高折射率椭圆芯布拉格光纤的偏振特性

应用带完全匹配层边界条件的全矢量有限元方法,分析了高折射率椭圆芯布拉格光纤的偏振特性,详细讨论了光纤结构参量对模式双折射度以及群速度走离的影响,结果发现:高折射率椭圆芯布拉格光纤的模式双折射度可达10-2量级,比传统保偏光纤至少高出一个量级,并且表现出不同于传统保偏光纤的群速度走离特性;在保持较高双折射度的同时,通过合理的结构设计,可在一定的波长处灵活地获得较大的群速度走离或零走离特性,具有重要的潜在应用价值;最后,简要分析了低折射率区域的折射率变化对偏振特性的影响;研究结果有助于设计高性能的微结构保偏光纤。     

Effects of ultrasound-assisted enzyme hydrolysis on the microstructure and physicochemical properties of okara fibers

This work focuses on the effects of different ultrasound power densities on the microstructural changes and physicochemical properties of okara fibers, which are composed of carbohydrate-based polymers. Okara suspensions were treated with ultrasound at different power densities (0, 1, 2, 3, 4, and 5 W/mL) for 30 min, after which the ultrasound-treated okara were hydrolyzed by trypsin to obtain okara fibers. The ultrasound treatment of the okara fibers induced structural disorganization and changes, evidenced mainly in their morphological characteristics and their relative crystallinity degrees. Increasing the ultrasound power broke the okara fibers into flaky and stacked structures. When the ultrasound power density reached 4 W/mL, the parenchyma became compact and the hourglass structure fractured. The mean particle size of the okara fiber was reduced from 82.24 µm to 53.96 µm, and the homogeneity was enhanced significantly. The relative crystallinity of the okara fibers was reduced from 55.14% to 36.47%. The okara fiber surface charge decreased when the ultrasound power was increased. However, after ultrasound treatment at 4 W/mL (800 W), the okara fiber suspension exhibited the highest viscosity value and a higher swelling capacity, water-holding capacity, and oil-holding capacity. Therefore, the results indicated that the selection of processing conditions for okara fibers is critical and that okara fiber modification using a high ultrasound treatment might improve their use in potential applications.     

Studies on the syntheses of polymetalloxanes and their properties as a precursor for amorphous oxide. IV. Properties of SiO2–TiO2 oxide fibers from polytitanosiloxane

From polytitanosiloxanes (PTS), SiO₂–TiO₂ oxide fibers with fairly good tensile strength were prepared, and their mechanical and thermal properties were investigated. The precursor fibers PTS-0.5 and PTS-1.0 were obtained by dry spinning of a highly viscous PTS solution which were formed as the reaction mixture of silicic acid (SA) with bis(2,4-pentanedionato)titanium diisopropoxide (PTP) in the molar ratios (SA/PTP) of 0.5 and 1.0. The precursor fibers PTS-0.5 were too brittle to measure their tensile strength, whereas PTS-1.0 and the heat-treated fibers were found to have tensile strength of 130 (precursor), 540 (500°C), and 450 (900°C) MPa, respectively. Heat-treatment of the fibers PTS-1.0 at above 1000°C forms anatase and rutile of titanium dioxide. The crystallization is resulted from the unreacted PTP which is not incorporated into the polymer network.     

Biomolecules from Plant Wastes Potentially Relevant in the Management of Irritable Bowel Syndrome and Co-Occurring Symptomatology

During and following the processing of a plant’s raw material, considerable amounts are wasted, composted, or redistributed in non-alimentary sectors for further use (for example, some forms of plant waste contribute to biofuel, bioethanol, or biomass production). However, many of these forms of waste still consist of critical bioactive compounds used in the food industry or medicine. Irritable bowel syndrome (IBS) is one of the most common functional gastrointestinal disorders. The primary treatment is based on symptomatology alleviation and controlled dietary management. Thus, this review aimed to describe the possible relevance of molecules residing in plant waste that can be used to manage IBS and co-occurring symptoms. Significant evidence was found that many forms of fruit, vegetable, and medicinal plant waste could be the source of some molecules that could be used to treat or prevent stool consistency and frequency impairments and abdominal pain, these being the main IBS symptoms. While many of these molecules could be recovered from plant waste during or following primary processing, the studies suggested that enriched food could offer efficient valorization and prevent further changes in properties or stability. In this way, root, stem, straw, leaf, fruit, and vegetable pomaces were found to consist of biomolecules that could modulate intestinal permeability, pain perception, and overall gastrointestinal digestive processes.     

