Basic principles of technological shaping of optical properties and radiation hardness of PWO crystals

Technological conditions ensuring growth of optically homogeneous lead tungstate (PWO) crystals are reported. It is shown that the basic scintillator characteristics of PWO grown from highly purified raw material and properly doped with lanthanides are mainly determined by inclusions of oxides W_1−yL_yO_3−x (L=Y, La, Gd; 0<x<0.3). Moreover, surface-located inclusions with structure close to tungstenite may also be of importance. It is demonstrated that the scintillation properties can be intentionally designed by varying the oxygen content in the inclusions x and the surface structure. The optimal value for x and the most favorable surface structure are achieved by proper thermal regimes and environment content during the crystal annealing. The results enabled low-cost fabrication of PWO scintillators with steady and reproducible characteristics acceptable for the CERN project ALICE and ensured production of PWO on an industrial scale by “North Crystals” company at a rate of 125–135 crystals per year from every growth apparatus.     

Influence of the light illumination on thermoluminescence properties of PbWO4

The thermally stimulated properties of PbWO₄ in the temperature range 90–400 K have been investigated on undoped and terbium-doped crystals after X-ray irradiation at 90 K. Doping with terbium changes the concentration of shallow traps, which are responsible for retrapping free electrons and holes. Light illumination can change the distribution of the traps. The optically stimulated luminescence is observed. The influence of light illumination on the TSL curves and emission properties is studied. The possible mechanism of TSL phototransformation is discussed.     

Chemical Speciation of Amphoteric Ions on Semi‐Dry Scrubber Residue and Bag‐House Ash from MSWI

Two series of size‐fractionated combusted residues, a bag‐house ash and a scrubber residue, from a municipal solid waste incinerator (MSWI) were prepared and extracted by means of sequential chemical extraction (SCE) procedures proposed by Tessier. Concentrations of water‐soluble phase, exchangeable phase, carbonated phase, Fe/Mn oxide phase, organic matter phase, and residual phase bound amphoteric metals (Pb and Zn) were obtained, and have been compared with those of single batch extraction of toxic characteristic leaching procedure (TCLP). In each size fraction of baghouse ash or scrubber residue, lead or zinc shows a common phenomena that the TCLP value is always lower than the content of the water‐soluble fraction. For lead, baghouse ash has a significant size‐dependent distribution on the water‐soluble phase to perform a size‐dependent test of lead in the TCLP test. The zinc TCLP data having less size dependence might be due to that neither the baghouse ash nor the scrubber residue has a size‐dependent distribution on the water‐soluble zinc phase.     

慢性铅中毒一例

详细问诊，为诊断慢性铅中毒提供了重要依据。     

Optimization of a portable microanalytical system to reduce electrode fouling from proteins associated with biomonitoring of lead (Pb) in saliva

There is a need to develop reliable portable analytical systems for on-site and real-time biomonitoring of lead (Pb) from both occupational and environmental exposures. Saliva is an appealing matrix since it is easily obtainable, and therefore a potential substitute for blood due to existing reasonably good correlation between Pb levels in blood and saliva. The microanalytical system is based on flow-injection/stripping voltammetry with a wall-jet (flow-onto) microelectrochemical cell. Samples that contain as little as 1% saliva can cause electrode fouling, resulting in significantly reduced responsiveness and irreproducible quantitations. In addition, incomplete Pb release from salivary protein can also yield a lower Pb response than expected. This paper evaluates the extent of in vitro Pb-protein binding and the optimal pretreatment for releasing Pb from the saliva samples. Even in 50% by volume of rat saliva, the electrode fouling was not observed, due to the appropriate sample pretreatment and the constant flow of the sample and acidic carrier that prevented passivation by the protein. The system offered a linear response over a low Pb range of 1-10 ppb, low detection limit of 1 ppb, excellent reproducibility, and reliability. It also yielded the same Pb concentrations in unknown samples as did the ICP-MS. These encouraging results suggest that the microanalytical system represents an important analytical advancement for real-time non-invasive biomonitoring of Pb.     

