硫化态K—Mo合成低碳醇催化剂的制备条件和载体效应研究

用浸渍法制备以KCl为助剂的ZrO_2、γ-Al_2O_3和SiO_2负载硫化态钼基催化剂,研究了钼和助剂钾两种组分浸渍顺序、助剂含量、载体差别以及浸渍溶液的酸碱性对催化剂上CO加氢合成低碳混合醇性能的影响。ZrO_2按先钼后钾、γ-Al_2O_3和SiO_2则按相反的顺序浸渍两种组分、且K/Mo原子比分别为0.5,0.8和1.0制备催化剂,其合成醇活性最佳。由于载体性质的差异,K-Mo/SiO_2、特别是K-Mo/ZrO_2的合成醇活性强烈依赖于钾助剂含量。而K-Mo/SiO_2在较宽的钾含量范围内,其活性差别不明显。适当选择较高碱性的浸渍溶液制备K-Mo/γ-Al_2O_3催化剂,有利于醇活性的提高。     

春砂仁无机成分与药效的研究

采集了阳春县三个产地有代表性的春砂仁．用原子吸收光谱、控制气忿和罩帽电极发射光谱等法，测定其无机成分。结果表明，春砂仁对Zn、Mn有较大富集作用．其含量与春砂仁质量正相关；不同产地春砂仁的挥发油、无机成分与药效成分之间存在差别，证实以金花坑的春砂仁质量最优。     

Role of Bipolar Pulsed DBD on the Growth of <Emphasis Type="Italic">Microcystis aeruginosa</Emphasis> in Three-Phase Discharge Plasma Reactor

Algae in drinking water supplies often bring about impact on the water treatment. In this study, a bipolar pulsed dielectric barrier discharge system in three-phase discharge plasma reactor was constructed for investigating its ability to control excessive growth of cyanobacteria, Microcystis aeruginosa. Experimental results show there was almost no change in optical density immediately after the interruption of electrical discharge, but the decreasing trend of optical density, cell density and chlorophyll-a content was obvious during the incubation period, indicating a significant residual effect of electrical discharge process on the algal growth inhibition. Scanning electron microscopy investigation of algae revealed surface damage, apparent leakage of intracellular contents and pores formed after electrical discharge process, which showed that algal cells had no potential to survive and grow. Compared with the control sample, it was observed that electrical discharge on the algal extracellular products has almost no residual effect and the growth rate of algae slightly decreased before three days storage. Hydrogen peroxide was produced by electrical discharge in the μM level and showed a first-order decay. But at such level, the external addition of hydrogen peroxide alone is not likely to cause the residual effect. These results implicated that the growth inhibition of M. aeruginosa was mainly caused by electrical discharge process, and it made the algal cells lose ability to survive, demonstrating the considerable potential of such an alternative process for efficient water purification.     

对固体圆二色光谱测试方法的再认识——兼谈“浓度效应”

对近期发展的固体圆二色(CD)光谱测试方法进行了概述、评价和比较, 着重探讨了“浓度效应”的存在使固体CD光谱失真的原因. 通过对本课题组和其他作者已报道的四种化合物的固体CD谱再测试的反思, 强调了依手性化合物的手性光谱学性质不同, 根据浓度梯度实验选择其合适测试浓度的必要性. 对固有手性的阻转异构化合物(S)-1,1'-联二萘酚(S-BINOL)进行了成膜法固体CD谱浓度梯度测试, 发现所得固体薄膜CD谱中也存在着“浓度效应”     

纳米复合材料CoFe2O4/SiO2的制备和表征

采用溶胶-凝胶法制备了(CoFe2O4)x/(SiO2)1-x纳米复合材料. 利用TG/DTA, XRD和Mssbauer效应研究了热处理过程中干凝胶的变化及样品的结构、晶粒尺寸和磁性. 结果表明, 随着SiO2含量的增加, 样品中CoFe2O4的晶粒尺寸和内磁场逐渐变小, 并从磁有序状态转变为超顺磁状态.     

