Thermochemistry of copper complex of 6-benzylaminopurine

The copper(II) complex of 6-benzylaminopurine (6-BAP) has been prepared with dihydrated cupric chloride and 6-benzylaminopurine. Infrared spectrum and thermal stabilities of the solid complex have been discussed. The constant-volume combustion energy, Δ_c U, has been determined as −12566.92±6.44 kJ mol⁻¹ by a precise rotating-bomb calorimeter at 298.15 K. From the results and other auxiliary quantities, the standard molar enthalpy of combustion, Δ_c H _m ^θ, and the standard molar of formation of the complex, Δ_f H _m ^θ, were calculated as −12558.24±6.44 and −842.50±6.47 kJ mol⁻¹, respectively.     

Effects of carrier and Mn loading on supported manganese oxide catalysts for catalytic combustion of methane

Supported manganese oxide catalysts were prepared by incipient wetness impregnation method for methane catalytic combustion, and effects of the support （Al2O3, SiO2 and TiO2） and Mn loading were investigated. These catalysts were characterized with N2 adsorption, X-ray diffraction, X-ray photoelectron spectroscopy and temperature-programmed reduction techniques. Methane conversion varied in a large range depending on supports or Mn loading. Al2O3 supported 15% Mn catalyst exhibited better activity toward methane catalytic oxidation. The manganese state and oxygen species played an important role in the catalytic performance,     

负载型CeO2-ZrO2固溶体的性能及其在甲烷燃烧Pd催化剂中的应用

以硅改性的氧化铝为载体,用反相微乳液法合成了负载型的CeO2-ZrO2固溶体(Ce-Zr-O/Si-Al2O3),用低温氮吸附、X射线衍射、程序升温还原、拉曼光谱和x射线光电子能谱等方法对Ce-Zr-O/Si-Al2O3的织构性能、热稳定性和储放氧性能等进行了表征.结果表明,负载后的CeO2-ZrO2晶相与负载前相比没有变化,但热稳定性和在低温下的放氧能力及总储氧量明显提高.作为甲烷燃烧Pd催化剂的载体,Ce-Zr-O/Si-Al2O3的性能明显优于CeO2-ZrO2,Si-Al2O3和机械混合物CeO2-ZrO2 Si-Al2O3.使用0.2%Pd/10?-Zr-O/Si-Al2O3为催化剂时,甲烷90%转化率时的温度仅为345℃,比负载在其它载体上的Pd催化剂低175℃.     

Study on the active sites of Cu-ZSM-5 in trichloroethylene catalytic combustion with air

The catalytic activity of Cu-ZSM-5 in trichloroethylene （TCE） combustion increases with the increasing skeletal Cu amount and however decreases with the increase of surface amorphous CuO, which is detected by infrared spectroscopy （IR） and diffuse reflectance ultraviolet-visible spectroscopy （DRS-UV-vis）, therefore the skeletal Cu species are concluded to be the active sites for the TCE combustion.     

氧瓶燃烧-离子色谱法测定植株中硫和氯

采用氧瓶燃烧法对样品进行燃烧,然后用0.08mol.L-1碳酸钠-0.01mol.L-1碳酸氢钠-过氧化氢吸收液吸收释放出的氯化氢和三氧化硫,并提出了离子色谱法分离测定植株中硫和氯含量的方法。以Ionpac AS14A(4mm×250mm)离子交换柱,以0.008mol.L-1碳酸钠-0.001mol.L-1碳酸氢钠溶液为淋洗液等度洗脱。硫和氯的方法检出限(3S/N)分别为0.04mg.L-1和0.02mg.L-1。方法用于大米(GSB-1S)、黄豆(GSB-4S)、菠菜(GSB-6S)和圆白菜(GSB-5S)标准样品的分析,测定值与认定值相一致,硫和氯的相对标准偏差(n=5)分别为3.1%和4.2%,回收率分别为97.0%和93.8%。     

甲醇协助丙交酯开环聚合反应的理论研究

采用密度泛函理论在B3LYP/6-31G(d,p)水平上研究了甲醇协助的丙交酯开环聚合反应, 探讨了1~3个甲醇分子参与的丙交酯聚合反应机理, 考察了溶剂化效应对聚合反应的影响. 结果表明, 甲醇协助的丙交酯开环聚合按加成-消除机理进行; 甲醇分子作为质子给体与受体通过与丙交酯形成环状氢键促进开环聚合, 随着甲醇分子数的增加, 环状氢键的张力逐渐减小, 反应能垒随之降低; 溶剂化效应对反应机理和反应势垒的影响均可忽略不计.     