Simultaneous measurement of curvature and temperature based on PCF-based interferometer and fiber Bragg grating

A sensor head consisting of a photonic crystal fiber (PCF)-based Mach-Zehnder interferometer (MZI) and a fiber Bragg grating (FBG) is proposed and experimentally demonstrated for simultaneous measurement of curvature and temperature. The MZI fabricated by splicing a short length of PCF between two single-mode fibers with the air-hole structure that completely collapsed near the splicing points, is sensitive to fiber bending and surrounding temperature, while the FBG is only sensitive to the later. Simultaneous measurement of curvature and temperature is therefore obtained. Sensitivities of 4.06 nm/m^− 1 and 6.30 pm/°C are achieved experimentally for curvature and temperature, respectively. And the corresponding resolutions are 5.2 × 10^− 4 m^− 1 and 1.25 °C for curvature and temperature, respectively, based on the wavelength measurement resolution of 10 pm.     

Phase-matched third-harmonic UV generation using low-order modes in a glass micro-fiber

We observe phase-matched third-harmonic generation at 355 nm in a low-order mode of a sub-micron diameter glass fiber. The third-harmonic signal exhibits a sharp resonance for a fiber diameter d = 0.49 ± 0.02 μm, in excellent agreement with the value d = 0.506 μm predicted by theory. The third-harmonic conversion efficiency is 2 × 10⁻⁶, and is limited by the pump power (1 kW) and effective fiber length (100 μm).     

双折射光纤中偏振模色散的抑制

利用双折射光纤中孤子自捕获现象可以抑制偏振模色散,但这种抑制技术对传输参量有严格的限制.本文提出在双折射光纤中周期性地改变快慢轴的方法来抑制偏振模色散. 研究发现,这种方法在一定程度上能有效地抑制偏振模色散,并且光纤间偏振轴的夹角偏差有利于对偏振模色散的进一步抑制.     

Enhanced Compression of Fundamental Solitons in Dispersion Decreasing Fibers with Negative Third-order Dispersion Ⅱ. Effects of Fiber Characteristics and Initial Soliton Width

Previous work have shown that the combined effects of negative third-order dispersion (TOD) and Raman self-scattering (RSS) can significantly enhance soliton compression in dispersion decreasing fibers (DDFs). In this paper, the effects of the negative TOD coefficient and the effective amplification of DDF′s on the performance of soliton compression are investigated. It is shown that for a given initial soliton width and a given effective amplification, there exists an optimum value of the negative TOD coefficient of the DDF at which the enhancement in soliton compression is maximum. It is also shown that the compression enhancement saturates when the effective amplification exceeds a certain value, which has been explained as a compromise between the higher-order effects induced increase of the ratio of input to output group-velocity dispersion coefficients of the DDF and the TOD induced non-adiabatic compression characteristics. The dependence of the compression enhancement on the initial soliton width have also be studied and the scheme is found works well for solitons with initial widths less than 3 ps.     

熊猫光纤的结构与双折射特性关系研究

本文用微元算法研究了熊猫光纤的结构参量对熊猫光纤双折射特性(拍长)的影响.由实验数据拟合出了计算拍长的熊猫光纤掺杂区的有效热膨胀系数.计算结果表明,熊猫光纤的猫眼半径、猫眼与纤芯的距离、猫眼的不一致等都是影响拍长的因素.所得结果对熊猫光纤的制作提供了理论指导.     

Numerical calculation of cutoff frequencies of optical fibers by a variational technique

A numerical method for calculating cutoff frequencies of modes of weakly guiding optical fibers is described. Starting from a properly constructed field representation, the method follows a variational approach to obtain an eigenvalue problem for the cutoff frequencies which can be easily solved by a standard numerical routine. The field representation uses an expansion in terms of the Laguerre–Gauss functions in the fiber core and limiting form for small arguments of modified Bessel functions in the fiber cladding. Fibers with power-law refractive index profiles and fibers with a profile showing a dip on the axis are analyzed. Results obtained for modes of arbitrary order (both azimuthal and radial) show that our method is very efficient and accurate.