Reduction of Chemical Reactions in Nitrogen and Nitrogen–Hydrogen Plasma Jets Flowing into Atmospheric Air

The large number of possible chemical reactions represents a severe burdenfor modeling of even relatively simple plasma systems. Reduced sets ofchemical reactions have been obtained for numerical simulations of nitrogenand nitrogen-hydrogen plasma jets flowing into an atmospheric airenvironment. The important or active reactions are determined based on asimplified reduction method. A reaction is considered active if it leadsto higher sensitivities than a specified cutoff sensitivity of 1%. Theactive reactions exert a significant influence on main plasma parameters,such as velocity, temperature, and species concentrations. The sensitivityanalysis for the specified systems shows that two NO reactions, known asZel'dovich reactions (N₂+ONO+N andNO+OO₂+N),⁽¹⁾ are both active in a nitrogenplasma jet. On the other hand, the latter is not active and may be omittedin a nitrogen–hydrogen plasma jet. A nitrogen–hydrogen plasmajet requires contribution of two active charge exchange reactions:N₂+N⁺N⁺ ₂+N andN+H+N+ +H, while only the former is needed in a nitrogen plasmajet. The dissociation reactions are all active in both plasma jets, exceptthe dissociation of OH.     

Supersonic jet spectroscopy of naphthalene–fluorene bichromophoric cluster

We have investigated the supersonic jet spectroscopy and photophysics of 1-methylnaphthalene–fluorene (1MN–FL) cluster, and looked for indications of intramolecular electronic energy transfer (Intra-EET) from the FL (donor, D) to 1MN (acceptor, A). The clusters were identified by their time of flight (TOF) mass spectra. We observed clusters bands in the LIF spectrum near the region of 1MN origin. We have also observed cluster TOF–resonance enhanced multi-photon ionization (REMPI) spectrum near the electronic origin of the fluorene moiety. However, this spectrum was almost independent of the excitation wavelength, and was not observed in the LIF spectrum. This is probably due to fast Intra-EET resulting in lifetime broadening of the donor chromophore cluster spectrum, similar to that observed previously for the naphthalene–anthracene bichromophoric system.     

Trace level analysis of volatile and semi-volatile organic compounds in water using a membrane/jet separator interfaced to an ion trap mass spectrometer

An ion trap mass spectrometer, equipped with a membrane/jet separator interface, is used for the direct detection of volatile and semi-volatile organic compounds in aqueous solutions. Aqueous sample is passed through a capillary membrane, the outside surface of which is continuously purged by helium. The permeate is pneumatically transported to the mass spectrometer via a jet separator which acts as an additional enrichment device. The performance and response characteristics of non-porous silicone and microporous polytetrafluoroethylene (PTFE) membranes are studied. The microporous membrane allows sufficient water to pass for it to be used as a reagent gas for chemical ionization. Both types of membranes provide detection limits in the parts per trillion (pptr) to parts per billion (ppb) range with a linear dynamic range of 3 orders of magnitude for some volatile organic compounds. Results show that there is no detectable matrix effect on response in the selected cases examined. The use of microporous membranes to analyze more polar compounds, such as 5-hydroxymethyl furfuraldehyde and lactic acid, is also demonstrated. The effects of other experimental parameters, such as membrane temperature and length, on sensitivity are also investigated.     

Application of laser ablation–inductively coupled plasma-mass spectrometry (LA–ICP–MS) to investigate trace metal spatial distributions in human tooth enamel and dentine growth layers and pulp

Human tooth enamel provides a nearly permanent and chronological record of an individuals nutritional status and anthropogenic trace metal exposure during development; it might thus provide an excellent bio archive. We investigated the micro-spatial distribution of trace metals (Cu, Fe, Mg, Sr, Pb, and Zn) in 196×339 m² raster pattern areas (6.6×10⁴ m²) in a deciduous tooth using laser ablation-inductively coupled plasma-mass spectrometry (LA–ICP–MS). Ablated areas include prenatal and postnatal enamel, the neonatal line, the dentine–enamel junction (DEJ), dentine, and the dentine–pulp junction. Topographic variations in the surface elemental distribution of lead, zinc, strontium, and iron intensities in a deciduous tooth revealed heterogeneous distribution within and among regions. ⁴³Ca normalized elemental intensities showed the following order: Sr>Mg>>Zn>Pb>Fe>Cu. Elevated zinc and lead levels were present in the dental pulp region and at the neonatal line. This study demonstrates the ability of LA–ICP–MS to provide unique elemental distribution information in micro spatial areas of dental hard tissues. Elemental distribution plots could be useful in decoding nutrition and pollution information embedded in their bio apatite structure.Presented in part at the 2002 Winter Conference on Plasma Spectrochemistry, Scottsdale, AZ, January 6–12, 2002. The poster was selected as an outstanding poster presentation.     