A study on the utility of bismuth-film electrodes for the determination of In(III) in the presence of Pb(II) and Cd(II) by square wave anodic stripping voltammetry

This work is an investigation into the utility of bismuth-film electrodes (BiFEs) for the determination of indium in the presence of cadmium and lead by square wave anodic stripping voltammetry (SWASV). The purpose of this study was to demonstrate that, after judicious choice of the associated chemical and instrumental conditions, it is possible to achieve satisfactory separation of the relevant stripping peak and, thus, to determine simultaneously trace concentrations of cadmium, lead and indium. It was conclusively demonstrated that a BiFE performed better than the equivalent mercury-film electrode (MFE) in this particular application.     

Synthese und Kristallstruktur von Blei(II)‐oxidhalogenid‐Alkoholaten mit unterschiedlichen Verknüpfungsvarianten von Pb4O4‐Heterokubaneinheiten

Synthesis and Crystal Structure Determination of Lead(II) Oxide Halide Alcoholates with Different Connectivity of Pb₄O₄ Heterocubane‐like Subunits The reaction of red lead(II) oxide (Litharge) and lead(II) halide (Cl^? and Br^?) with diethylene glycole at a temperature of 180 °C leads to the isotypic compounds [Pb₆(C₄H₈O₃)O₂Cl₆] (1) and [Pb₆(C₄H₈O₃)O₂Br₆] (2) . In a similar synthesis with PbI₂ as educt at temperature of 160 °C the two modifications β‐[Pb₆(C₄H₈O₃)O₂I₆] (3) and α‐[Pb₆(C₄H₈O₃)O₂I₆] (4) were found, whereas at a reaction temperature of 180 °C [Pb₉(C₂H₄O₂)(C₄H₈O₃)O₃I₈] (5) was surprisingly obtained as product. The X‐ray diffraction data show that at a temperature of 180 °C a splitting of the ether took place. The cited compounds show cubane like subunits built by lead and oxygen atoms. These fragments are connected by alkoholate molecules. In 5 additionally an I₆ octahedra centered by lead is observed.     

原子吸收光谱法测定裂解汽油中铅

报道了用火焰原子吸收光谱法测定裂解汽油中铅的方法。用碘 二甲苯溶液对汽油进行氧化处理,用稀硝酸进行萃取,萃取后浓缩液用原子吸收光谱法进行测定。铅含量在0～7.0μg·ml-1范围内符合比耳定律。对汽油样品进行分析时,相对标准偏差小于3.95%,对样品进行加标回收试验,回收率为97.7%～101.7%,方法的精密度和准确度良好。     

黄孢展齿革菌菌丝球同时吸附铅镉离子的动力学

采用间歇法，利用黄孢展齿革菌菌丝球吸附溶液中的Pb^2 和Cd^2 ，研究Pb^2 和Cd^2 共存体系中吸附初速率随初始浓度的变化规律。实验结果表明，少量Cd^2 的存在促进其对Pb^2 的吸附，并提高吸附初速率，但随着Cd^2 初始浓度的增加，促进作用逐渐减弱并转为抑制作用；Cd^2 的吸附初速率随着Pb^2 初始浓度增大而减小；Pb^2 和Cd^2 的吸附初速率都随自身初始浓度的增加而增大。     

琼脂凝胶中形成铬酸铅周期性沉淀的机理研究

选择硝酸铅和铬酸钾作为相互扩散的反应物以形成铬酸铅在琼脂凝胶中的周期性沉淀．分别在光照和黑暗中对六种不同浓度的硝酸铅溶液进行了实验．根据实验现象对周期性沉淀的形成提出了可能的机理．认为光辐射可使铬酸铅部分电离，从而减慢了胶核成长速率，有利于汇聚成带．