ICP-AES同时测定高纯碲中钙、铈和钛

ICP-AES法测定高纯碲中的杂质元素Ca、Ce和Ti,进行了碲基体影响、加标回收和精密度实验研究。加标回收率为92%—93%,相对标准偏差小于1%,所得结果令人满意。     

低阈值飞秒钛宝石激光器的理论研究

利用数值求解的方法，从理论上系统分析了决定钛宝石激光器锁模阈值的几个关键因素. 定 量分析了腔模对克尔效应的主导作用，并将光孤子模型引入低阈值锁模理论，分析了色散与 阈值的关系. 根据理论指导在实验上完成了一台阈值低至390 mW自启动飞秒掺钛蓝宝石激光 器. 关键词： 低阈值 掺钛蓝宝石激光器 克尔透镜锁模 光孤子     

贮氢钛膜氢含量的中子反射分析方法设计

对3 μm厚Ti膜的中子反射率谱进行理论计算,得到了Ti膜在不同含氘量(TiDc,c=0.5、1.0、1.5和2.0)、表面是否氧化下的反射率谱.数据表明,用中子反射技术可以获取含氘量和表面氧化程度等信息.同时,根据需测量的膜层最大厚度,对反射谱仪部分参数提出了要求.     

Structure and micro-mechanical properties of helium-implanted layer on Ti by plasma-based ion implantation

The present paper concentrates on structure and micro-mechanical properties of the helium-implanted layer on titanium treated by plasma-based ion implantation with a pulsed voltage of −30 kV and doses of 3, 6, 9 and 12 × 10¹⁷ ions/cm², respectively. X-ray photoelectron spectroscopy and transmission electron microscopy are employed to characterize the structure of the implanted layer. The hardnesses at different depths of the layer were measured by nano-indentation. We found that helium ion implantation into titanium leads to the formation of bubbles with a diameter from a few to more than 10 nm and the bubble size increases with the increase of dose. The primary existing form of Ti is amorphous in the implanted layer. Helium implantation also enhances the ingress of O, C and N and stimulates the formations of TiO₂, Ti₂O₃, TiO, TiC and TiN in the near surface layer. And the amount of the ingressed oxygen is obviously higher than those of nitrogen and carbon due to its higher activity. At the near surface layer, the hardnesses of all implanted samples increases remarkably comparing with untreated one and the maximum hardness has an increase by a factor of up to 3.7. For the samples implanted with higher doses of 6, 9 and 12 × 10¹⁷ He/cm², the local displacement bursts are clearly found in the load-displacement curves. For the samples implanted with a lower dose of 3 × 10¹⁷ He/cm², there is no obvious displacement burst found. Furthermore, the burst width increases with the increase of the dose.     

Wavelength dependent damage in biological multi-photon confocal microscopy: A micro-spectroscopic comparison between femtosecond Ti:sapphire and Cr:forsterite laser sources

Molecular excitation by the simultaneous absorption of two photons provides intrinsic three-dimensional resolution in laser scanning fluorescence microscopy. Thus induced two-photon absorption and the accompanied multi-photon absorption/ionization not only cause photo-bleaching but also cell damage in the vicinity of the focal point. In this paper, we study the wavelength dependent cell damage induced by high intensity femtosecond near infrared lasers. The study was performed with a Ti:sapphire laser and a Cr:forsterite laser. With a longer output wavelength from a Cr:forsterite laser, multi-photon absorption and auto-fluorescence were found to be significantly suppressed and the destructive plasma formation was found to be greatly reduced. Sustained multi-photon spectra can be observed in most plant specimens with a tightly focused Cr:forsterite laser beam under long term irradiation with more than 100 mW laser average power. In contrast, multi-photon absorption induced destructive plasma formation were frequently observed with a tightly focused Ti:sapphire laser beam within seconds with more than 10 mW laser average power.     

