Slow crack growth in blends of HDPE and model copolymers

The resistance to slow crack growth (SCG) was measured in binary blends of high density polyethylene (HDPE) and 5–10% concentrations of model ethylene-butene random copolymers by measuring the time to failure (t_f) under a constant stress intensity. An increase of t_f with the addition of the copolymer if the copolymer could crystallize and the increase was greater the higher branch density. The copolymer with 117 branches/1000C could not crystallize and therefore its blend had a t_f that was less than that of the HDPE. The fracture energies of the blends as determined by their resistance to SCG were compared with the energy by rapid fracture, J_c, as previously measured by Rhee and Crist. It is concluded that SCG is more sensitive to variations in the microstructure than is rapid fracture and that the differences in SCG behavior can be qualitatively explained in terms of the differences in microstructure of the blends. ©1995 John Wiley & Sons, Inc.     

微型硅谐振式力传感器的振动分析

介绍了谐振式力传感器的工作原理，并从理论上和实验上对中科院合肥智能所研制的第一代微型硅谐振梁（３×０．４×０．０４５ｍｍ＾３）式测力传感器进行了全面的振动分析，所得结构为其进一步优化设计提供了科学根据，文中使用的实验分析方法，为其它微小物体的动态和识别提供了一条有效途径。     

PHASE INVERSION AND ITS MECHANICAL MODEL STUDIES FOR THE TWO-PHASE POLYMER BLEND SYSTEMS (Ⅱ)——DYNAMIC VISCOELASTIC RESPONSE

The dynamic viscoelastic response of the two-phase polymer blend systems shows the characteristics of the thermorheologically complex materials. In this paper theoretical equations for describing the dynamic viscoelastic response of such polymer blend systems have been established by means of the mechanical modeling technique. The dynamic viscoelastic response of the blend systems at any blend composition can be predicted theoretically by using the equations established, provided that the dynamic viscoelastic response of the two pure components and the mechanical model parameters are known in advance. Thus, we provide an effective method for studying the dynamic mechanical properties and the molecular relaxation characteristics of the two-phase polymer blend systems.     

三磷酸胞苷在Duolite A-30树脂上的交换过程研究

根据CTP在离子交换树脂上的吸附容量和分离因数的大小,确定Duolite A-30树脂适合CTP与CDP,CMP之间的分离.对CTP在Duolite A-30树脂上的吸附动力学和热力学研究表明,在283.15K~303.15K之间,CTP的质量浓度在7.5g/L以上时,Duolite A-30树脂对CTP的吸附主要受颗粒扩散的控制,其有效扩散系数为D=3.47×10-7cm2/s,溶液的质量浓度≤1.0g/L时,CTP与Duolite A-30树脂之间的交换速率主要受液膜控制,其液膜扩散系数为Kf =4.112×10-4/s.同时测定了不同条件下三磷酸胞苷溶液在Duolite A-30树脂固定床离子交换柱中的穿透曲线,研究了进口浓度、进口流速、原料液温度、原料液的pH值及柱高对穿透曲线的影响.用二阶动力学推动力模型描述固定床动态过程,考察了轴向返混对穿透曲线的影响,并从穿透曲线回归得到总传质系数,模型计算值与实验数据符合良好.     

A Biokinetic Model to Describe Consequences of Inhibition/Stimulation in DNA-Proofreading and -Repair,Part 2. Calibration of the Model

Summary.  A biokinetic model has been developed to describe the mathematical consequences of inhibition, respectively stimulation of proofreading. According to data reported in the literature, a first approximative calibration of the model has been carried out in an attempt to make it both: practically applicable and comparable with experimental data and clinical facts. The model is open for further improvements and adjustable according to results of further researches via the parameters chosen. In a first test of the model it is shown that it does well reflect the results described in the literature upon proof-reading-inhibition and its consequences, i.e., the reduction of replication-fidelity (→ exponential increase of malignant cells with time). As a further result it is shown that the model also does well describe in its kinetic approach opposite effects as, e.g., a reduction of wrong genetic information by classical cancer-therapies like chemotherapy and surgergy. The system is orientated towards known biochemical relations and chemical similarities together with a discussion of the potential chance which offer special combinations of chemically identifyable substances (like nucleotides’ precursors or effector-molecules contained in low-molecular-human-placenta-extracts as an alternative to umbilical cords’-blood/cells) as stimulators of the enzymatic proof-reading- and -repair-machinery. E-mail: Haschke.H@isovolta.com Received January 20, 2002; accepted (revised) June 26, 2002     

