镀液中Ce^3＋离子对锡镀层结构缺陷和可焊性的影响

应用荧光分析法、X光电子能谱法(XPS)及正电子湮没寿命谱法(PALS)等研究了从含硫酸铈添加剂的酸性光亮锡镀液获得的锡镀层结构缺陷与可焊性的关系。结果表明,电镀时Ce与Sn不发生共沉积,Ce~(3+)的主要作用是阻化Sn~(2+)的水解和氧化使镀液稳定,因而使锡镀层纯度提高、结构致密、表层氧含量减少,有利于提高镀层的可焊性。当Ce~(3+)浓度控制在3.5g/L左右时,可使镀层结构缺陷较少,可焊性较佳,说明结构缺陷是影响锡镀层可焊性的直接原因。     

流动注射在线共沉淀HG-AFS测定痕量铅

建立了流动注射在线共沉淀HG-AFS测定痕量铅的分析方法。方法基于铅在碱性介质中与氢氧化镁共沉淀，沉淀收集在锥形沉淀腔中，用HCl溶洗沉淀和NaBH4反应，产生的氢化物被载气引入原子化器中进行测定。测定铅的RSD为3％(5ng/mL，n=10)，检出限为0．01ng。检出限较直接进样降低了11倍。对国家标准物质中铅的测定结果与标准值相符。     

Comparative study of 8-hydroxyquinoline derivatives as chelating reagents for flow-injection preconcentration of cobalt in a knotted reactor

8-Hydroxyquinoline (HQ), 2-methyl-8-hydroxyquinoline (CH₃-HQ), 5,7-dichloro-2-methyl-8-hydroxyquinoline (Cl₂-CH₃-HQ), 5,7-dibromo-8-hydroxyquinoline (Br₂-HQ), 5-sulfo-7-iodo-8-hydroxyquinoline (ferron) and 5-sulfo-8-hydroxyquinoline (SO₃H-HQ) were compared as chelating reagents for on-line sorption preconcentration of cobalt in a knotted reactor (KR) precoated with the reagent. The results obtained with the different HQ derivatives reveal those properties of the chelating reagent responsible for the processes taking place in the KR. The influence of hydrophobicity, acidity, stability of the cobalt chelate and type of substituents in the HQ ring system on the separate steps of the flow injection (FI) preconcentration procedure are discussed. According to the performance characteristics of the different HQ derivatives, the most important parameters for on-line preconcentration in a KR are the hydrophobicity of the reagent and the stability of the chelate complex with the analyte.     

A New Technique of Synthesizing 10—Hydroxy—5—methyl—5,10—dihydrophenophosphazine 10—Oxide

10-Hydroxy-5-methyl-5,10-dihydrophenophosphazine 10-oxide(1)was prepared by a new technique of treating 10-methoxy-5,10-dihydrophenophosphazine 10-oxide(2)with an equivalent of NaH in anhydrous DMF,and then at 120℃ for 3-4h,which not only avoided poisonous and expensive methyl iodide used in literature,but made the consumption of NaH greatly decrease as well.The possible reaction mechanism was also described.The chemical structure of 1 was confiremed by IR,NMR,and mass spectroscopy.     

On-line SFE-GC for determination of PCBs in human milk and blood serum

On-line coupled supercritical fluid extraction and gas chromatography (SFE-GC) has been utilized for the determination of PCBs and other organochlorine compounds in human milk and blood serum. The procedure involved preconcentration of the sample on C₁₈-silica sorbent in an extraction cell: after precipitation of the proteins up to 20 ml of human milk was concentrated on 0.5 g of sorbent. Serum (up to 5 ml) was applied to the C₁₈ material without pretreatment. Basic alumina was utilized as a selective adsorbent for lipids in the on-line SFE-GC system. The method was used to analyze milk and serum spiked with 0.5 and 10 ng of Aroclor 1260 and the results compared with those obtained by liquid–liquid extraction of serum.     