良性前列腺增生组织对钛宝石激光的吸收和散射特性

研究了经尿道等离子体双极电切除术(PKRP)切除和经尿道前列腺电切术(TURP)切除的前列腺增生(BPH)组织对640, 660, 680, 700, 720, 740, 760, 780, 800, 820, 840, 860和880 nm波长的钛宝石激光的光学特性及其差异,实验采用双积分球测量系统以及反向倍增法获取BPH组织的吸收和散射特性参数。结果表明：PKRP和TURP切除的BPH组织对这1３个不同波长的激光的吸收系数和约化散射系数都是随着激光波长增大而明显减小的,PKRP切除的BPH组织对这同一波长的激光的吸收系数和约化散射系数都明显较TURP切除的BPH组织对相应的波长的激光的吸收系数和约化散射系数要小,PKRP和TURP切除的BPH组织的吸收系数以及约化散射系数的最大值都在640 nm,其值分别为(0.885±0.022)和(0.955±0.024)mm-1以及(1.564±0.039)和(1.658±0.042)mm-1,其差异分别为7.91%以及6.01%,其最小值都在880 nm,其值分别为(0.443±0.011)和(0.455±0.011)mm-1以及(1.117±0.028)和(1.197±0.030)mm-1,其差异分别为2.71%以及7.16%。PKRP和TURP切除的BPH组织对660 nm的吸收系数的差异最大,其值为8.95%,其差异最小在860 nm,其值为1.75%,PKRP和TURP切除的BPH组织对800 nm的约化散射系数的差异最大,其值为9.13%,其差异最小在640 nm,其值为6.01%。     

8—9.5 keV正电子致Ti的K壳层电离截面的实验研究

低能正电子碰撞原子内壳层电离截面的实验数据目前还很缺乏,从而影响了对近年来发展的各相关理论模型的检验,限制了慢正电子束流技术在诸多领域中的应用.本文采用慢正电子束流装置产生的8—9.5 keV正电子束碰撞纯厚Ti靶,利用硅漂移探测器(SDD)收集正电子碰撞Ti靶产生的X射线,同时采用高纯锗探测器在线获得与靶碰撞的入射正电子数,从而得到Ti的K壳层实验产额,并基于蒙特卡罗模拟程序PENELOPE获得模拟产额.将实验产额分别与内壳层电离截面数据库采用经典光学数据模型(ODM)和扭曲波玻恩近似理论模型(DWBA)的蒙特卡罗模拟产额进行对比,发现基于ODM理论模型的模拟产额与实验值有较大的偏差,基于DWBA理论模型的模拟产额与实验结果符合较好.根据实验产额和基于DWBA理论模型的模拟产额的比较结果,对蒙特卡罗模拟程序使用的DWBA理论模型数据库进行修正后再进行模拟和比较,从而得到可靠的8—9.5 keV正电子致Ti原子K壳层电离截面数据.     

缺陷TiO2中铁磁性的第一性原理计算

计算钛空位（V_Ti）和氧空位（V_O）共存情况下未掺杂金红石TiO₂的铁磁性.发现V_O可以产生局域磁矩,由它引起的自旋极化比V_Ti引起的更加局域,导致V_O之间的铁磁耦合作用弱于V_Ti之间的铁磁耦合作用.V_Ti之间的铁磁耦合在引入V_O之后进一步加强.V_O引入的电子调制两个分离的V_Ti之间的长程铁磁耦合.加入V_Ti之后,两个V_O的磁矩猝灭,当V_O的数量多于V_Ti的数量二倍时,V_O会对磁矩有贡献.结果与实验发现的V_O可以提高铁磁有序,并且总的磁矩会随着V_O数量的增多而增加的结果符合很好.     

Tin(n=2~7)团簇结构, 稳定性和电荷分布关系的密度泛函研究

利用密度泛函理论中的B3LYP方法, 选择LANL2DZ基组优化Tin(2~7)团簇得到各团簇的稳定结构,然后对稳定结构的束缚能及自然轨道进行分析. 研究结果表明: Tin(n=2~7)团簇都依带帽的形式在前一个团簇的结构基础上加一个原子变化而来; 通过自然轨道分析发现, 团簇原子的轨道存在sp-d杂化, 有大约一个电子从4s转移到了3d, 原子之间亦存在电子转移, 而且除Ti7外, 团簇键长由最外层4d轨道电子和3d轨道共同决定, 在Ti7中, 团簇键长由3d轨道决定.     

Tunable Sum Frequency Mixing of a Ti∶sapphire Laser and a Nd∶YAG Laser

In this paper the theoretical and experimental results of sum-frequency mixing of a Ti∶sapphire laser and a 1.064 μm Nd∶YAG laser are presented. By using two KTP crystals cut at θ=76° and 85° (φ=90° in both crystals), respectively, the sum-frequency mixing tuning range from 459.3 to 509.6 nm in one Ti∶sapphire laser setup is experimentally achieved. The maximum output energy was 14.6 mJ and the energy conversion efficiency was up to 15.2%.