The mechanism of photoinsertion of haloalkenes into Fe---C bonds of dieneiron tricarbonyls

1,1-Dichloro-2,2-difluoroethylene (like other fluoroalkenes) and dieneiron tricarbonyls react photochemically to give products in which the haloalkene has inserted into the Fe---C(1) bond of the diene complex. The reaction is regiospecific with respect to both diene and haloalkene. The reaction is shown to occur by (a) photodissociation of a CO ligand from iron; (b) π-complexation of haloalkene; (c) π → σ ligand rearrangements accompanied by CO reattachment. The adducts undergo hydrolysis on silica gel chromatography, to give substituted 2-chlorocyclohexadienoneiron tricarbonyls.     

On-line sample preconcentration with chemical derivatization of bacterial biomarkers by capillary electrophoresis: a dual strategy for integrating sample pretreatment with chemical analysis

Simple, selective yet sensitive methods to quantify low-abundance bacterial biomarkers derived from complex samples are required in clinical, biological, and environmental applications. In this report, a new strategy to integrate sample pretreatment with chemical analysis is investigated using on-line preconcentration with chemical derivatization by CE and UV detection. Single-step enantioselective analysis of muramic acid (MA) and diaminopimelic acid (DAP) was achieved by CE via sample enrichment by dynamic pH junction with ortho-phthalaldehyde/N-acetyl-L-cysteine labeling directly in-capillary. The optimized method resulted in up to a 100-fold enhancement in concentration sensitivity compared to conventional off-line derivatization procedures. The method was also applied toward the detection of micromolar levels of MA and DAP excreted in the extracellular medium of Escherichia coli bacterial cell cultures. On-line preconcentration with chemical derivatization by CE represents a unique approach for conducting rapid, sensitive, and high-throughput analyses of other classes of amino acid and amino sugar metabolites with reduced sample handling, where the capillary functions simultaneously as a concentrator, microreactor, and chiral selector.     

在线固相萃取预富集-原子吸收联用测定痕量Fe(Ⅱ)和总铁量

以1,10-二氮菲(1,10-phen)为配合剂,乙醇为洗脱液,在C₁₈柱上将流动注射固相萃取预富集-原子吸收光谱联用测定痕量Fe(Ⅱ)和总铁.Fe(Ⅲ)的含量可通过抗坏血酸还原后用差示法测得.本法灵敏度高,选择性好,能在线分离干扰富集Fe(Ⅱ),采样速度80次/h,富集倍数19倍,检测下限为3μg/L,相对标准偏差1.1%(n=10),可用于测定水样中痕量Fe(Ⅱ)和Fe(Ⅲ),回收率为94%105%.     

Statistical fluctuation in zeta potential distribution of nanoliposomes measured by on‐chip microcapillary electrophoresis

The zeta potential of nanoliposomes with a diameter below 100 nm has been studied by the combined use of on‐chip microcapillary electrophoresis (μCE) and sensitive fluorescence imaging. Tracking the electrophoretic migration of individual nanoliposomes has enabled the accurate evaluation of the zeta potential distribution of nanoliposomes and the first observation of its abnormal broadening due to a statistical fluctuation phenomenon specific to the “nanoscale world.” The materials used for liposome preparation were phosphocholine as the neutral lipid, phosphatidylserine as the anionic lipid, and cholesterol. The size of the liposomes encapsulating calcein, a fluorescent dye used for imaging convenience, was tailored by extrusion through polycarbonate membrane filters of different pore sizes ranging from 50 to 1000 nm. The on‐chip μCE system comprised a μCE chip, a laser source, an inverted microscope, and an electron‐multiplying charge‐coupled device camera. The electrophoresis experiment using this system revealed that the relative standard deviation of the zeta potential distribution of nanoliposomes is inversely proportional to their diameter and apparently increases below 100 nm. This abnormal broadening of zeta potential distribution of nanoliposomes is explained by prominent discreteness effect of the number of anionic lipid molecules in nanoliposomes.     

On‐line two‐dimensional LC: A rapid and efficient method for the determination of enantiomeric excess in reaction mixtures

A novel LC‐based method for the determination of enantiomeric excess (ee) in a sample mixture has been developed by employing on‐line 2D LC. The orthogonal separation system is composed of an NH₂ column as the first dimension to elute the target chiral compound from the crude mixture and a chiral column as the second dimension to determine the ee of the target chiral product. A series of crude mixtures from asymmetric reactions have been directly analyzed without prepurification. Good reproducibility (intra‐ and interday precisions were all under 1.33%) and good accuracy (deviations from ee values determined by 1D HPLC were all <1.03%) have been obtained. Compared with the traditional method for the determination of ee, on‐line 2D HPLC can be used in real time and holds great potential in the time‐saving determination of ee in asymmetric synthesis.     

