The origin of spectral distortion in electric field modulation spectroscopy based on scanning tunneling microscopy

Electric field modulation spectroscopy using scanning tunneling microscopy (STM-EFMS) measurements were performed for a Si(1 1 1) surface with epitaxially-grown β-FeSi₂ islands. STM-EFMS spectra acquired around the indirect energy gap of Si reproduced the photon energy peak position observed in conventional macroscopic EFMS experiments. However, a considerable discrepancy was found in the energy position of the accompanying spectral dip. We examined two possibilities for the cause of this discrepancy. The first interpretation is that the STM-‘EFMS’ spectra may simply reflect the local density of states based on essentially the same principle as that of tunneling spectroscopy. However, this interpretation is ruled out by the facts that almost identical STM-EFMS spectra are obtained also out of the regime of tunneling. The second interpretation is a spectral distortion due to a large electric field steadily built in the sample surface, which is supported experimentally by a spectral shift of the dip energy that is induced by altering the tip-induced band bending.     

The influence of fiber dispersion on the code form of the optical mm-wave signal generated by single sideband intensity-modulation

We have theoretically investigated the transmission performance of the optical mm-wave generation by using an external modulator based on single sideband (SSB) intensity modulation. Though the SSB millimeter (mm)-wave can immune the fading effect, the baseband signals with a high bit rate are degraded greatly after transmission along fiber. The main reason is that the fiber dispersion causes the time shift of the code edges; therefore the maximum transmission distance of the baseband signals is limited. The experimental and simulation results agree well with our theoretical analysis. We also propose a novel scheme to extend the transmission distance. In this novel scheme, the data signals are modulated only onto one of the two optical carriers; hence the shift of the code edges in the down-converted signals after transmission is eliminated.     

In situ calibration of a Michelson type, speckle-shearing interferometer: Wobbling mirror effect

In situ calibration of piezoelectric transducers in a phase stepping, Michelson type, speckle-shearing interferometer can be affected by mirror wobbling introduced by the transducers. When this happens, a modulation of the curves employed for calibration can be readily detected in imaging systems with large apertures. A calibration method that takes into account the modulation of these curves is, therefore, essential to insure the required regularity of the phase steps. A computer model of speckle-shearing interferometry is used to deal with piezoelectric non-linearities and mirror wobbling in the interferometer, and to show how the calibration curves are affected when both phenomena are present. Computer simulated and experimental results validate the calibration technique advanced here.     

Synthesis and reconstruction of computer generated holograms by a double pass technique on a twisted nematic-based liquid crystal spatial light modulator

Achieving phase only modulation from a spatial light modulator (SLM) is useful for many optical processing tasks. In this paper, we demonstrate a simple method of decoupling phase and amplitude modulation in a twisted nematic liquid crystal (TNLC) SLM using a double pass technique. A Jones calculus model is developed which matches our experimental data.     

干涉测量用半导体激光器驱动电源

设计了一种可调制的高稳定度半导体激光器驱动电路。该电路的直流稳定度高达1.5×10-5，输出电流在0～200mA内连续可调，长时间工作（12h以上）电流变化小于1μA；在直流基础上注入100kHz～300kHz的调制电流，其调制深度为0～100mA连续可调，可实现在激光干涉测量中对光波频率和光波强度的调制。将该电路驱动的光栅外腔半导体激光器和辅助温度控制电路应用于光干涉测量技术中，得到了功率稳定、波长单一的激光输出，解决了激光器的跳模现象，完成了对远距离微小振动（纳米量级）的测量。     

Steepest-descent method-based adaptive frequency domain equalizer in coherent optical orthogonal frequency division multiplexing with quadrature phase shift keying modulation

An adaptive frequency domain equalizer (A-FDE) in quadrature phase shift keying-coherent optical-orthogonal frequency division multiplexing (QPSK-CO-OFDM) system is proposed in this paper. A-FDE uses steepest descent method to search the optimal equalization parameters. And through applying the adaptive control factor (ACF) to monitor the state of A-FDE, the interference from phase noise (PN) and chromatic dispersion (CD) can be mitigated. The numerical simulation shows that the performance of A-FDE has a remarkable improvement on combating PN and CD comparing with the conventional decision-directed equalizer (DDE). And the A-FDE can achieve the forward-error-correction (FEC) threshold in noisier scenario. Furthermore, because the calculation of ACF only bases on valid data instead of pilot symbols (PSs), A-FDE has low PS overhead merit.     

Broadening-independent demodulation for wavelength modulation spectroscopy based on even-order harmonics

The line broadening of gas absorption spectrum is a significant but unknown factor in traditional demodulation of wavelength modulation spectroscopy, which is a kind of tunable diode laser absorption spectroscopy in weak absorption cases. In this paper, another signal demodulation method based on some simple algebraic operations with the amplitudes of the zero-, second-, and fourth-order harmonics was proposed. With this method the effect of spectrum broadening could be selfeliminated. That makes the amplitude of the demodulated signal is irrelevant to the broadening, and enables the direct and fast measurement without complex simulations and curve fittings in traditional method.     

Intermodulation of transverse magnetoresistance oscillations in structures with strong intersubband interaction

In the Shubnikov–de Haas oscillation spectrum of doped InAs/AlSb structures, high-amplitude peaks are established at combination frequencies. It is demonstrated that they are caused by a significant contribution of intersubband scattering to the processes of electron-electron interaction. Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 12, pp. 32–38, December, 2008.     

Generation and transmission of the double-sideband optical millimeter-wave with signal carried only by optical carrier

In this paper, we have proposed a new scheme to generate double-sideband (DSB) optical millimeter-wave (mm-wave) with signal carried only by optical carrier, and its transmission performance is investigated. The theoretical and numerical results show that the DSB optical mm-wave signal generated by our scheme suffers only from the fading effect, the time shift of the sidebands has little influence on its transmission performance. The signal demodulated from the harmonic photocurrent shows a clear and open eye diagram and has good performance even if the transmission distance is very close to but not just at the fading nodes. The theoretical results are in good agreement with our numerical simulation.     

XPM-induced intensity distortion due to dispersion in fibre Bragg grating filters

We investigate the conversion of cross-phase modulation (XPM) to intensity distortion due to dispersion in fibre Bragg grating (FBG) filters. We find that there can be significant XPM-induced intensity distortion, especially near the edges of the filter passband where the in-band dispersion is increasingly pronounced. Since FBG filter dispersion occurs above and beyond that in standard single-mode fibre, this enhances XPM-induced intensity distortion arising from dispersion and should be accounted for in system design.