Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Solid-phase epitaxy of CaSi2 on Si(1 1 1) and the Schottky-barrier height of CaSi2/Si(1 1 1)

Thin Ca films were evaporated on Si(1 1 1) under UHV conditions and subsequently annealed in the temperature range 200–650 °C. The interdiffusion of Ca and Si was examined by ex situ Auger depth profiling. In situ monitoring of the Si 2p core-level shift by X-ray photoemission spectroscopy (XPS) was employed to study the silicide formation process. The formation temperature of CaSi₂ films on Si(1 1 1) was found to be about 350 °C. Epitaxial growth takes place at T≥400 °C. The morphology of the films, measured by atomic force microscopy (AFM), was correlated with their crystallinity as analyzed by X-ray diffraction (XRD). According to measurements of temperature-dependent I–V characteristics and internal photoemission the Schottky-barrier height of CaSi₂ on Si(1 1 1) amounts to qΦ_Bn=0.25 eV on n-type and to qΦ_Bp=0.82 eV on p-type silicon.     

新疆玛纳斯湖水蒸发过程研究

本文依据Na^ ,K^ ,Mg^2 //Cl^-,SO4^2--H2O五元水盐体系相图，对新疆玛纳斯盐湖水进行原料分析、理论研究、25℃等温蒸发实验和自然蒸发实验，研究了该湖水蒸发过程中盐类的析出规律及湖水中各组分浓度变化的规律，为进行工艺实验及将来的综合开发利用提供了可靠依据。     

蕴涵代数与BCK代数

系统研究 Fuzzy蕴涵代数与 BCK代数之间的关系 ,给出 MV代数与 BCK代数之间的联系 ,建立正则 FI代数和对合 BCK代数的对偶代数     

A nilpotent Roth theorem

Let T and S be invertible measure preserving transformations of a probability measure space (X, ℬ, μ). We prove that if the group generated by T and S is nilpotent, then exists in L ²-norm for any u, v∈L ^∞(X, ℬ, μ). We also show that for A∈ℬ with μ(A)>0 one has . By the way of contrast, we bring examples showing that if measure preserving transformations T, S generate a solvable group, then (i) the above limits do not have to exist; (ii) the double recurrence property fails, that is, for some A∈ℬ, μ(A)>0, one may have μ(A∩T _-n A∩S ^{- n} A)=0 for all n∈ℕ. Finally, we show that when T and S generate a nilpotent group of class ≤c, in L ²(X) for all u, v∈L ^∞(X) if and only if T×S is ergodic on X×X and the group generated by T ^-1 S, T ^-2 S ²,..., T ^-c S ^c acts ergodically on X. Oblatum 19-V-2000 & 5-VII-2001?Published online: 12 October 2001     

On a conjecture of Cox and Katz

This note shows that a certain toric quotient of the quintic Calabi-Yau threefold in provides a counterexample to a recent conjecture of Cox and Katz concerning nef cones of toric hypersurfaces. Received: 8 February 2001; in final form: 17 September 2001 / Published online: 1 February 2002     

Sharp estimates in terms of moduli of smoothness for compound cubature rules

Summary In 1980 Dahmen-DeVore-Scherer introduced a modulus of continuity which turns out to reflect invariance properties of compound cubature rules effectively. Accordingly, sharp error bounds are derived, the existence of relevant counterexamples being a consequence of a quantitative resonance principle, established previously.     

A comparative study of the structure and crystallization of bulk metallic amorphous rod Pr60Ni30Al10 and melt-spun metallic amorphous ribbon Al87Ni10Pr3

Pr-based bulk metallic amorphous （BMA） rods （Pr60Ni30Al10） and Al-based amorphous ribbons （Al87Ni10Pr3） have been prepared by using copper mould casting and single roller melt-spun techniques, respectively. Thermal parameters deduced from differential scanning calorimeter （DSC） indicate that the glass-forming ability （GFA） of Pr60Ni30Al10 BMA rod is far higher than that of Al87Ni10Pr3 ribbon. A comparative study about the differences in structure between the two kinds of glass-forming alloys, superheated viscosity and crystallization are also made. Compared with the amorphous alloy Al87Ni10Pr3, the BMA alloy Pr60Ni30Al10 shows high thermal stability and large viscosity, small diffusivity at the same superheated temperatures. The results of x-Ray diffraction （XRD） and transmission electron microscope （TEM） show the pronounced difference in structure between the two amorphous alloys. Together with crystallization results, the main structure compositions of the amorphous samples are confirmed. It seems that the higher the GFA, the more topological type clusters in the Pr-Ni-Al amorphous alloys, the GFAs of the present glass-forming alloys are closely related to their structures.     

Novel model of FM-noise conversion in a UMZI using RF external phase modulation of lasers: Theoretical and experimental results

In this paper, we propose and demonstrate a new and original model for theoretical calculation and experimental measurement of the noise power spectral density (NPSD) in phase-modulated optical links. The phase modulation is operated in the RF frequency range by an external phase modulator. The NPSD is derived for the first time in interferometric systems, by considering all effects such as the 1/f FM noise of the laser and white noise applied to light from a 1550 nm DFB laser, with phase modulation. The results show for the first time the influence of the phase modulation index, modulation frequency and interferometric delay in the phase-to-intensity noise conversion. The experimental and simulation results of conversion of FM-noise to intensity noise in an optical link by considering the external RF phase modulation are shown with good agreement.