Degradation of ²-O-4 lignin model and related compounds by the ascomyceteChrysonilia sitophila (TFB 27441 strain)

Growth of the ascomyceteChrysonilia sitophila during degradation of lignin model dimers and monomers was compared to a glucose control. An inhibition of growth by Cα-carbonyl monomers and stimulation by β-O-4 lignin model and vanillyl alcohol were observed. A comparison of the degradation by this ascomycete with the basidiomycetePhanerochaete chrysosoporium showed similarities in relation to the type of degradation caused.     

Photophysical aspects of single-molecule detection by two-photon excitation with consideration of sequential pulsed illumination.

An important goal in single molecule fluorescence correlation spectroscopy is the theoretical simulation of the fluorescence signal stemming from individual molecules and its autocorrelation function. The simulation approaches developed up to now are based exclusively on continuous-wave (cw) illumination and consequently on cw-excitation. However, this approximation is no longer valid in the case of two-photon excitation, for which pulsed illumination is usually employed. We present a novel theoretical model for the simulation of the fluorescence signal of single molecules and its autocorrelation function with consideration of the time dependence of the excitation flux and thus of all illumination-dependent photoprocesses: two-photon excitation, induced emission and photobleaching. Further important characteristics of our approach are the consideration of the dependence of the photobleaching rate on illumination and the low intersystem-crossing rates of the studied coumarins. Moreover, using our approach, we can predict quantitatively the effect of the laser pulse width on the fluorescence signal of a molecule, that is, the contributions of the photobleaching and saturation effects, and thus we can calculate the optimal laser pulse width. The theoretical autocorrelation functions were fitted to the experimental data, and we could ascertain a good agreement between the resulting and the expected parameters. The most important parameter is the photobleaching constant sigma, the cross section of the transition Sn<--S1, which characterises the photostability of the molecules independent of the experimental conditions. Its value is 1.7 x 10(-23) cm2 for coumarin 153 and 5 x 10(-23) cm2 for coumarin 314.     

An Electrostatic Bond Energy Model for Enthalpies of Formation of Chloroalkanes in Gaseous States

An electrostatic bond energy model is formulated to fit the enthalpies of formation and dipole moments of the alkanes and chloroalkanes. In this model, the charge distributions are calculated by an electrostatic approach similar to the "MSE" method, and the enthalpy of formation of a molecule is the sum of the bond energy terms plus the electrostatic energy of the interactions between the charges on all atoms. All parameters of this model are obtained by parameterization. The calculated dipole moments for 13 chloroalkanes and enthalpies of formation for 19 alkanes and non-geminal chloroalkanes agree with the determined values very well. To calculate the enthalpies of formation of geminal chloroalkanes, a correction mainly attributed to the van der Waals interactions in the geminal substituted group, about 24 kJ/mol per pair of geminal chlorine atoms, is introduced.     

New Monte Carlo method for the self-avoiding walk

We introduce a new Monte Carlo algorithm for the self-avoiding walk (SAW), and show that it is particularly efficient in the critical region (long chains). We also introduce new and more efficient statistical techniques. We employ these methods to extract numerical estimates for the critical parameters of the SAW on the square lattice. We find=2.63820 ± 0.00004 ± 0.00030=1.352 ± 0.006 ± 0.025v=0.7590 ± 0.0062 ± 0.0042 where the first error bar represents systematic error due to corrections to scaling (subjective 95% confidence limits) and the second bar represents statistical error (classical 95% confidence limits). These results are based on SAWs of average length 166, using 340 hours CPU time on a CDC Cyber 170–730. We compare our results to previous work and indicate some directions for future research.     

Semiclassical study of collision-induced predissociation: Comparison of the Landau-Zener model with the method of analytic continuation

Semiclassical calculations are carried out by two methods for the problem of collision-induced predissociation of electronically excited I₂. The first method is that of surface-hopping with the Landau-Zener model. The second method is similar to surface-hopping, except that analytic continuation of the adiabatic potential energy surfaces replaces the Landau-Zener model. Results of the calculations by the two methods compare favorably with each other and with experiment. The possible advantages of the second method are discussed.Camille and Henry Dreyfus Teacher-Scholar, Alfred P. Sloan Research Fellow.