LES of spatially developing turbulent boundary layer over a concave surface

We revisit the problem of a spatially developing turbulent boundary layer over a concave surface. Unlike previous investigations, we simulate the combined effects of streamline curvature as well as curvature-induced pressure gradients on the turbulence. Our focus is on investigating the response of the turbulent boundary layer to the sudden onset of curvature and the destabilising influence of concave surface in the presence of pressure gradients. This is of interest for evaluating the turbulence closure models. At the beginning of the curve, the momentum thickness Reynolds number is 1520 and the ratio of the boundary layer thickness to the radius of curvature is δ₀/R = 0.055. The radial profiles of the mean velocity and turbulence statistics at different locations along the concave surface are presented. Our recently proposed curvature-corrected Reynolds Averaged Navier-Stokes (RANS) model is assessed in an a posteriori sense and the improvements obtained over the base model are reported. From the large Eddy simulation (LES) results, it was found that the maximum influence of concave curvature is on the wall-normal component of the Reynolds stress. The budgets of wall-normal Reynolds stress also confirmed this observation. At the onset of curvature, the effect of adverse pressure gradient is found to be predominant. This decreases the skin friction levels below that in the flat section.     

高次谐波辐射发射特性研究

报告由不同脉冲宽度(半高宽,FWHM)和不同载波-包络相位(CEP,Φ)的激光产生的高次谐波辐射能量输出时间特性即发射特性的研究结果. 计算表明,由宽度为几个周期的激光产生的高次谐波辐射的截止能量明显低于由无限长脉冲宽度激光产生的截止能量ω_max=3.17U_p+I_p(其中ω_max为光子角频率,U_p和I_p分别为激光有质动力势和原子的电离能). 例如,由两周期(FWHM),Φ＝15°的激光产生的高次谐波辐射的截止能量为ω_max=2.90U_p+I_p,此时发射特性单脉冲(即分布单脉冲)具有最大的能量带宽0.86U_p. 脉冲中心位置的载波相位和时间宽度分别为0.94rad(弧度)和1.29rad. 而该激光脉冲在Φ＝-75°时能产生截止能量为ω_max=2.70U_p+I_p,最大能量带宽为0.70U_p的双分布脉冲,其中心位置分别为-0.58rad和2.43rad,宽度分别为1.22rad和1.33rad. 随着激光脉冲宽度的增加,分布单脉冲的能量带宽比时间宽度下降得更快. 对于一定宽度的激光脉冲,所产生的分布单脉冲的能量带宽和时间宽度的CEP依赖性显示出180°的周期结构. 利用这个有趣的特点,在实验上可以通过调节CEP来选择分布脉冲的能量参数,也可用来定位和控制阿秒脉冲的时间参数. 理论分析指出,只要选择合适的阿秒X射线能量带宽,CEP不稳定性对于光电子谱和测量结果的影响将大为降低,甚至在最大程度上消除这种影响. 这些研究结果不仅有助于在物理上深入了解高次谐波辐射的动力学过程,而且对于进一步在实验上优化和选择阿秒单脉冲和双脉冲具有重要的参考和指导意义. 关键词： 高次谐波产生 鞍点方法 谐波发射特性 分布脉冲     

优化两色组合场参数获得单个阿秒脉冲

基于经典方法优化了组合场中基频场和低频场的强度比,利用优化后的组合场驱动一维氦原子,通过求解含时薛定谔方程研究了氦原子产生的高次谐波,其截止位置得到扩展,再考虑基频场初相位对产生高次谐波的影响,能够得到脉宽为37as的单个阿秒脉冲.     

