Degradation of 4-Chlorophenol using a Gas–Liquid Gliding Arc Discharge Plasma Reactor

The gas–liquid gliding arc discharge plasma is used directly to study degradation and dechlorination of 4-Chlorophenol (4-CP) in solution. The typical AC waveforms of discharge voltage and current revealed that the discharge behavior was not definitely periodic. The chemical oxygen demand (COD) abatement of 4-CP solution with stainless steel electrode is higher than that with aluminum or brass electrode; When air was used as carrier gas the COD abated from 1,679.2 to 190 mg/L (i.e., 88.68% abatement) after 76 min plasma treatment; Increasing gas–liquid mixing rate could also increase the degradation of 4-CP; adding appropriate amounts of Fe²⁺ or iron chips to the solution were found to be favorable for 4-CP degradation. The main intermediates of 4-CP degradation are p-benzoquinone, hydroquinone, 4-chlorocatechol, p-chloronitrobenzene, and ring cleavage products (acetic acid, glycol, propanone, and others). Furthermore, possible pathways of 4-CP degradation in solution are proposed.     

大环烷构象

综述了40多年来大环烷构象的研究进展，将大环烷分为偶数和奇灵敏环分别对其构象研究进行讨论，得出大环烷构象的一般规律，并介绍了有关大环化合物构象的命名法则。     

TS和PTS单晶体的热刺激电流

测定了双(对甲基磺酸)2,4-己二炔-1,6-二醇酯(TS)及其不同聚合程度TS-PTS混合体和完全聚合的聚合物PTS在100-300K温度范围内的热刺激电流。在沿分子堆砌方向上(对PTS则是大分子链方向)上观察到了它们的热刺激电流,并在相应于它们相变152K和192K处呈现热刺激电流峰。研究了聚合程度对相变的影响,绘制了TS-PTS体系的相图。对另三个热刺激电流峰的归属作了定性解释。     

Ultra trace analysis of refractory metals by solid state mass spectrometry — A comparison of GDMS,SSMS and SIMS

The analytical performance of a glow discharge quadrupole mass spectrometer is demonstrated using sintered tungsten as an example. The inherent problem of molecular interferences in glow discharge mass Spectrometry has been considerably reduced using neon as a complementing discharge gas. Particular attention has been paid to time dependences. Analytical figures of merit are presented.     

Low-temperature electrothermal vaporization of thenoyltrifluoroacetone complex of Sc(III) and Y(III) for sample introduction in an inductively coupled plasma atomic emission spectrometry,and their determination in biological samples

A new method for inductively coupled plasma atomic emission spectrometry (ICP-AES) determination of trace Sc and Y, based on gaseous compound introduction into the plasma as their thenoyltrifluoroacetone (TTA) complexes by electrothermal vaporization was developed. Using the reagent TTA as chemical modifier can not only enhance the analytical signals, but also reduce the vaporization temperature. At a temperature of 1,000 °C the trace Sc and Y can be vaporized completely into ICP. The factors affecting the formation of the chelate and its vaporization behavior, such as drying time, vaporization temperature/time, reaction medium and the amount of TTA, were investigated in detail. Under the optimized conditions (drying temperature/time 100 °C/10 s, vaporization temperature/time 1,000 °C/4 s), the limits of detection for Sc and Y were 19 pg and 34 pg (3), respectively, and the relative standard deviations for Sc and Y were 4.2% (c _Sc=0.2 g mL^–1; n=7) and 2.6% (c _Y=0.5 g mL^–1; n=7). The linear ranges of the calibration graphs cover three orders of magnitude. The method was applied to the analysis of the biological reference materials (GBW 07602, bush branches and leaves; GBW 07604, poplar leaves), and the results obtained were in good agreement with the certified values.     

Characterization of proteins separated by displacement chromatography using low angle laser light scattering photometry

Summary -Lactoglobulin A and B (-LACT) were separated by displacement chromatography (DSC) on an ionexchange column using dextran sulfate as the displacer. A LALLS photometer and a UV detector, in series, were used to determine the molecular weight (MW) of the proteins, on-line. The results indicate that both, -LACT A and B, were present as dimers in the buffer used for the mobile phase. The MWs of the proteins were about 6–8% higher than the theoretical MW of a dimer (37,000). Additional control studies have shown the presence of a high molecular weight species in both the proteins, which could possibly be an aggregate. This species was observed in the LALLS signal but was nearly absent in the UV signal. Our work has demonstrated the feasibility of interfacing LALLS with displacement chromatography for detecting impurities or aggregates which may be difficult to detect by conventional detectors used for chromatography.     

