Low noise double pass L-band erbium-doped fiber amplifier

A new double pass long wavelength band erbium-doped fiber amplifier with enhanced noise figure characteristics is demonstrated. The noise figure is improved by about 2.6 dB with the incorporation of broadband conventional-band fiber Bragg grating (FBG) in between the two segments of erbium-doped fiber. By incorporating both the pre-amplifier and the FBG, the noise figure is further improved, which varies from 4.0 to 5.0 dB in the flat gain region from 1570 to 1600 nm. The gain varies from 32.0 to 33.4 dB within this region. The new amplifier with high gain and low noise figure can be useful as an inline amplifier in a wavelength division multiplexing transmission system.     

Approximate and Exact Small Signal Analysis for Single-Mode Fiber Near Zero Dispersion Wavelength with Higher Order Dispersion

This article presents the comparison of approximate and exact small-signal theories for analyzing the influence of the higher-order dispersion terms on dispersive optical communication systems operating near zero dispersion wavelength for linear single-mode fiber. For the approximate theory, the generalized conversion matrix has been reported and gives the transfer function of intensity and phase from the fiber input to fiber output for a laser source including the influence of any higher-order dispersion term. In addition, expressions for the small-signal frequency response and the relative intensity noise (RIN) response of an ultrafast laser diode including noises are derived. However, it is observed that the approximation assumed for the second-order dispersion term for the approximate analysis is not valid. From the approximate theory, the exact generalized conversion matrix and exact expressions for small-signal frequency response and relative intensity noise (RIN) are obtained. We show that for the exact theory, the second-order dispersion term has no effect on intensity and frequency response even at large modulating frequencies and large propagation distances contrary to the approximate theory as reported by other authors. But we show that third-order dispersion term certainly has some minute impact on the frequency and RIN response for long distance links at high modulating frequencies.     

低噪音摩阻复台材料影响因素的探讨

采用动态粘弹谱仪（ＤＤＶ）、电子扫描显微镜（ＳＥＭ）和摩擦试验机等对影响摩阻复合材料制动噪音的因素进行了探讨。结果表明，摩阻材料基体的合理改性以提高其损耗角正切ｔａｎδ对减少振动、降低噪音行之有效。同时对传统解决噪音的方法，如添加固体润滑剂、橡胶共混等进行了分析比较。     

受激喇曼散射在掺铒光纤放大器中的影响

本文在分析了均匀掺杂分布式光纤放大器（d－EDFA）的基础上，提出了沿传输方向掺杂浓度单调下降（单变），和降升结合（两变）的两种渐变型分布式光纤放大器，并用传输方程研究了透明传输和最佳掺杂浓度下，受激喇曼散射对均匀、单变和两变型三种d－EDFA的各种特性的影响．     

A study of noise in CNG driven modes of transport in Delhi

Measurements of noise and its spectral characteristics were made inside various types of transport running on Compressed Natural Gas (CNG) fuel in Delhi. Noise indices L₁₀, L₅₀, L₉₀ and L_eq were estimated from the measured noise levels for vehicles in neutral gear, slow speed (speed ?20 km/h) and under free flow (speed ?30 km/h) conditions. It is found that background levels, when averaged over all speeds, are maximum in Rural Transport Vehicles (RTV) followed by Buses, Auto-rickshaws and Taxis. With increase in the speed, noise levels are appreciably enhanced except in the case of auto-rickshaws where the increase is moderate. The spectral distributions of noise inside vehicles obtained at 1-octave band frequencies, show a rather similar nature. The study reveals significantly lower noise levels inside CNG driven public modes of transport compared to those found in an earlier survey inside diesel and petrol driven vehicles.     

Performance of noise barriers with various edge shapes and acoustical conditions

The performances of barriers having different shapes and surface conditions were tested using the boundary element method in a well-controlled environment. The heights and widths of the barriers were standardized and the insertion losses for six receiver positions were averaged and compared. Figures displaying the results allow for straightforward barrier performance estimation. It was shown that absorbing and soft edges significantly improve the efficiency of the barrier, but configuration modifications provide only a slight improvement. The soft T-shaped barrier produces the highest performance. A 3 m high T-shaped barrier provides the same performance as a 10 m high plain barrier. The spectral efficiency was also investigated. The insertion loss spectra for the absorbing and the soft barriers exhibit a similar shape, but the rigid barrier differs from these two.     

In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

突体剖面线型的流噪声机理分析和试验研究

本文在分析突体马蹄涡和湍流脉动压力特性的基础上，在中国船舶科学研究中心０３Ｂ水筒，试验比较了不同剖面线型的突体模型流动噪声，降噪效果３－５ｄＢ，提出了突体部面低噪声设计的实验依据和具体方法。     

用碘酸钾滴定法标定二氧化硫标准溶液

用KIO3滴定法标定SO2标准溶液,RSD≈0.10%,标定结果与标准法结果无显著性差异,相对误差<±0.3%。     

Hydrogen Oxidation on a Platinum Microelectrode: Effect of Carbon Monoxide Impurities

The kinetics of the hydrogen oxidation and the CO adsorption on a Pt (ultra)microelectrode is studied in a 0.5 M H₂SO₄ solution saturated with a mixture of gaseous H₂ and CO at partial CO pressures p _CO = 10–500 ppm. The balance between rates of diffusion and adsorption of CO at different adsorption times is studied. Studied is the effect of CO impurities in H₂ on steady-state polarization curves for the hydrogen ionization and nonsteady-state curves of the oxidation current decay with time at 0.02–0.05 V. Conditions under which in a certain time interval and at a certain CO concentration the slope of an I vs. t curve is proportional to p _CO are determined. The obtained dependence may be used when designing a technique for monitoring CO impurities in technical hydrogen.