On-line enzymatic reaction,extraction, and chromatography of fatty acids and triglycerides with supercritical carbon dioxide

Supercritical carbon dioxide can be utilized both as an introduction solvent in capillary SFC and as a reaction medium; both possibilities are illustrated in this study. An off-line SFE unit was modified for on-line SFE-SFC. To facilitate rapid depressurization of the extraction cell and to prevent memory effects, a 6-port valve was installed at the outlet line of the extraction unit. An increased background signal was obtained when PEEK polymer was used in the construction of the extraction vessel; when stainless steel was used, the blanks improved. The synthesis of methyl esters and butyl esters of fatty acids from triglycerides in edible fat was examined using an immobilized lipase as a catalyst in on-line SFE-SFC. As a result of 30 minutes reaction – extraction time, high yields of fatty acid esters were obtained at a pressure of 150 bar and a temperature of 50°C.     

Chemical removal of humic substances interfering with the on-line solid-phase extraction—Liquid chromatographic determination of polar water pollutants

Summary Different methods for removing interference by humic substances in the analysis of polar pollutants have been compared in the analysis of environmental water by solid-phase extraction (SPE) with a chemically modified polymeric resin coupled on-line to liquid chromatography with UV detection. The methods were based on the use of chemical reagents. The best method was found to be addition of sodium sulphite to humic-containing water before SPE. The appropriate amount of sulphite depends on the amount of humic substances dissolved in the sample—for analysis of 50 mL tap and Ebro river water, respectively, 250 μL and 500 μL 10 % Na₂SO₃ solution had to be added. In both cases, the recovery values after chemical treatment were similar to those when a Milli-Q-quality water standard was analysed.     

Selective flow injection analysis of ultra-trace amounts of Cr(VI), preconcentration of it by solvent extraction, and determination by electrothermal atomic absorption spectrometry (ETAAS)

A rapid, robust, sensitive and selective time-based flow injection (FI) on-line solvent extraction system interfaced with electrothermal atomic absorption spectrometry (ETAAS) is described for analyzing ultra-trace amounts of Cr(VI). The sample is initially mixed on-line with isobutyl methyl ketone (IBMK). The Cr(VI) is complexed by reaction with ammonium pyrrolidine dithiocarbamate (APDC), and the non-charged Cr(VI)–PDC chelate formed is extracted into IBMK in a knotted reactor made from PTFE tubing. The organic extractant is separated from the aqueous phase by a gravity phase separator with a small conical cavity and delivered into a collector tube, from which 55 μl organic concentrate is subsequently introduced via an air flow into the graphite tube of the ETAAS instrument. The operations of the FI-system and the ETAAS detector are synchronously coupled. A significant advantage of the approach is that matrix constituents, such as high salt contents, effectively are eliminated. The extraction procedure was optimized by a simplex approach. A central composite design was subsequently employed to verify the estimated operational optimum. An 18-fold enhancement in sensitivity of Cr(VI) was achieved after preconcentration for 99 s at a sample flow rate of 5.5 ml min⁻¹, as compared to direct introduction of 55 μl of sample, yielding a detection limit (3σ) of 3.3 ng l⁻¹. The sampling frequency was 24.2 samples h⁻¹. The proposed method was successfully evaluated by analyzing a NIST Cr(VI)-reference material, synthetic seawater and waste waters, and waste water samples from an incineration plant and a desulphurization plant, respectively.     

On-line preconcentration using dual mini-columns for the speciation of chromium(III) and chromium(VI) and its application to water samples as studied by inductively coupled plasma-atomic emission spectrometry

On-line preconcentration system for the selective, sensitive and simultaneous determination of chromium species was investigated. Dual mini-columns containing chelating resin were utilized for the speciation and preconcentration of Cr(III) and Cr(VI) in water samples. In this system, Cr(III) was collected on first column packed with iminodiacetate resin. Cr(VI) in the effluent from the first column was reduced to Cr(III), which was collected on the second column packed with iminodiacetate resin. Hydroxyammonium chloride was examined as a potential reducing agent for Cr(VI) to Cr(III).The effects of pH, sample flow rate, column length, and interfering ions on the recoveries of Cr(III) were carefully studied. Five millilitres of a sample solution was introduced into the system. The collected species were then sequentially washed by 1 M ammonium acetate, eluted by 2 M nitric acid and measured by ICP-AES. The detection limit for Cr(III) and Cr(VI) was 0.08 and 0.15 μg l⁻¹, respectively. The total analysis time was about 9.4 min.The developed method was successfully applied to the speciation of chromium in river, tap water and wastewater samples with satisfied results.