Isolation of lysozyme from hen egg albumen using glass fiber-based cation-exchange membranes

In this study, porous glass fiber membranes were coated with monophenyl trimethoxysilane (MPh) and then sulphonated by chlorosulphonic acid to prepare the cation-exchange membranes with sulphonic acid groups. Different MPh-coating times were tested and the properties of the resulting membranes such as contact angle, FTIR spectrum, conductivity, and ion-exchange capacity were measured. It was found that the optimal MPh-coating time was 60 min and the related ion-exchange capacity was 49.5 μequiv./disc. The modified membrane under the optimal MPh-coating condition was adopted for lysozyme isolation. The results were compared with those for the commercial cation-exchange membrane with sulphonic acid groups (ICE 450 unsupported membrane). Although the prepared membrane exhibited less adsorption capacity than ICE 450 unsupported membrane in the batch lysozyme adsorption experiment, it showed lower non-specific binding ratio under higher salt concentration. In the flow process isolating lysozyme from hen egg albumen, the purification effectiveness obtained using the prepared cation-exchange membrane was superior to the ICE 450 unsupported membrane.     

活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

ZrO2纳米粉末复合羊毛纤维研究

ＺｒＯ_２纳米粉末复合羊毛纤维研究陈代荣，樊悦朋（山东大学化学系济南２５０１００）关键词ＺｒＯ_２纳米粉末，羊毛纤维，复合纤维由陶瓷粉末和天然纤维形成的复合纤维的强度、织品的保暖性、抗起球性及防缩性能等均有所提高，报道较多的是微米级陶瓷粉末（粒径０．５...     

碳纤维汞膜微电极1.5次微分伏安法测定米托蒽醌的研究

米托蒽醌（ＭＸＴ）能吸附在碳纤维汞膜微电极表面，阴极溶出时，产生一个灵敏的１．５次微分溶出峰，其峰电流和米托葱酿的浓度在１．０×１０－５ｍｏｌ／Ｌ～１．３×１０－９ｍｏｌ／Ｌ范围内具有良好的线性关系，经３ｍｉｎ的富集，检出限可达１．０×１０－１０ｍｏｌ／Ｌ，据此建立了测定ＭＸＴ的灵敏的新方法，本文讨论了实验条件，并对血样中的ＭＸＴ进行了测定。     

碳纤维微电极研究(Ⅺ)——利用温度效应测定电极反应的热力学和动力学参数

研究了温度对碳纤维微电极上伏安曲线的影响及温度与电极电位的关系,测定了电极反应的热力学参数.由电流与温度的关系测定了去极剂的扩散活化能E_(al)和D_o,利用微电极具有高速传质的特性,测定了常规电极上为可逆反应的电极反应标准速率常数(?),并通过(?)与温度的关系测定了电极反应的活化能.     

Effect of take-up speed on physical properties and permeation performance of cellulose acetate hollow fibers

Cellulose acetate (CA) ultrafiltration hollow fibers were spun via the dry-jet wet spinning technique. The effect of the take-up speed on the mechanical properties, morphology, thermal properties, pure water permeation, retention, and surface characterization of hollow fiber membranes were investigated. Both the inner and outer diameters of the hollow fiber decreased with the increase of take-up speed. Macrovoids were observed on the inner surface of the drawn hollow fibers. The d-space decreased with the increase of the take-up speed. The ultimate tensile stress (UTS) increased and the breaking elongation decreased with the increase of take-up speed. The permeation performance was measured. The hydraulic permeability increased and the retention decreased slightly with the increase of the take-up speed. The surface roughness increased with the increase of the take-up speed. The thermal analysis results showed that the endothermic peak shifts to the higher temperature region and coefficient of thermal expansion (CTE) decrease for a higher take-up speed.     

ξ-potential and surface dye-ability of poly(vinyl alcohol) fiber with different degree of formalization in a cationic dye solution

Summary The surface dyeability of the poly(vinyl alcohol) fiber with different degree of formalization was studied by measuring -potential of the fiber in alkaline aqueous solutions (pH 10) of a cationic dye Methylene Blue. With the increase in the dye concentration, the sign of the -potential of the fiber changed from negative to positive and thereafter the positive value approximated to saturated value, and the amount of dye adsorbed (expressed in mol/cm²-fiber) increased also. These results may possibly be attributed to the formation of the electrostatic bond between the fiber and the dye. The linear relations were found between and logC _d and its slope did not change with rise of temperature. The free energy of dyeing G (negative) calculated from the slope of the -logC _id curve, etc. increased with increasing the degree of formalization of the fiber. This fact corresponds to the increase in the surface dye adsorption with increasing the degree of formalization. With increasing the degree of formalization, the heat of dyeing H (negative) increased and the entropy of dyeing S (positive) decreased. The positive value of S for each fiber, suggests the formation of hydrophobic bond as a driving force to the dyeing of Methylene blue on the fiber surface in addition to the electrostatic bond.This paper is Part XXVII in a series on Studies on -potentials and Surface Dyeability of Natural and Synthetic Fibers in Dye Solution. Part XXVI: T. Suzawa andK. Kawakami, Nippon Kagaku Kaishi1975, No. 7,1134.     

表面起伏光栅形成速率的影响规律 Ⅰ.偶氮生色团种类和官能度的影响

设计并合成了含有不同生色团以及不同官能度的环氧树脂基偶氮高分子 ,系统研究了偶氮生色团的种类和官能度对光栅形成速率的影响规律 .实验结果表明 ,偶氮苯对位是羧基的聚合物的光栅形成速率明显快于偶氮苯对位是硝基的聚合物 ,光栅形成速率随偶氮生色团官能度的增加而加快 .这两类聚合物都可以形成规整的可擦式表面起伏光栅     

二氧化钛纤维表面担载Pt纳米结构的原子力显微镜研究

通过原子力显微镜研究了二氧化钛纤维表面担载Pt的表面形貌及其结构.结果表明,TiO2纤维表面担载的Pt具有微米尺度的近似六边形或者近似长方形的结构,与在单晶TiO2(110)表面的Pt纳米簇形貌相似,但尺度较大.TiO2纤维担载的Pt表面明显存在不同高度的台阶结构,台阶高度以2~4倍Pt(111)晶面面间距的高度为主.由Pt在TiO2纤维表面的形貌与纤维的纳米晶粒排布有序性推测可知,Pt与TiO2纤维存在强的相互作用,可能正是这种强相互作用和表面台阶结构才使TiO2表面担载的Pt虽是微米尺寸但仍具有高光催化活性.     

Racemic ofloxacin separation by supported-liquid membrane extraction with two organic phases

As the relation of chirality and activities of drugs is researched deeply, people become to re-alize the clinic importance of chirality. The different enantiomers of a drug can have vastly differ-ent pharmacological activities, pharmacokinetic processes and toxicity[1,2]. The most well-docu- mented example is that of the drug substance thalidomide. Bitter lessons and scientific research promote the interest in single-enantiomer drugs, so the potential of the chiral drug market is enormous[3]. …