介质材料二次电子发射特性对微波击穿的影响

以介质填充的平行板放电结构为例,本文主要研究了介质填充后微波低气压放电和微放电的物理过程.为了探究介质材料特性对微波低气压放电和微放电阈值的影响,本文采用自主研发的二次电子发射特性测量装置,测量了7种常见介质材料的二次电子发射系数和二次电子能谱.依据二次电子发射过程中介质表面正带电的稳定条件,计算了介质材料稳态表面电位与二次电子发射系数以及能谱参数的关系.在放电结构中引入与表面电位相应的等效直流电场后,依据电子扩散模型和微放电中电子谐振条件,分别探讨了介质表面稳态表面电位的大小对微波低气压放电和微放电阈值的影响.结果表明,介质材料的二次电子发射系数以及能谱参数越大,介质材料的稳态表面电位也越大,对应的微波低气压放电和微放电阈值也越大.所得结论对于填充介质的选择有一定的理论指导价值.     

担载Ru_3（CO）_（12）－Fe_2（CO）_9混合簇的脱羰基作用和表面加氢反应

担载于ＺｒＯ２上的Ｒｕ３（ＣＯ）１２－Ｆｅ（ＣＯ）９混合簇的红外光谱表明，Ｒｕ３（ＣＯ）１２以Ｒｕ（ＣＯ）２Ｏ２表面络合物存在．混合族在真空中随温度升高而发生脱羰基作用，５００℃左右羰基完全脱掉；以Ａｌ２Ｏ３为载体者其羰基不易脱除，升高温度出现多种羰基带．混合簇中的Ｆｅ２－（ＣＯ）９极易脱羰基．担载混合簇在Ａｒ气中进行ＴＰＤＥ时，低温时以脱羰基为主，高于１５０℃时发生表面歧化反应而生成ＣＯ２；在Ｈ２气中，低温时仍以脱羰基为主，高于１５０℃时发生表面加氢反应而生成ＣＨ４．混合簇的脱羰基和表面反应能力与Ｒｕ／Ｆｅ比及载体有关．担载混合簇在ＣＯ加氢反应中以Ｒｕ（ＣＯ）２Ｏ２和分散Ｆｅ存在，还出现－ＣＨｘ多种表面物种．     

活化条件对活性碳纳米管比表面积的影响

以KOH为活化剂, 研究了多壁碳纳米管在制备活性碳纳米管过程中四个重要影响因素: 活化剂用量、活化温度、活化时间和活化过程中保护气体的流速对所得活性碳纳米管BET比表面积的影响并解释了原因. 研究表明上述四个因素都会对活性碳纳米管的比表面积产生较大的影响, 其中活化剂用量的影响最大, 在研究范围内可引起比表面积增大约241 m²•g^-1. 在这四个影响因素中除活性碳纳米管的比表面积随活化温度的增加而不断增加外, 其他三个影响因素的变化都会使活性碳纳米管的比表面积出现最大值, 而且四个影响因素的改变, 都不改变活性碳纳米管的孔洞主要是中孔和大孔的特点.     

铜-镍合金电极表面组成及状态的变化对硝基苯电还原的影响

铜-镍合金电极表面组成及状态的变化对硝基苯电还原的影响;Monel合金电极;表面状态;硝基苯;对氨基苯酚;电还原     

人肝癌细胞系HLE细胞表面抗原多肽的纳升电喷雾串联质谱从头测序分析

肿瘤细胞表面的抗原多肽能够被细胞毒T淋巴细胞特异性识别而引起免疫应答,因此有可能用于研制基于多肽的抗肿瘤疫苗。用弱酸将人肝癌细胞系HLE细胞表面抗原多肽和人正常肝细胞表面多肽洗脱后,经RP-HPLC分离,选择HLE细胞表面特异性多肽进行纳升电喷雾串联质谱(nanoESI-MS/MS)测序,共测定5个色谱峰中的20个多肽序列,分子量分布范围为1000~2000 Da。借助M asSeq软件分析出其中12个多肽的序列。经数据库查寻,其中的3个肽段分别来自钙调节蛋白、核蛋白S19和伴侣蛋白10。这些多肽的生物学功能及与肿瘤的关系值得深入研究。该研究表明nanoESI-MS/MS是测定微量混合多肽序列的最有效方法。     

