钕玻璃的热致断裂及泵浦极限

以激光介质的第一主应力为评判标准,依据Griffith微裂纹理论作为断裂临界应力,基于已报道的断裂实验数据和3维、瞬态的有限元计算,建立了预测一定泵浦参数下钕玻璃断裂可能性的Weibull统计模型,同时分析了影响介质泵浦极限的其它因素。结果表明:材料的抛光工艺决定了介质的断裂应力;对于短脉冲大能量方式工作的钕玻璃介质,基于美国2 0世纪9 0年代的抛光水平,1 Hz以下低重频时应优先考虑18 kW.cm-2的泵浦饱和极限,10 Hz以上高重频时应优先考虑介质的断裂极限。     

Ca8Mg(SiO4)4Cl2:Eu2+,Nd3+的近红外发光

用高温固相法制备了Ca<,8>Mg(SiO<,4>)<,4>Cl<,2>:Eu<'2+>,Nd<'3+>近红外发光材料,通过X射线衍射仪,近红外,可见发射光谱和激发光谱,荧光寿命等对样品进行了测试.研究了Eu<'2+>、Nd<'3+>的掺杂浓度对近红外发光性能的影响及相对强度变化的规律,结果表明,Ca<,8>Mg(Si...     

Surface morphologic and structural analysis of IR irradiated silver

The microstructural morphological changes in laser irradiated targets are investigated. Nd:YAG laser (1064 nm, ∼12 ns nominal, 1.1 MW) is used to irradiate 4 N pure (99.99%) fine polished and annealed silver samples in ambient air and under vacuum ∼10⁻⁶ Torr. The laser spot size and power density at tight focus are 12 μm and 3×10¹¹ W/cm², respectively. SEM micrographs and X-ray diffractograms of the exposed and unexposed targets reveal the surface texture and structural changes, respectively. Amongst the ablation mechanisms involved, exfoliation and hydrodynamic sputtering are found to be dominant. Surface modifications appear in the form of craters and ripples formation. Heat is conducted non-uniformly through narrow channels at the surface. Thermal stresses induced by the laser do not disturb inter planar distance of the target. On the other hand irradiation causes significant variations in grain size and diffracted X-rays intensities.     

LD端面抽运c切Nd:YVO4自拉曼倍频589 nm黄光激光研究

报道了LD端面抽运c切Nd:YVO₄自拉曼倍频黄光激光器的研究. 采用10 mm长,二类临界相位匹配角 (θ=69°,ø=0°)切割的KTP晶体作为倍频晶体. 考虑到c切Nd:YVO₄跃迁截面较小,所以通过对谐振腔及晶体膜系的严格设计,减少腔内插入损耗和衍射损耗. 最终在脉冲重复率为10 kHz,抽运功率为11.2 W下,获得了最高570 mW的倍频黄光激光输出,对应抽运光到倍频黄光的转化效率约为 关键词： 拉曼激光 c切Nd:YVO₄')" href="#">c切Nd:YVO₄ 589 nm 黄光激光     

Ablation yield and angular distribution of ablated particles from laser-irradiated metals: The most fundamental determining factor

Five metals (Zn, Cu, Ni, Ti, and Mo) were irradiated with 150 shots of a Q-switched Nd:YAG pulsed laser in a vacuum of 10⁻³ torr. The ions projected out of the laser-produced plasma (LPP) plume were detected by CR-39 detectors positioned at −15°, 0°, 30°, 60°, and 90° with respect to the target-surface normal at a distance of 5 cm from the target in each case. The angular distribution of LPP ions, which is characterized by the exponent n of cosⁿ θ distribution, is given by n = 2.5-11 for the five target metals. The value of the exponent n has no systematic correlation with the square-root of atomic mass of the target metals but exhibits systematic dependence on the room temperature Debye-Waller's thermal parameter B or the mean-square amplitude of atomic vibrations 〈u²〉. Likewise, the ablation yield (atoms/shot) of the twelve target metals investigated by Thestrup et al. (2002) [8] under identical irradiation conditions is a function of the room temperature B-factor or 〈u²〉.     

High power 1341.4 nmNd:YAlO3 CW laser and its performances

A lamp pumped high power 1341.4 nmNd:YAlO₃CW laser and its performances have been described. As high as 188 W of CW output power has been obtained at 1341.4 nm alone line with a overall efficiency of 1.37% and a slope efficiency of 2.14%. The divergence (FWHM) and instability (RMS) of this laser at output power of 155 W are 15 mrad and 1.19%, respectively.     

ICP－AES法测定钨酸钇钾激光晶体中的Er和Nd

应用ＩＣＰ－ＡＥＳ法测定钨酸钇钾［ｋＹ（ＷＯ４）２］激光晶体中的Ｅｒ和Ｎｄ。试样用磷酸分解，Ｔｍ被选作内标元素。Ｅｒ和Ｎｄ的回收率分别为９８．６％－１０５．３％和９６．５％－１０５．８％，相对标准偏差分别为１．９０％和１．６０％。     

Dependence of the refractive power of Nd:YAG rods on the intracavity intensity

The refractive power of two flashlamp-pumped Nd:YAG rods was measured as being dependent on the output coupling of the resonator. With laser oscillation, the refractive power or thermal heat is decreased by up to 15% and a minimum occurs at a specific output coupling. The experimental results could be explained by a theoretical model assuming a non-radiative transition from the upper laser level to the ground state. The lifetime of this non-radiative transition decreases with increasing pumping power per pulse and, for pumping power higher than 100 kW, saturation at a value of 0.63 times the fluorescence lifetime occurs. The results indicate that the non-radiative process is caused by energy migration to flashlamp-induced transient quenching centres.     

三倍频Nd∶YAG激光抽运氧气中的受激拉曼和布里渊散射

报道了三倍频脉冲Nd∶YAG激光(355 nm)在两种不同带宽模式下抽运氧气中受激拉曼散射(SRS)和受激布里渊散射(SBS)的实验研究。在宽带(约1 cm-1)抽运模式下,只测到了前向受激拉曼散射,而没有观察到后向散射,其一级和二级斯托克斯最大能量转换效率可达22%和8%。在窄带(约0.003 cm-1)模式下,前向、后向受激拉曼散射和受激布里渊散射都测量到了,但大部分抽运能量都转换到受激布里渊散射,其转换效率可达67%。测量了两种带宽模式下各散射组分在它们最佳转换时的波形;窄带情况下后向受激拉曼散射和受激布里渊散射的脉宽分别可压窄至1.5 ns和2.3 ns,不到抽运脉宽的三分之一,使得受激布里渊散射峰值功率可大大高于抽运功率。对氧气中前向、后向受激拉曼散射和受激布里渊散射之间的竞争进行了讨论。     

Cr,Nd:YAG self-Q-switched laser with high efficiency output

The high efficient laser performance of self-Q-switched laser in the co-doped Cr⁴⁺,Nd³⁺:YAG microchip with 1.8 mm thickness was demonstrated. The slope efficiency is varied with the reflectivity of output coupler at 1064 nm, and the highest slope efficiency of 26% was obtained for 95% reflectivity of output coupler at 1064 nm. The pulse width, the single pulse energy and the pulse repetition rate for different reflectivity of the output couplers were measured, and the experimental results agree with the numerical calculations of the passively Q-switched rate equations. This can lead to develop the diode laser pumped monolithic self-Q-switched solid-state microchip lasers, especially for the intracavity frequency-doubled solid-state microchip lasers.