双8-羟基喹啉端开链冠醚金属络合物的光物理性质

设计合成了双8-羟基喹啉端的开链冠醚QP3Q,研究了金属离子铝或锌与其形成络合物的组成和发光性质,并测定了络合物的激发态寿命.这些络合物在溶液中有较高的荧光量子产率,所得到的络合物固体具有较强的蓝光发光性能.结果表明,有可能通过QP3Q与不同离子形成的络合物得到不同发光波长的发光材料.     

锚联膦,胺配体对胶体钯的配位俘获及其负载催化剂的催化性能

本文继采用含硫配体(-SH,-SR)对高分子保护金属胶体的配位俘获之后,采用锚联在SiO_2表面的较含硫配体配位能力弱的P,N配体分别与聚乙烯吡咯烷酮(PVP)保护的胶体钯在室温下反应,在P/Pd大于3.5,N/Pd大于7时,可以实施对保护金属胶体的配位俘获,证实了配位俘获法是一种具有普遍意义的方法,经原子吸收光谱分析,溶液中残留的金属钯的量小于0.36 ppm(P/Pd=3.5)。经电子能谱证实,锚联膦胺配体与金属钯之间存在配位作用,这是实施保护胶体负载化的关键。透射电镜分析表明,在整个配位俘获的过程中,无论是在载体上或是在溶液中,胶体钯的颗粒大小与分布均保持不变。因此,配位俘获法是一种能控制多相催化剂中金属颗粒大小与分布的有效方法。由此合成的钯催化剂具有很高的催化活性,良好的选择性和稳定性,在对Cis,Cis-1,3-环辛二烯的选择性加氢中,其活性仅比均相的PVP-Pd胶体催化剂稍低,选择性达100％。在周转数达12,000次/个钯原子后,其催化活性仍保持不变,随着P/Pd比的增大,催化活性迅速下降。     

Thermochemistry of adducts of some bivalent transition metal bromides with 4-chloroaniline

The compounds [MBr₂(p-clan)₂] (where M is Mn(II), Fe(II), Co(II), Ni(II), Cu(II) or Zn(II); p-clan = 4-chloroaniline) were synthesized and characterized by melting points, elemental analysis, thermal analysis and electronic and IR spectroscopy. The enthalpies of solution of the adducts, metal(II) bromides and 4-chloroaniline in methanol, 1.2 M aqueous HCl or 25% (v/v) 1.2 M aqueous HCl in methanol were measures and by using thermochemical cycles, the following thermochemical parameters for the adducts have been determined: the standard enthalpies for the Lewis acid/base reactions (Δ_rH°), the standard enthalpies of formation (Δ_fH°), the standard enthalpies of decomposition (Δ_DH°), the lattice standard enthalpies (Δ_MH°) and the standard enthalpies of the Lewis acid/base reactions in the gaseous phase (Δ_rH°(g)). The mean bond dissociation enthalpies of the metal(II)-nitrogen coordinated bonds and the enthalpies of adduct formation in the gaseous phase have been estimated.     

Speciation of chromium in waste waters by coupled column ion chromatography-inductively coupled plasma mass spectrometry

An application of coupled column ion chromatography (IC)-inductively coupled plasma mass spectrometry (ICP-MS) is presented for speciation of chromium in waste waters. By coupling an anion column with a cation column, both the cationic Cr(III) and anionic Cr(VI) species can be analyzed with detection limits below 0.5 μg/1. The separation of the interfering ions (chloride, chlorate, perchlorate, sulphate, sulphite, sulphide, thiosulphate, carbonate, cyanide and some organic compounds) from the chromium peaks is discussed, and the use of different chromium isotopes for data acquisition is compared. Based on the results, m/z 52 was considered as an ideal isotope for speciation of chromium in waste waters by the coupled column IC-ICP-MS, because it did not suffer from polyatomic interferences and due to the high sensitivity for chromium. The analysis of the waste water samples should be performed as soon as possible after sampling according to the stability tests of the species.     

K3MnH5, das erste salzartige Manganhydrid

K₃MnH₅, the First Salt-like Manganese Hydride K₃MnH₅ and K₃MnD₅ were synthesized by the reaction of potassium hydride (deuteride) with manganese powder under a hydrogen pressure above 3000 bar at 875 K. X-ray investigations on powdered samples and elastic neutron diffraction experiments on the deuterated compound at the time-of-flight spectrometer LAD in the temperature range 5–600 K led to the complete structure determination. The atomic arrangement is isotypic with that of Cs₃[CoCl₄]Cl (space group: 14/mcm, Z = 4). The structure of K₃MnH₅ contains isolated [MnH₄]^2?-tetrahedra and additional hydrogen ions which are exclusively coordinated by potassium cations. The magnetic susceptibilities show Curie-Weiss behaviour. At temperatures below 50 K there are obviously antiferromagnetic interactions.     