The structure and electrochemical characteristics of La0.67Mg0.33 (Ni0.8Co0.1Mn0.1) x (x=2.5–5.0) multiphase alloys for nickel-metal hydride batteries

This paper presents results concerning structure and electrochemical characteristics of the La_0.67Mg_0.33 (Ni_0.8Co_0.1Mn_0.1) _x (x=2.5–5.0) alloy. It can be found from the result of the Rietveld analyses that the structures of the alloys change obviously with increasing x from 2.5 to 5.0. The main phase of the alloys with x=2.5–3.5 is LaMg₂Ni₉ phase with a PuNi₃-type rhombohedral structure, but the main phase of the alloys with x=4.0–5.0 is LaNi₅phase with a CaCu₅-type hexagonal structure. Furthermore, the phase ratio, lattice parameter and cell volume of the LaMg₂Ni₉phase and the LaNi₅ phase change with increasing x. The electrochemical studies show that the maximum discharge capacity increases from 214.7 mAh/g (x=2.5) to 391.1 mAh/g (x=3.5) and then decreases to 238.5 mAh/g (x=5.0). As the discharge current density is 1,200 mA/g, the high rate dischargeability (HRD) increases from 51.1% (x=2.5) to 83.7% (x=3.5) and then decreases to 71.6% (x=5.0). Moreover, the exchange current density (I ₀) of the alloy electrodes first increases and then decrease with increasing x from 2.5 to 5.0, which is consistent with the variation of the HRD. The cell volume reduces with increasing x in the alloys, which is detrimental to hydrogen diffusion and accordingly decreases the low-temperature dischargeability of the alloy electrodes.     

Electrochemical characterization of negative electrodes consisting of surface-modified Zr0.9Ti0.1(Ni1.1Co0.1Mn0.5V0.2Cr0.1)x Laves-phase alloys

Laves-phase hydrogen storage alloy has a high potential for use as negative electrode material as alternative for the misch-metal-based material. In order to improve the energy density and the rate capability of negative electrode, chemical and mechanical modification of Lavesphase alloy with different stoichiometric ratios was carried out. Discharge capacity and high-rate dischargeabilty was evaluated by electrochemical methods and the characterization of Laves-phase alloy was made by X-ray diffraction, SEM observation and PCT measurement. The best result in discharge capacity could be obtained for stoichiometric Laves-phase alloy with a composition of Zr_0.9Ti_0.1Ni_1.1Co_0.1Mn_0.5V_0.2Cr_0.1 by boiling in 10 M KOH solution. On the other hand, the high-rate dischargeability was increased remarkably by introducing mechanical grinding before alkali treatment. The cause for improved performance was discussed on the basis of thermodynamic stability of metal hydride and changes in crystal structure and surface morphology influencing on diffusion coefficient and diffusion path length of hydrogen.     

Structural refinement of Nd[Fe(CN)6]·4H2O and study of NdFeO3 obtained by its oxidative thermal decomposition at very low temperatures

The crystal structure of Nd[Fe(CN)₆]·4H₂O has been refined by Rietveld analysis using high resolution synchrotron powder X-ray diffraction data. It belonged to the orthorhombic crystal system, Cmcm space group, with cell parameters: , and . The change in space group from P6₃/m which is observed in the pentahydrates (LnFe(CN)₆·5H₂O) to Cmcm in the tetrahydrates has been analyzed to be a consequence of the change in 9-fold coordination of Nd³⁺ in the pentahydrates to 8-fold coordination in the tetrahydrates, which changes the Nd³⁺ environment from tricapped trigonal prism to a distorted tricapped trigonal prism or square antiprism. Its decomposition process in air to produce NdFeO₃ has been followed by thermogravimetric and differential thermal analysis, IR spectroscopy and laboratory powder XRD. We found that it is possible to synthesize crystalline NdFeO₃ at temperatures as low as 380 °C and refine the structure of single phase crystalline NdFeO₃ synthesized by this method at 600 °C.     

Electrolytic Co3O4 for thin-layer anodes of lithium-ion batteries

Electrolytic (e) cobalt oxide of a spinel structure, e-Co₃O₄, is obtained from the sulfate and nitrate (aqueous, water-alcohol) solutions containing Co²⁺ with the aim of using it in thin-layer anodes of lithium-ion batteries. The physicochemical and structural properties of the synthesized compounds are examined using thermal and x-ray diffraction analyses, absorption IR spectroscopy, and atomic force microscopy. The electrochemical characteristics of e-Co₃O₄ are determined in breadboards of lithium power sources and in the lithiumion system LiCoO₂/e-Co₃O₄.