LiNbO3质子交换波导及其退火效应

采用质子交换技术,以苯甲酸为交换源,实验研究X-切LiNbO₃质子交换平面波导及其退火效应。利用棱镜耦合器测出波导模折射率。采用费米函数,由模折射率确定出波导折射率分布随退火时间的变化关系,给出了分布参数和曲线.     

基于宽度可调节的线缺陷平板型光子晶体的空气槽微腔

研究了一种空气槽光子晶体微腔,这种腔是由在平板型光子晶体上引入一条宽度可以调节的线缺陷空气槽形成的.腔模的电场被强烈局限在空气槽中,由于介电常量的不连续性,电场得到很大的提高,同时模体积被大大地降低.数值模拟与分析了微腔的能带结构和场分布,考虑到腔模的谐振频率和对称性,发现一阶偶膜同时具有较高的品质因子和较小的模体积;应用有限时域差分法,得到腔模的品质因子可以高达10⁶,模体积仅为0.02(λ/n)³.计算了一阶偶模谐振波长随空气槽宽度以及空气孔半径的变化,发现随着宽度的增加,波长越来越短.而随着空气孔半径的增加,波长近似线性地减小;当空气孔半径为170 nm时,可以获得最高的腔品质因子.     

New generalized computations of quasi-planar waveguides characteristics

An efficient hybrid field solution to the general multilayer substrates transmission line problems with full shielded and half open cross-sectional geometry is presented by using the waveguide modes coupling and decoupling procedure in the spectral domain. Modal transverse transmission lines corresponding to the LSE and LSM modes are taken into account so that the Green's elements for the edge conditions can be derived by a simple iterative method. In this paper, we analyze not only the propagation constants and characteristic impedances but also the available transmission power capacity and power distribution of most commonly used structures. Normalized eigenmode power levels characterizing the propagation features are computed.     

W波段TE62-TEM00准光模式变换器

对准光模式变换器的基本理论和设计方法进行了讨论.以改进型等效电流理论为基础给出了Vlasov辐射器的分析方法,建立了数值模型,并进行了计算分析.继而推导了自适应相位修正Katsenelenbaum-Semenov算法,编制了相位修正反射镜自适应设计分析程序.在上述理论工作的基础上,针对3 mm波段TE62至TEM00准...     

不同开关频率下电压控制升压变换器中的Hopf分岔分析

由于电压控制升压变换器的传统平均模型中没有包含开关频率,从而无法分析开关频率的大小对电压控制升压变换器中Hopf分岔的影响. 通过建立电压控制升压变换器的含有开关频率的改进平均模型,分析了开关频率对电压控制升压变换器中Hopf分岔的影响,并设计硬件电路,给出电路试验结果. 研究表明:采用电压控制升压变换器的改进平均模型,可以有效地分析不同开关频率对电压控制升压变换器中Hopf分岔的影响; 随着开关频率的减小,电压控制升压变换器更易于发生Hopf分岔. 关键词： 改进平均模型 电压控制升压变换器 开关频率     

Mode Specificity,Bond Selectivity,and Product Energy Disposal in X + CH4/CHD3 (X=H,F, O(3P), Cl,and OH) Hydrogen Abstraction Reactions: Perspective from Sudden Vector Projection Model

Reactions between methane and various radicals have become the workhorse in our understanding of mode specificity and bond selectivity in bimolecular reactions. In this work, the recently proposed Sudden Vector Projection (SVP) model is used to gain insight into the existing experimental and theoretical data on these reactions. The SVP model attributes mode specificity and bond selectivity to the coupling of reactant modes/bonds with the reaction coordinate at the transition state. In the sudden limit, the strength of the coupling can be simply computed by projecting the corresponding reactant normal mode vector onto that of the imaginary frequency mode at the saddle point. In addition, the SVP model can be used to predict energy disposal in the products, thanks to microscopic reversibility. It is shown that most of the mode‐specific and bond‐selective chemistry in X + CH₄/CHD₃ (X=H, F, O(³P), Cl, and OH) reactions can be reasonably understood with this simple model.     

连续碳纤维增强的聚芳醚酮在Ⅰ型循环载荷下的层间破坏

用双悬臂梁(DCB)试件研究了连续碳纤维增强的聚芳醚酮复合材料(CF/PEK-C),在Ⅰ型循环载荷作用下的层间裂纹扩展行为.循环载荷采用载荷控制模式,最小载荷与最大载荷之比为0.5.在疲劳试验中,仍然发现有“阻力曲线”现象存在.层间裂纹扩展速率用指数定律与相应的应变能释放速率联系起来,并对结果进行了讨论.     

Intrinsically flame retardant epoxy resin - Fire performance and background - Part II

The flame retardant mechanism of a newly synthesized phosphorus-containing reactive amine, which can be used both as crosslinking agent in epoxy resins and as flame retardant, was investigated. The mode of action and degradation pathway were investigated by in situ analysis of the gases evolved during the degradation by thermogravimetric measurements coupled online with infrared (TG-EGA-FTIR) and mass spectroscopy (TG/DTA-EGA-MS) and by solid residue analysis by infrared (ATR) spectroscopic methods and X-ray photoelectron spectroscopy (XPS). It was observed that the main difference in the degradation of the reference and the flame retardant system is that the degradation of the latter begins at lower temperature mainly with the emission of degradation products of the phosphorus amine, which act as flame retardants in the gas phase slowing down the further degradation steps. At the high temperature degradation stage the solid phase effect of the phosphorus prevails: the formation of phosphorocarbonaceous intumescent char results in a mass residue of 23.4%. The ratio of phosphorus acting in gas phase and solid phase, respectively, was determined on the basis of thermogravimetric and XPS measurements.     

MOSFET with a boron-loaded gate as a low-energy neutron dosimeter

A MOSFET-based low-energy neutron dosimeter has been fabricated using a ¹⁰B loaded gate electrode as (n,α) converter. The response to thermal neutrons has been studied.