用4,4‘—壬二酰基—双（1—苯基—3—甲基—吡唑酮—5）萃取分离钍

本文研究了标题试剂(简称H_2A)与Th(Ⅳ)的络合作用及萃取行为,考查了H_2A对Fe(Ⅲ)、Co(Ⅱ)、Ni(Ⅱ)、Zn(Ⅱ)、Pb(Ⅱ)、Cu(Ⅱ)、La(Ⅲ)、Yb(Ⅲ)和U(Ⅵ)的萃取作用,试验了它对Th(Ⅳ)与上述元素及Ca(Ⅱ)、Mg(Ⅱ)、Cr(Ⅲ)、In(Ⅲ)、V(Ⅴ)、Zr(Ⅵ)的分离效果。     

Synthesis and Characterization of Core‐Shell Selenium/Carbon Colloids and Hollow Carbon Capsules

A novel Se/C nanocomposite with core‐shell structures has been prepared through a facile one‐pot microwave‐induced hydrothermal process. The new material consists of a trigonal‐Se (t‐Se) core and an amorphous‐C (a‐C) shell. The Se/C composite can be converted to hollow carbon capsules by thermal treatment. These products were characterized by transmission electron microscopy (TEM), powder X‐ray diffraction (XRD), scanning electron microscopy (SEM), selected area electron diffraction (SAED), energy‐dispersive X‐ray (EDX) spectroscopy, and X‐ray photoelectron spectroscopy (XPS).     

Insight into the extractability of metals from soils using an implementation of the linear adsorption isotherm model

This paper deals with an often overlooked artifact in sequential and single extraction of metals from soils, viz. the volume to mass (V/m) ratio as a potential source for inadequate extraction yields. We offer a theoretical framework to get a grip on this intricate parameter and came up with a model based on a linear adsorption isotherm to derive the correct maximal metal extractability for a certain extractant. We verified the model experimentally using 0.1 mol l⁻¹ nitric acid for extraction of seven metals (Cr, Co, Cu, Cd, Pb, Ni and Zn) from an urban soil sample, and concluded that commonly used V/m ratios in the range of 10-40 ml g⁻¹ may give as much as 50% too low extraction yields. Thus, a strong caveat is in place as to be very critical what V/m ratios to use and preferably apply the model derived to obtain the correct maximal extractability using a variable V/m ratio method.     

Synthesis and chelation properties of new polymeric ligand derived from 8-hydroxy-5-azoquinoline hydroxy benzene

8-Hydroxy-5-azoquinoline phenyl methacrylate-formaldehyde (8H5AQPMA-F) macromonomer was prepared from methacryloyl chloride with condensation products of 8-hydroxy-5-azoquinoline phenol-formaldehyde, and polymerized in DMF at 70 °C using benzoyl peroxide as free radical initiator. Poly(8H5AQPMA-F) was characterized by infrared and nuclear magnetic resonance spectroscopic techniques. Polychelates were obtained when the DMF solution of the resin containing few drops of ammonia was treated with the aqueous solution of Cu(II)/Ni(II). Elemental analysis of the polychelates indicates that the metal to ligand ratio was about 1:2. The IR spectra of polychelates suggest that the metals were coordinated through the oxygen of the phenolic-OH group and nitrogen of the quinoline ligand. The DRS and magnetic moment data indicate a square planar for Cu(II) complex whereas octahedral for Ni(II) complex. The TGA data revealed the thermal stability of the resin and the polychelates. X-ray diffraction study revealed the incorporation of the metal ions significantly enhanced the degree of crystallinity. The sorption properties of the chelate-forming resin towards various divalent metal ions [Cu(II) and Ni(II)] were studied as a function of pH and electrolyte.     

Effect of HF addition on the microwave-assisted acid-digestion for the determination of metals in coal by inductively coupled plasma-atomic emission spectrometry

The microwave-assisted acid-digestion for the determination of metals in coal by ICP-AES was investigated, especially focusing on the necessity of adding HF. By testing five certified reference materials, BCR-180, BCR-040, NIST-1632b, NIST-1632c, and SARM-20, it was found that the two-stage digestion without HF (HNO₃ + H₂O₂ was used) was very effective for the pretreatment of ICP-AES measurement. Both major metals (Al, Ca, Fe, and Mg) and minor or trace metals (Co, Cr, Cu, Mn, Ni, Pb, and Zn) in coal gave good recoveries for their certified or reference values. The possibility of ‘HF-memory effect’ was cancelled by the use of a set of vessels which had been never contacted with HF. Twenty-four Japanese standard coals (SS coals) were analyzed by the present method, and the concentrations of major metals measured by the present method provided very high accordance with those from the authentic JIS (Japanese Industrial Standard) method.