Production of Raw Starch-Saccharifying Thermostable and Neutral Glucoamylase by the Thermophilic Mold <Emphasis Type="Italic">Thermomucor indicae-seudaticae</Emphasis> in Submerged Fermentation

Among physical and nutritional parameters optimized by “one variable at a time” approach, four cultural variables (sucrose, MgSO₄ ^.7H₂O, inoculum size, and incubation period) significantly affected glucoamylase production. These variables were, therefore, selected for optimization using response surface methodology. The p-values of the coefficients for linear effect of sucrose and inoculum size were less than 0.0001, suggesting them to be the key experimental variables in glucoamylase production. The enzyme production (34 U/ml) attained under optimized conditions (sucrose, 2%; MgSO₄ ^.7H₂O, 0.13%; yeast extract, 0.1%; inoculum size, 5 × 10⁶ spores per 50 ml production medium; incubation time, 48 h; temperature, 40°C; and pH 7.0) was comparable with the value predicted by polynomial model (34.2 U/ml). An over all 3.1-fold higher enzyme titers were attained due to response surface optimization. The experimental model was validated by carrying out glucoamylase production in shake flasks of increasing capacity (0.25–2.0 l) and 22-l laboratory bioreactors (stirred tank and airlift), where the enzyme production was sustainable. Furthermore, the fermentation time was reduced from 48 h in shake flasks to 32 h in bioreactors.     

Alkylation of catechol with methanol to guaiacol over sulphate-modified zirconia solid acid catalysts

A series of sulphate-promoted ZrO₂ solid acid catalysts with different contents of SO₄ ²⁻ were calcined at 450°C in air for 4 h and tested for the liquid-phase alkylation of catechol to guaiacol in a fixed-bed down-flow reactor. The 5 wt.% SO₄ ²⁻ on ZrO₂ showed the best conversion (82%) and selectivity for guaiacol (84%) at 200°C and 1 bar pressure. A smooth correlation was observed between the catalytical activity and surface acidity of sulphated zirconia. Based on our results, a surface mechanism is proposed.     

Statistical Optimization for Succinic Acid Production from E. Coli in a Cost-Effective Medium

Response surface methodology (RSM) was employed for optimization of medium components and cultural parameters in cost effective cane molasses based medium for attaining high yield of succinic acid. The important factors obtained by “one-variable-at-a-time-approach” (cane molasses, corn steep liquor, sodium carbonate, and inoculum density) were further optimized by RSM. The optimum values of the parameters obtained through RSM (cane molasses 12.5%, corn steep liquor 7.5%, and sodium carbonate 25 mM) led to almost double yield of succinic acid (15.2 g/l in 36 h) as against “one-variable-at-a-time-approach” (7.1 g/l in 36 h) in 500-ml anaerobic bottles containing 300-ml cane molasses based medium. Subsequently, in 10-l bioreactor succinic acid production from Escherichia coli was further improved to 26.2 g/l in 30 h under conditions optimized through RSM. This fermentation-derived succinic acid will definitely help in replacing existing environmentally hazardous and cost-intensive chemical methods for the production of succinic acid.     

Effect of specific adsorption of anions on the kinetics of the current relaxation after pulsed anodic activation of dissolution of hydrophilic metals

Based on the model of spatial separation of the dissolution and passivation of hydrophilic metals, the effect of strong specific adsorption of anions on the shape of curves for the relaxation of anodic current of metals in acid solutions after switching an anodic activation pulse off is considered by using iron as an example.     

Fe3O4磁性纳米粒子的超声包金及其表征

超声条件下, 在乙醇分散的3-氨丙基三乙氧基硅烷(APTES)功能化的磁性Fe₃O₄纳米粒子和四氯合金酸的混合溶液中滴加柠檬酸钠, 成功地制备了磁性Fe₃O₄/Au复合纳米粒子. 采用X射线粉末衍射仪(XRD)、紫外吸收可见光谱(UV-Vis)、带有电子能谱仪(EDS)的扫描电子显微镜(SEM)、透射电子显微镜(TEM)、光电子能谱(XPS)、超导量子干涉仪(SQUID)等方法, 对复合粒子的形态、结构、组成以及磁学性质进行了表征. 结果表明: 在此条件下制得的复合粒子粒径在30 nm左右, 室温下磁化强度可达63 emu/g.