Effect of the Structure of Nonuniform Conducting Polymer Films on Their Electrochemical Impedance Response

Electrochemical impedance spectroscopy is used to characterize thin p-doped polypyrrole (PPy) films in propylene carbonate (PC) solutions and poly(trifluorophenyl)thiophene (PTFPT), in solutions based on sulfolane (SF). It appears that the latter film is much less swelled compared to the former one. One consequence of this difference is that the PTFPT film shows a much higher bulk resistance compared to that for the PPy film. Another important consequence is that the swelling of the PTFPT film is essentially physically non-homogeneous. Two parallel, uncoupled paths, with different chemical diffusion coefficients, model the experimental results adequately. In order to quantify the impedance spectra for both polymer films, we use a model proposed by Rubinstein et al. explaining the difference in the diffusion coefficients of Ru(bpy)^3+/2+ ₃ within a thin Nafion film. The model can also predict the impedance spectra for composite powdery electrodes containing different particle sizes, such as composite cathodes and graphite anodes used in lithium batteries.     

Quo Vadis total reflection X-ray fluorescence?

The multielement trace analytical method ‘total reflection X-ray fluorescence’ (TXRF) has become a successfully established method in the semiconductor industry, particularly, in the ultra trace element analysis of silicon wafer surfaces. TXRF applications can fulfill general industrial requirements on daily routine of monitoring wafer cleanliness up to 300 mm diameter under cleanroom conditions. Nowadays, TXRF and hyphenated TXRF methods such as ‘vapor phase decomposition (VPD)-TXRF’, i.e. TXRF with a preceding surface and acid digestion and preconcentration procedure, are automated routine techniques (‘wafer surface preparation system’, WSPS). A linear range from 10⁸ to 10¹⁴ [atoms/cm²] for some elements is regularly controlled. Instrument uptime is higher than 90%. The method is not tedious and can automatically be operated for 24 h/7 days. Elements such as S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Br, Sn, Sb, Ba and Pb are included in the software for standard peak search. The detection limits of recovered elements are between 1×10¹¹ and 1×10⁷ [atoms/cm²] depending upon X-ray excitation energy and the element of interest. For the determination of low Z elements, i.e. Na, Al and Mg, TXRF has also been extended but its implementation for routine analysis needs further research. At present, VPD-TXRF determination of light elements is viable in a range of 10⁹ [atoms/cm²]. Novel detectors such as silicon drift detectors (SDD) with an active area of 5 mm², 10 mm² or 20 mm², respectively, and multi-array detectors forming up to 70 mm² are commercially available. The first SDD with 100 mm² (!) area and integrated backside FET is working under laboratory conditions. Applications of and comparison with ICP-MS, HR-ICP-MS and SR-TXRF, an extension of TXRF capabilities with an extremely powerful energy source, are also reported.     

Conducting polymer membranes for low activity potentiometric ion sensing

Conducting polymer (CP) films, used as ion-sensing membranes under open circuit potentiometric conditions, are usually characterised with rather high detection limit, in the range of 10⁻⁴-10⁻⁵ mol dm⁻³. This effect is unfavourable, not only from the point of view of CP applications in potentiometry as ion sensitive membranes, but also when these materials are used as ion-to-electron transducers (solid contacts) for ion-selective electrodes. The theoretical considerations presented underline the crucial role of spontaneous processes of polymer charging/discharging—the source of observed high detection limit of sensors comprising CP layer under zero current conditions. Although the mechanism of occurring process is different from that observed for plastic, solvent polymeric based ion-selective electrodes, the ultimate result—alteration of activity of electrolyte at the membrane/solution interface leading to elevation of the detection limit—is the same.The method of estimation of parameters characterising spontaneous charge transfer processes is presented. The values obtained can be used to calculate the resulting polymer/solution interface activity of electrolyte ions, thus the detection limit of CP membrane can be theoretically predicted.A method of lowering of the detection limit of conducting polymer membranes, applying galvanostatic polarisation to compensate the spontaneous process of polymer charging/discharging, is presented.The experimental results obtained for poly(pyrrole), poly(N-methylpyrrole) and poly(3,4-ethylenedioxythiophene) are in good accordance with predictions of the presented model.     

