冲击电流计线圈运动状态的分析

简要介绍了冲击电流计的工作原理,分析研究了冲击电流计的偏转线圈在磁场中的运动状态,并运用数理方法和电磁学知识推导出描述各种运动状态的物理表达式,揭示出偏转线圈的运动规律,对于仪器的调节和实验电路的设计具有重要意义.     

基于国产仪器研究钨丝原子吸收光谱

用标准的150 W幻灯灯泡的钨丝作原子化加热材料,设计制作了一种新颖的、结构简单的钨丝电热原子化器,同时还设计了该原子化器的电源电路和信号的数据采集电路.该原子化器能的最高原子化温度可达3100 K左右;编写了硬件的控制软件和信号处理的应用软件.用该原子化器将实验室一台火焰原子吸收光谱仪改装成钨丝原子吸收光谱仪,并以铜元素标准溶液和PerkinElmer公司多元素标准溶液对仪器性能作了研究.仪器对铜的检出限为0.0133 μg/mL,线性范围为0.10～4.0 μg/mL;对1.0 μg/mL的铜标准溶液测试的相对标准偏差为RSD=4.1%(测试次数n=10),每次分析所需样品量20 μL.     

Alternating copolymers consisting of arylalkyl methacrylates. II. Effect of coil collapse on fluorescence spectra of alternating copolymers of 2-(9-carbazolyl)ethyl methacrylate and aromatic vinyl monomers

Alternating and random copolymers of 2-(9-carbazolyl)ethyl methacrylate with aromatic vinyl monomers were synthesized and their fluorescence properties were compared in good and poor solvents. Contraction of the polymer coils induced the hypochromic effect, i.e., the mutual interaction of the ground-state chromophores, but caused little quenching of their excited state. This is sharp in contrast with the vinyl-type of polymers, exhibiting large interactions in both the ground and excited states. Introduction of bulky groups on the comonomers in the alternating copolymers further suppressed these interactions. © 1996 John Wiley & Sons, Inc.     

Hollow fiber supported liquid membrane extraction for ultrasensitive determination of trace lead by portable tungsten coil electrothermal atomic absorption spectrometry

Hollow fiber supported liquid membrane extraction (HF-SLME) was used to separate and enrich trace lead from a large volume of 250 mL water sample to a final tiny volume of 30 μL of 1-octanol, 5 μL of which was inject into a tungsten coil electrothermal atomic absorption spectrometer (W-coil ET-AAS) for determination of lead. Some important parameters that influenced the extraction and determination were investigated in detail, such as the concentration of ammonium pyrrolidine dithiocarbamate (APDC), pH of sample solution, stirring rate, extraction time, pyrolysis current, atomization current, carrier gas flow rate, as well as interferences. Under the optimized conditions, a practical enrichment factor of 499 and a limit of detection (3σ) of 0.2 ng mL^{− 1} were obtained. The calibration curve was linear in the range of 0.5–10 ng mL^{− 1}. The relative standard deviation (RSD) was 5.6% for five measurements of a 4 ng mL^{− 1} lead standard solution. The accuracy of this method was examined by the analysis of certified reference water samples (GBW(E)080398 and GSBZ(E) 50009-88) for lead. Finally, the proposed method was applied to the determination of lead in local tap water, pond water and river water, with recoveries in the range of 96–109% for spiked samples.     

ITER ���򳡴���֧��U �����Լк��ӷ����Ż�

利用试验及数值模拟技术研究了ITER 极向场磁体支撑U 型韧性夹的焊接变形规律,模拟和实际测量的比较验证了模拟的准确性,从而得到了U 型夹焊缝变形的基本规律,并改进现有夹具类型。基于验证好的热力边界条件以及优化的夹具,对三种焊接方案的U 型韧性夹的焊接变形进行了计算,从而提出了极向场磁体支撑制造的优化方案。优化后的焊接方案将焊接变形控制在0.6mm 以内。     

An open volume, high isolation, radio frequency surface coil system for pulsed magnetic resonance