Vibrational isotope effect by the low rank perturbation method

Mathematical formalism of the Low Rank Perturbation method (LRP) is applied to the vibrational isotope effect in the harmonic approximation with a standard assumption that force field does not change under isotopic substitutions. A pair of two n-atom isotopic molecules A and B which are identical except for isotopic substitutions at ρ atomic sites is considered. In the LRP approach vibrational frequencies ω _k and normal modes of the isotopomer B are expressed in terms of the vibrational frequencies ν _i and normal modes of the parent molecule A. In those relations complete specification of the normal modes is not required. Only amplitudes at sites τ affected by the isotopic substitutions and in the coordinate direction s (s = x, y, z) are needed. Out-of-plane vibrations of the (H,D)-benzene isotopomers are considered. Standard error of the LRP frequencies with respect to the DFT frequencies is on average . This error is due to the uncertainty of the input data (± 0.5 cm⁻¹) and in the absence of those uncertainties and in the harmonic approximation it should disappear. In comparing with experiment, one finds that LRP frequencies reproduces experimental frequencies of (H,D)-benzene isotopomers better () than scaled DFT frequencies () which are designed to minimize (by frequency scaling technique) this error. In addition, LRP is conceptually and numerically simple and it also provides a new insight in the vibrational isotope effect in the harmonic approximation.     

负载于孔道内部的手性酸碱催化不对称Aldol反应

将手性的伯胺-叔胺与B酸组成的酸碱对负载到介孔材料SBA-15孔道的内表面,得到了一种非均相双功能催化剂.该催化剂在催化丙酮和不同醛的aldol反应时得到了中等的活性和对映体选择性,重复使用6次后活性没有明显下降.与以硅胶为载体的催化剂相比,以介孔SBA-15分子筛为载体的催化剂ee值更高,这可能是由于介孔孔道限制效应引起的.     

水/有机两相体系 1-癸烯氢氨甲基化反应中 TPPTS 和TPPDS 的协同效应

 在 RhCl(CO)(TPPTS)2-TPPTS[P(m-C6H4SO3Na)3]/TPPDS[C6H5P(m-C6H4 SO3Na)2]-CTAB (十六烷基三甲基溴化铵) 水-有机两相催化体系中, 系统考察了 TPPTS/TPPDS 摩尔比、反应压力、阳离子表面活性剂结构及其浓度对 1-癸烯氢氨甲基化反应区域选择性的影响. 结果表明, TPPDS 的加入对生成胺的区域选择性的影响非常大. 当 TPPTS/TPPDS 摩尔比为 4 时, 直链胺和支链胺之比由不加 TPPDS 时的 8.2 增加到 21.0. 可见, TPPTS 和 TPPDS 存在着明显的协同效应. 阳离子表面活性剂的结构对生成胺的区域选择性影响也很大, 加入双长链阳离子表面活性剂时区域选择性远低于单长链阳离子表面活性剂, 且形成的聚集体越紧密, 越有利于提高产物正/异比.     

TiO_2/Mn-ZSM-5复合催化剂的光催化-臭氧耦合降解乙醛

采用离子交换法制备了Mn-ZSM-5系列催化剂,并利用浸渍法制备了TiO2/Mn-ZSM-5系列复合催化剂.通过Uv-Vis、BET、X射线衍射等手段对催化剂进行了表征,考察了臭氧存在下乙醛的降解性能.结果表明:臭氧能显著促进乙醛的光催化降解,在所制备的催化剂中TiO2/Mn-ZSM-5(1:2)对乙醛降解具有最好的活性,这归功于这种复合催化剂对臭氧和乙醛的吸附和催化协同效应.     

3-甲基环状乙撑磷酸二酯醇解的反应途径的理论研究

采用密度泛函理论和MP2方法研究了3-甲基环状乙撑磷酸二酯(MEP)与甲醇的反应途径:(Ⅰ)CH3O-+MEP;(Ⅱ)CH3OH+MEP;(Ⅲ)CH3O-+HMEP(MEP的质子化形式);(Ⅳ)CH3OH+HMEP.在B3LYP/6-31++G(d,p)水平上优化了四条反应途径的反应物、中间体、过渡态及产物的几何构型,并在同水平上进行了自然电荷分析,然后在MP2/6-311++G(3df,2p)水平上计算了各驻点的单点能.采用极化连续介质模型(PCM)研究了各途径在苯、甲醇和水溶液中的溶剂化效应.计算结果表明,溶剂效应使途径(Ⅰ)的自由能垒降低,而使途径(Ⅱ)和(Ⅳ)的决速步骤的自由能垒升高.在气相和苯溶剂中途径(Ⅳ)是反应的优势途径,在甲醇和水溶剂中途径(Ⅰ)则成为最优.研究结果进一步表明实验条件下途径(Ⅱ)与(Ⅳ)对总醇解反应的贡献相当.