氧原子在Pt低指数面上的吸附和振动

应用原子和表面簇合物相互作用的5参数Morse势方法（简称5-MP）对O-Pt低指数表面体系进行了研究,并获得了全部临界点特性.计算结果表明,氧原子在Pt(100)面上只存在四重吸附态.在缺行重构的(110)面上,氧原子仍吸附于三重位,随着覆盖度的增加还会嵌切吸附于长桥位;通过分析三重态振动指纹性质的遗传和遗变,确认实验观察到的59.49和40.90 meV损失谱分别为氧原子在三重位和长桥位吸附态的表面垂直振动.     

小功率空气冷却ICP-AES 研究I——小功率空气冷却ICP的特性

本文用顺序等离子体光谱仪研究了27.12MHz他激式R.F.发生器点燃的小功率空气冷却ICP的特性。测量并比较了二十个元素五十七条谱线在空气冷却和氩冷却两种ICP中的检测限。     

靛红掺杂聚吡咯膜修饰电极的电荷传输

利用交流阻抗法研究了靛红掺杂聚吡咯膜内的电荷传输，通过非线性最小二乘法拟合，得出了体系的等效电路，并计算出其电荷扩散系数和异相电子传递反应速率常数。实验结果表明，随着膜厚的增加，活性点增多，异相电子传递反应速率常数增大，同时表观扩散系数也增大。     

Electrochemical Impedance Analysis of Thermogalvanic Cells

Thermogalvanic cells(also known as thermo-electrochemical cells) that convert waste heat energy to electricity are a new type of energy conversion device. However, the electron transfer kinetics and mass transfer of redox couples have not been thoroughly studied. Here, the ion reaction and charge transport in thermogalvanic cells are investigated by electrochemical impedance analysis. We first propose the detailed impedance model followed experimental verification on three types of electrode materials. Parameters including kinetic rate constants and ion diffusion coefficients for the electrodes are obtained by fitting the impedance data. Our study shows explicitly that impedance analysis can provide useful information on selecting suitable electrode materials for thermogalvanic cells.     

Study of Densities, Viscosities and Ultrasonic Speeds of Binary Mixtures Containing 1,2-Dimethoxyethane and an Alkan-l-ol at 298.15 K

The viscosity deviation (Δη), the excess molar volume (V ^E) and the ultrasonic speed (u) have been investigated from viscosity (η) and density (ρ ) measurements of binary liquid mixtures of 1,2-dimethyoxyethane with methanol, ethanol, propan-1-ol, butan-1-ol, pentan-1-ol, hexan-1-ol or octan-1-ol over the entire range of composition at 298.15 K. The excess volumes are negative over the entire range of composition for all of the mixtures with the exception of hexan-1-ol and octan-1-ol. The excess isentropic compressibilities (K _S ^E) and viscosity deviations are negative for all of the mixtures. The magnitudes of the negative values of V ^E decrease with the number of carbon atoms of the alkan-1-ol. The trend of increasing K _S ^E values with the chain length of the alkanol is similar to that observed in the case of V ^E. Graphs of V ^E, Δ η, K _S ^E, Δ u, L _f ^E and Z ^E against composition are presented as a basis for a qualitative discussion of the results.     

Self-assembled monolayers on Au microelectrodes

Long chain alkanethiols self-assembled monolayers (SAMs) formed on Au microelectrodes showed higher sensitivity towards defects than the same monolayers on macroelectrodes. The analysis of cyclic voltammetry and electrochemical impedance spectroscopy (EIS) experiments performed on covered microelectrodes were consistent with the formation of pinholes of about 10 nm in diameter. Moreover, the EIS data exhibited a specific behavior that was interpreted invoking the short circuiting of the pinholes impedance by the surrounding surface of the microelectrode in the high frequency domain, whereas in the low frequencies, the surface covered by the SAM was assume to act as an insulator.     

M?ssbauer and other spectral studies of Fe(III) complexes of benzothiazolines

Different molar reactions of Fe(OPr¹)₃, and FeCl₃ with benzothiazolines having an NSH donor system. derived by the condensation ofo-aminothiophenol with heterocyclic aldehydes. viz. pyridine-2-aldehyde. furfuraldehyde and thiophene-2-aldehyde. lead to the formation of [Fe.Pr¹(NS)₂]₂, [Fc(NS)₃] and [Fe(NS)₂Cl| type of complexes. The resulting derivatives have been characterized by elemental analysis, conductivity measurements, molecular weight determinations and magnetic studies. IR, electronic, M?ssbauer and ESR spectral data have been used to deduce the structures of the resulting derivatives.