表面垂直裂痕诱发瑞利波散射的数值分析

激光激发的声表面波为材料表面缺陷的检测提供了有力的工具.针对含缺陷材料在模型边界上的复杂性,建立了基于平面应变的有限元模型并选取了相同厚度但含有不同深度的表面裂痕的单层铝板进行了对比计算,得到了声表面波经过不同深度的表面裂痕时产生的反射及透射信号波形的时域特征.进而引入了基于Wigner-Ville分布理论的时-频分析方法计算裂痕前、后散射的瞬态表面波的能量在时间-频率平面内分布的情形.结果显示：声表面波接近中心频率的某一频率成分在经过深度小于其中心波长的表面缺陷时,随着裂痕深度的增加,对应于该频率的反射系数呈现单调递增的趋势;而透射系数呈现递减的特征,这一结果可以为激光超声检测表面缺陷提供一种定量的表征手段.     

环形浅液池内热毛细对流的热力学特性

为了了解径向温度梯度作用下环形浅液池内硅熔体热毛细对流的热力学特性,利用有限差分法进行了非稳态三维数值模拟。液池外半径r0=50 mm,内半径ri=15 mm,深度为d=3 mm。结果表明,当温度梯度较小时,流动为稳定轴对称流动,系统总熵产较小;随着温度梯度的增加,流动将失去其稳定性,首先转化为径向脉动波,此时系统总熵产呈周期性变化;温度梯度再增加时,流动转化为热流体波,系统总熵产较大,但不再随时间变化。     

驻波型热声制冷机熵产分析

声制冷机是一种新型制冷机,具有无机械运动部件,可靠性高寿命长,采用惰性气体为工质无污染等优点．驻波型热声制冷机的声功泵热效应是不可逆过程,内部不可逆损失导致热声制冷机效率偏低,制约了热声制冷机的发展和应用．本文研究了线性范围内驻波型制冷机换热器和回热器内的可压缩振荡流动与传热过程的熵产,分析了板间距,振荡频率和温度梯度对熵产的影响。     

相干叠加态高次谐波发射的时间行为分析

本文研究了一维模型分子离子(初态为基态和一个激发束缚态叠加的相干态)在超强超短激光脉冲作用下的谐波发射谱.我们发现在高次谐波谱平台区域出现了周期性的结构变化.我们利用小波变换对谐波谱进行了暂态时间频率分析,结果表明该谐波结构产生的原因是由电离电子返回母离子时与不同束缚态复合而产生的谐波光脉冲之间相干叠加.同时采用半经典计算,对所得到的计算结果进行了分析,验证了我们的结论.     

二次谐波中大相位失谐下入射啁啾脉冲对相位的影响

讨论了在大相位失谐下,基波为频率啁啾脉冲的二次谐波产生过程,结果表明选取合适的啁啾参量可以使二次谐波的光强提高,但同时会使其波形和相位发生变化.三波相位的畸变主要取决于入射的基波啁啾脉冲,而与相位匹配的失谐量关系不大.     

Efficient second, third, fourth, and fifth harmonic generation of a Yb-doped fiber amplifier

We report generation of the second, third, fourth, and fifth harmonics of the output of a Yb-doped fiber amplifier seeded by a passively Q-switched Nd:YAG microchip laser. We obtained high conversion efficiencies using a simple optical arrangement and critically phase-matched nonlinear crystals. Starting with 320 mW of average power at 1064 nm (86 μJ per pulse at a 3.7 kHz repetition rate), we generated 160 mW at 532 nm, 38 mW at 355 nm, 69 mW at 266 nm, and 18 mW at 213 nm. The experimental results are in excellent agreement with calculations.     

Probing buried interfaces with non-linear optical spectroscopy

The importance of buried interfaces in our everyday lives and in current scientific research is highlighted, along with experimental difficulty associated with studying such systems. We present an overview of the application of second harmonic generation and sum-frequency spectroscopy to the study of buried interfaces. Several examples from the current literature are presented, ranging from chemical and biological, to electrical and magnetic interfaces. The importance of this work in the context of ongoing research in these areas is discussed. Finally, we provide a snapshot of the state of the art in non-linear optical spectroscopy by mentioning several new directions that are likely to have a large impact on future research into the physics and chemistry of buried interfaces.