Studies on the pervaporation membrane of permeation water from methanol/water mixture

This investigation was performed to find if the nanometer SiO₂ added in the membranes can improve the pervaperation performance of the membranes. Acrylic acid (AA) and acrylonitrile (AN) were synthesized by solution polymerization with and without nanometer SiO₂. The copolymer solution was made into main body of the membranes, then composited with the polyvinyl alcohol (PVA) acetal membranes, to make the three-layer sandwich composite pervaporation membranes. The structure and the performance of the membranes were characterized by scanning electron microscope (SEM), Fourier transform infrared spectroscopy (FT-IR), thermogravimetry (TG), dynamic themomechanical analysis apparatus (DMA) and mechanical property testing. Pervaporation experiments were carried out using these membranes to separate the mixtures of methanol/water over the complete concentration range 70–98%, and results showed that the selectivity of the membranes with nanometer SiO₂ had notable improvement. For the 98% mixture at 60 °C, the separate factor is up to 1458, which is improved more than 10 times compared to the membranes without nanometer SiO₂, the permeate flux is up to 325 g/(m² h). For the 70% mixture at 70 °C, the separate factor arrived at 12, the permeate flux is up to 7097 g/(m² h), which is improved more than 14 times compared to membranes without nanometer SiO₂. It was concluded that the pervaperation performance of the membranes can improve greatly by nanometer SiO₂.     

以切短多壁碳纳米管为载体制备高活性Pt/SCNT及PtRu/SCNT燃料电池催化剂

采用乙醇为助磨剂,利用球磨的方法将5-15μm长的多壁碳纳米管切短成长度约为200nm,并且分布较为均匀的短碳纳米管(SCNT).以SCNT为载体,采用有机溶胶法制得了含铂20%(w)的Pt/SCNT及PtRu/SCNT催化剂.实验发现:对于甲醇的阳极电氧化过程,以切短碳纳米管为载体的Pt/SCNT催化剂具有比相同条件制得的Pt/CNT催化剂高得多的催化活性,前者甲醇氧化峰电流密度是后者的1.4倍,并且远远高于商品的Pt/C催化剂.同时我们发现添加了钌的PtRu/SCNT具有比不含钌的催化剂更好的活性.采用X射线衍射(XRD)、透射电镜(TEM)、比表面积分析(BET)等方法对催化剂进行表征,结果表明,切短碳纳米管的晶相结构并未改变,但Pt/SCNT和PtRu/SCNT催化剂的比表面积和电化学活性得到了显著的提高.     

Fe/CexZr0.9-xLa0.1O1.95-Al2O3 整体式催化剂上的甲烷催化燃烧反应

 采用共沉淀法制备了一系列 CexZr0.9-xLa0.1O1.95-Al2O3 储氧材料 (其中 CexZr0.9-xLa0.1O1.95 与 Al2O3 的质量比为 1; x = 0, 0.3, 0.5, 0.7 和 0.9), 以其为载体, 制备了一系列负载铁基整体式催化剂. 考察了该系列催化剂催化甲烷燃烧反应性能, 并用低温 N2 吸附-脱附、储氧能力测试、X 射线衍射和 H2 程序升温还原等手段对载体和催化剂进行了表征. 活性测试结果表明, 当 x = 0.7 时, 催化剂活性最高, 可在 V(CH4) = 1% 和 50 000 h1 条件下使甲烷 465 oC 起燃, 615 oC 完全转化. CexZr0.9-xLa0.1O1.95-Al2O3 样品同时具有较高的储氧能力、较高的比表面积和抗热老化能力. 当 x = 0.5 和 0.7 时, 催化剂载体以 CeZrLaAlO 固溶体存在, 抗老化能力最好, 且 x = 0.7 时, 催化剂最易被还原.     

Ce掺杂的OMS-2催化剂上二甲醚催化燃烧性能的研究

通过氧化还原法合成了氧化锰八面体分子筛(OMS-2),而后浸渍负载一定量的Ce。采用TG-DSC、XRD、低温氮气吸附-脱附、TEM、FT-IR、Uv-vis、O2-TPD、H2-TPR以及XPS等技术对制备材料的结构和氧化还原性能进行了表征,考察了催化剂的二甲醚催化燃烧反应性能。结果表明,低掺杂量的Ce高度分散在OMS-2中;高含量时存在独立的CeO2。光谱测试结果表明,Ce的掺杂并未对OMS-2的晶型产生影响。XPS结果表明,Ce的掺杂会提高OMS-2中晶格氧的量。O2-TPD和H2-TPR结果表明,制备的催化剂具有比较丰富的氧物种,低温下易还原,因而在二甲醚催化燃烧中表现出了良好的催化活性和热稳定性。起燃温度在160℃左右,完全燃烧温度在170℃左右,反应产物仅有二氧化碳和水,并且反应后催化剂晶型保持不变,没有积炭产生。