We present an open volume, high isolation, RF system suitable for pulsed NMR and EPR spectrometers with reduced dead time. It comprises a set of three RF surface coils disposed with mutually parallel RF fields and a double-channel receiver (RX). Theoretical and experimental results obtained with a prototype operating at about 100 MHz are reported. Each surface RF coil (diameter 5.5 cm) was tuned to f₀ = 100.00 ± 0.01 MHz when isolated. Because of the mutual coupling and the geometry of the RF coils, only two resonances at f₁ = 97.94 MHz and f₂ = 101.85 MHz were observed. We show they are associated with two different RF field spatial distributions. In continuous mode (CW) operation the isolation between the TX coil and one of the RX coils (single-channel) was about −10 dB. By setting the double-channel RF assembly in subtraction mode the isolation values at f₁ or f₂ could be optimised to about −75 dB. Following a TX RF pulse (5 μs duration) an exponential decay with time constant of about 600 ns was observed. The isolation with single-channel RX coil was about −11 dB and it increased to about −47 dB with the double-channel RX in subtraction mode. Similar results were obtained with the RF pulse frequency selected to f₂ and also with shorter (500 ns) RF pulses. The above geometrical parameters and operating frequency of the RF assembly were selected as a model for potential applications in solid state NMR and in free radical EPR spectroscopy and imaging.     

Random coil phosphorus chemical shift of deoxyribonucleic acids

Random coil phosphorus chemical shift has been studied using 16 17-nucleotide DNA sequences. Due to the presence of residual base stacking in these sequences, the temperature and sequence effects were investigated at 50 and 55 degrees C. The phosphorus chemical shifts of random coil DNA sequences have been found to be independent of temperature. Sequence effect analysis shows that the phosphorus chemical shift of a nucleotide in a random coil DNA sequence depends on both its 5'- and 3'-nearest neighbors. A trimer model has been used to establish the random coil 31P chemical shift prediction protocol which shows an accuracy of 0.02 ppm.     

Flow-induced vibration in two-phase flow with wire coil inserts

Information of flow-induced vibration (FIV) in two-phase flow with wire coil inserts at atmospheric pressure, is presented in this study. FIV was measured in an upward vertical tube for four different wire coil inserts using an air–water mixture as process fluid. Vibration increased along with mass flux and quality. The narrower wire coils produced more vibration. The FIV prediction correlation for two-phase flow with wire coil inserts was experimentally developed with coefficient correlation value of 0.956.     

Synthesis and characterization of fluorene‐based rod–coil liquid crystal polymers

A series of fluorene‐based rod–coil liquid crystal polymers with different lengths of the coil segments on backbones were designed and synthesized by a palladium‐catalyzed Suzuki coupling‐reaction. The thermal stability, the UV–Vis absorption and fluorescence spectra in chloroform solution and thin film, the electrochemical properties, thermal behavior, and morphology of these rod–coil polymers were investigated. The thermal stability of these polymers steadily decreased on increasing the length of the coil segments on the backbone; their optical and electrochemical properties did not exhibit noticeable dependence on the weight fraction of the coil segments. However, the shoulder emission and the full width at the half‐maximum (FWHM) in PL spectra of the films increased, whereas the oxidation onset potentials and the corresponding HOMO energy levels decreased with the increase in the weight fraction of the coil segments, which was assigned to microphase separation and formation of folded chain conformation as the weight fraction of the coil segments increased. These polymers displayed a characteristic liquid crystalline texture. The variation of the weight fraction of the coil segments obviously affected the thermal behavior and morphology of these rod–coil polymers. Copyright © 2008 John Wiley & Sons, Ltd.     

低场核磁共振短死时间射频线圈与射频开关的设计

本文以核磁共振（NMR）射频线圈振铃信号产生原理为对象进行分析研究,提出了一种适用于低场环境下由环状间隙腔线圈与螺线管线圈构成的收发分离式短死时间射频线圈设计方案,采用优化调谐匹配网络提高发射效率;根据射频线圈方案需求设计了快速切换的射频开关及驱动．在此基础上依据仿真结果制作了短死时间射频线圈,并应用于自主研制的低场9.51 MHz便携式NMR谱仪系统,进行NMR实验,结果显示可将收发切换时间缩短至10 μs以内,验证了该设计方案的可行性．