Kinetics of the surface tension of micellar solutions: Comparison of different experimental techniques

The kinetics of the surface tension of micellar solutions of nonionic surfactant Triton X-100 is measured experimentally by means of three different techniques: oscillating jet, maximum bubble pressure and inclined plate. They allow to study the micellization kinetics at various time scales (from a few milliseconds to a few seconds) in fairly large concentration region up to 50 times CMC. The experimental data are satisfactorily explained by a theoretical model accounting for the kinetics of micellization, diffusion of surfactant species and expansion of the bubble interface. By this model are computed the characteristic times of diffusion and micellization, which are of comparable magnitude (about 5 to 200 ms), and the Gibbs' elasticity. The micellization time constant corresponds to the slow relaxation process known to coincide with the disintegration of micelles. Comparing our data with other data from literature one can conclude that more realistic information for the micellization kinetics is obtained by the maximum bubble pressure and the oscillating jet method. The inclined plate seems too slow to measure the relaxation processes in micellar solutions of this surfactant.     

Fluorometric detection with a packed flow cell in micro high-performance liquid chromatography

Summary A packed flow cell was used for fluorometric detection in micro high-performance liquid chromatography. The flow cell consisted of fused-silica tubing packed with the same material as the separation column. A focusing effect of the stationary phase on the signal intensity was observed, leading to an improvement of the mass detection limit, as achieved by on-column detection.     

用微芯片化学反应器实现酶催化化学发光测定葡萄糖的研究

葡萄糖是临床化学诊断以及食品分析中重要的检测项目 ,最常用的测定方法是采用葡萄糖氧化酶(GOD)催化葡萄糖与氧分子间反应 ,生成葡萄糖酸和过氧化氢 [1] ,而对过氧化氢的检测则可采用过氧化酶 (POD)催化鲁米诺的化学发光反应进行 [2 ] .FIA对整个过程的实现是十分有效的方式 ,但由于多采用固定化酶反应器 [3～ 5] 使其在制备及分析上较复杂且费用高 .由 Manz等[6] 提出的微型全分析系统(μ- TAS)在针对不同体系的微量分析及在线监测上均具有突出的优越性 .本文使用的含微混合器的微芯片化学反应器采用μ- TAS设计思想 ,建立了化学发…     

软刻蚀及其应用

软刻蚀是一类基于自组装和复制模塑等原理的非光刻微米和纳米加工方法。它为形成和制作微米、纳米图案提供了简便、有效、价廉的途径。在软刻蚀中，用一个表面带图案的弹性模板来实现图案的转移，其加工的分辨率可达30nm－100μm。软刻蚀是微接触印刷、复制模塑、转移微模塑、毛细微模塑、溶剂辅助微模塑等的总称。本文将简介软刻蚀的原理、方法以及它们在微米和纳米加工、微电子学、材料科学、光学、微电子机械系统、表面化学等方面的应用。     

一种新的库仑微水滴定仪的设计方法

在传统微库仑滴定仪原理的基础上，利用８７５１单片机和微机，采用对电解电流时间调制的方法以及测量精度为准则判断滴定终点，从而大大地提高了仪器的测量精度和重复性。     

Molecularly-imprinted polypyrrole-modified stainless steel frits for selective solid phase preconcentration of ochratoxin A

A molecularly-imprinted polymer (MIP) was prepared by electropolymerization of pyrrole (Py) onto a stainless steel frit, using ochratoxin A (OTA) as the template, in order to make a micro solid phase preconcentration (SPP) device. The OTA template was removed with 1% triethylamine (TEA) in methanol. Compared to non-imprinted polypyrrole (PPy), the molecularly-imprinted polypyrrole (MIPPy) enhanced the selective binding of OTA. The percentage recovery improved from 0 to 40% when the OTA sample solution was acidified with 1 M HCl (1% by volume). At a flow rate of 0.2 mL/min, maximum OTA binding was reached in 6 min after a total loading of 3.2 ng OTA. Final elution of the OTA was analyzed by high performance liquid chromatography (HPLC) with fluorescence detection, using 20:80 v/v acetonitrile–ammonia buffer (NH₄Cl/NH₃, 20 mM, pH 9.2) as the mobile phase. The MIPPy-SPP-HPLC results clearly demonstrated that the MIPPy-SPP device afforded selective preconcentration of OTA from red wine samples, at OTA concentration levels as low as 0.05 ppb, prior to HPLC analysis.