Evaluation of fritless solid‐phase extraction coupled on‐line with capillary electrophoresis‐mass spectrometry for the analysis of opioid peptides in cerebrospinal fluid

Fritless SPE on‐line coupled to CE with UV and MS detection (SPE‐CE‐UV and SPE‐CE‐MS) was evaluated for the analysis of opioid peptides. A microcartridge of 150 μm id was packed with a C₁₈ sorbent (particle size > 50 μm), which was retained between a short inlet capillary and a separation capillary (50 μm id). Several experimental parameters were optimized by SPE‐CE‐UV using solutions of dynorphin A (DynA), endomorphin 1 (End1), and methionine‐enkephaline (Met). A microcartridge length of 4 mm was selected, sample was loaded for 10 min at 930 mbar and the retained peptides were eluted with 67 nL of an acidic hydro‐organic solution. Using SPE‐CE‐MS, peak area and migration time repeatabilities for the three opioid peptides were 12–27% and 4–5%, respectively. SPE recovery was lower for the less hydrophobic DynA (22%) than for End1 (66%) and Met (78%) and linearity was satisfactory in all cases between 5 and 60 ng/mL. The LODs varied between 0.5 and 1.0 ng/mL which represent an enhancement of two orders of magnitude when compared with CE‐MS. Cerebrospinal fluid (CSF) samples spiked with the opioid peptides were analyzed to demonstrate the applicability to biological samples. Peak area and migration time repeatabilities were similar to the standard solutions and the opioid peptides could be detected down to 1.0 ng/mL.     

On‐Site Determination of Carbendazim,Cathecol and Hydroquinone in Tap Water Using a Homemade Batch Injection Analysis Cell for Screen Printed Electrodes

In this work, we present a simple homemade batch‐injection analysis cell for screen‐printed electrodes (BIA‐SPE). The potential of the proposed system for on‐site analysis was demonstrated by the determination of carbendazim, catechol, and hydroquinone in tap water. The system provided reduced injection volume (30 µL), high analytical frequency (≈200 h^?1) and low detection limits (nanomolar level). Moreover, the BIA‐SPE cell presented better stability (RSD≈0.4 %) than a conventional flow injection cell for SPE (RSD≈5.0 %) in organic media. The proposed homemade BIA‐SPE cell is very simple, inexpensive and can be easily constructed in any laboratory.     

Study of immobilized metal affinity chromatography sorbents for the analysis of peptides by on‐line solid‐phase extraction capillary electrophoresis‐mass spectrometry

Several commercial immobilized metal affinity chromatography sorbents were evaluated in this study for the analysis of two small peptide fragments of the amyloid β‐protein (Aβ) (Aβ(1–15) and Aβ(10–20) peptides) by on‐line immobilized metal affinity SPE‐CE (IMA‐SPE‐CE). The performance of a nickel metal ion (Ni(II)) sorbent based on nitrilotriacetic acid as a chelating agent was significantly better than two copper metal ion (Cu(II)) sorbents based on iminodiacetic acid. A BGE of 25 mM phosphate (pH 7.4) and an eluent of 50 mM imidazole (in BGE) yielded a 25‐fold and 5‐fold decrease in the LODs by IMA‐SPE‐CE‐UV for Aβ(1–15) and Aβ(10–20) peptides (0.1 and 0.5 μg/mL, respectively) with regard to CE‐UV (2.5 μg/mL for both peptides). The phosphate BGE was also used in IMA‐SPE‐CE‐MS, but the eluent needed to be substituted by a 0.5% HAc v/v solution. Under optimum preconcentration and detection conditions, reproducibility of peak areas and migration times was acceptable (23.2 and 12.0%RSD, respectively). The method was more sensitive for Aβ(10–20) peptide, which could be detected until 0.25 μg/mL. Linearity for Aβ(10–20) peptide was good in a narrow concentration range (0.25–2.5 μg/mL, R² = 0.93). Lastly, the potential of the optimized Ni(II)‐IMA‐SPE‐CE‐MS method for the analysis of amyloid peptides in biological fluids was evaluated by analyzing spiked plasma and serum samples.     

Large-volume sample on-line concentration of angiotensins in non-aqueous capillary electrophoresis

A single step on-line concentration and separation method for peptides in non-aqueous capillary electrophoresis was developed. ACN containing 50 mM tetraethylammonium perchlorate was used as the electrophoretic medium; angiotensins I-IV were separated as a result of the differences in the magnitudes of their interactions with perchlorate anions. When the sample solution (ACN containing 0.5% trifluoroacetic acid and angiotensins) was injected as a large-volume plug, the analytes were concentrated at the inlet end of the capillary by both sweeping and stacking mechanisms; the separation procedure then started automatically without any operations such as polarity change. It was found that the concentration of analytes, injection period, and concentration of tetraethylammonium perchlorate in the electrophoretic medium were important factors for both separation and concentration efficiencies. The angiotensins were concentrated and separated with the large-volume injection of up to 80% of the effective capillary length.