period of exposure, implies that the coating is highly affected by the atmosphere of the modern city. Copyright © 2006 John Wiley & Sons, Ltd.     

A new technique for fluid velocimetry based on near field scattering

We show that the time evolution of near-field scattering speckles, originated by a fluid suspension of particles, provides information about the velocity field in the fluid. This information can be extracted from a statistical analysis of speckle fields taken at different times, either by measuring their cross-correlation function or by recovering the power spectrum corresponding to the difference between the two speckle fields. Experimental data are in accordance to the expected behaviors. The results are independent of the scatterer's size, allowing one to exploit the technique also with sub-wavelength tracking particles.