PCB酸性蚀刻液中缓蚀剂对厚铜线路制作的影响

以2-巯基苯并噻唑(2-MBT)、 苯并三氮唑(BTA)和苯氧基乙醇(MSDS)作为缓蚀剂, 研究了其加入在酸性蚀刻液后对PCB厚铜线路的缓蚀效果。通过接触角测试、电化学测试和蚀刻因子得出缓蚀状态,并结合扫描电子显微镜观察铜表面形貌。通过分子动力学计算和量子化学模拟分析缓蚀剂在铜表面的吸附机理。结果表明,2-MBT + MSDS与BTA + MSDS的分子结构可有效地平行吸附在铜表面,且吸附能高于单一缓蚀剂。加入了2-MBT + MSDS的蚀刻液,对厚度约为33 μm铜线路进行刻蚀,铜线路的蚀刻因子提高到6.59,可有效应用于PCB厚铜线路制作。     

激光诱导击穿光谱法对钢中夹杂物类型的表征

激光诱导击穿光谱( LIBS)不仅可以对材料整体成分进行分析,还可进行微区及成分分布分析。本实验采用激光诱导击穿光谱对两牌号钢铁样品进行扫描分析,尝试对34CrNiMo6钢中的MnS夹杂物和重轨钢中的Si-Al-Ca-Mg复合夹杂物进行表征。结果表明,34CrNiMo6钢中元素信号的二维强度分布及元素通道合成后,个别位置Mn及S两元素的信号强度同时异常高,可确定试样中存在较多MnS夹杂物;重轨钢中元素的二维强度分布及元素通道合成后,个别位置Si、Ca、Mg及Al元素的信号同时异常高,可确定试样中存在Si-Al-Ca-Mg复合夹杂物。采用扫描电子显微镜/能谱法( SEM/EDS)对上述样品中夹杂物的对比分析结果表明,两种方法对夹杂物类型的判定结果一致。     

不同光谱预处理对激光诱导击穿光谱检测猪肉中铅含量的影响

为了研究适合激光诱导击穿光谱(LIBS)检测猪肉中重金属铅(Pb)元素含量的光谱预处理方法,将配制的84个猪肉腿肌样品分为校正集和预测集,以相关系数(R)、内部交叉验证均方差(RMSECV)和预测均方根误差(RMSEP)作为评价指标,比较了5种光谱预处理方法对偏最小二乘法(PLS)建模预测效果的影响.结果表明,多元散射校正(MSC)预处理效果最好,定标模型预测值与实验室分析元素检测值的相关系数(R)达到0.9908,RMSECV为0.302,RMSEP为0.282,主成分数为16,18个预测集样品的验证结果的平均相对预测误差(ARPE)为7.8％.说明MSC是LIBS检测猪肉Pb含量的有效光谱预处理方法,该研究为进一步实现食品中重金属快速定量分析提供了方法和数据参考.     

The Mosaic Structure of Zeolite Crystals

Zeolites are widely used in many commercial processes, mostly as catalysts or adsorbents. Understanding their intimate structure at the nanoscale is the key to control their properties and design the best materials for their ever increasing uses. Herein, we report a new and controllable fluoride treatment for the non‐discriminate extraction of zeolite framework cations. This sheds new light on the sub‐structure of commercially relevant zeolite crystals: they are segmented along defect zones exposing numerous nanometer‐sized crystalline domains, separated by low‐angle boundaries, in what were apparent single‐crystals. The concentration, morphology, and distribution of such domains analyzed by electron tomography indicate that this is a common phenomenon in zeolites, independent of their structure and chemical composition. This is a milestone to better understand their growth mechanism and rationally design superior catalysts and adsorbents.     

Laser-induced Fluorescence Spectroscopy of CoS： Identification of a New Excited State Arising from the Ground State

Laser-induced fluorescence excitation spectra and dispersed fluorescence spectra of cobalt sulfide （COS） have been recorded in the energy range of 22400-24400 cm-1 （corresponding to 446-409 nm）. A new electronic transition progression with six vibronic bands, stemming from the X4AT/2 state of CoS, was identified and assigned to be [24.0014AT/2-X4A7/2. The new observed 4A state most probably originates from the core[10a2][47r3][lla2][153][57r3] electronic configuration. Strong perturbations are found to extensively exist in the transition bands of this new state. The rotational constants and lifetimes of these bands have been determined.     

川芎嗪对脑缺血下大鼠纹状体区痕量氨基酸类神经递质的影响

采用脑内微透析技术结合激光诱导荧光检测的高效毛细管电泳研究了脑缺血下盐酸川芎嗪注射液对大鼠纹状体区氨基酸类神经递质含量的影响.在优化的分离条件下,各氨基酸在1×10^-6-1×10^-8mol/L的浓度范围内与荧光强度呈良好的线性关系,线性相关系数达到0.99以上,检测限低于1.6×10^-9mol/L,适合于大鼠纹状体区微透析样品中的痕量氨基酸类神经递质的测量.实验结果表明,脑缺血时,使用盐酸川芎嗪注射液可显著降低细胞外兴奋性氨基酸神经递质谷氮酸(G lu)和天门冬氨酸(Asp)的浓度(P<0.05),同时可显著升高抑制性氨基酸神经递质γ-氨基丁酸(GABA)和甘氨酸(G ly)的浓度(P<0.05).这一结果将对阐明盐酸川芎嗪注射液治疗缺血性脑血管疾病的有关机理提供帮助.     

Detection of OH Radical in the Photodissociation of p-Aminobenzoic Acid at 266 nm

Photodissociation of p-aminobenzoic acid at 266 nm was investigated by probing the nascent OH photoproduct employing the laser-induced fluorescence technique. It was found that the nascent OH radical was vibrationally cold and its rotational state distribution conformed to be a Boltzmann behavior, characterized by a rotational temperature of 1040±110 K. The rotational energy of OH was determined to be 8.78±0.84 kJ/mol. Between the two spinorbit states of OH, ^2Ⅱ3/2 and ^2Ⅱ1/2, the former was found to be preferentially populated. The distribution of the II（A＇） state for the A-doublet was dominant. Finally, a probable mechanism for the formation of OH produced from the photodissociation of p-aminobenzoic acid is discussed.     

微流控层流技术的研究

基于微型通道自身的层流特点而发展起来的多相层流技术,从最初的液-液微萃取开始,由于其结构加工简单、操作方便和分析功能强大,已逐渐发展成为一种加工分析方法,为微流控分析的研究应用打开了一个崭新的局面。本文概述了层流的基本原理,总结了近10年来在这方面的研究,包括层流界面间的分子扩散、转移现象和化学反应,以及层流刻蚀加工技术及其在制备纳米材料和在生命医学方面的应用。具体介绍了应用层流技术进行微芯片的加工制作,微型反应器的制备,离子、分子的分离分析,聚合物薄膜的形成和应用,微通道内有机合成反应的控制,溶液的浓度梯度控制以及在免疫检测中的应用,对细胞、生物大分子的操作控制,以及对生物试剂的预处理分析等。     

硅酸钇晶体的生长、腐蚀形貌和光谱性能研究

本文采用中频感应提拉法成功生长了未掺杂的Y2SiO5(YSO)晶体,经过定向、切割、抛光后得到样品.经过腐蚀后,利用大视场显微镜和扫描电镜在样品表面上观察到了菱形和四边形的位错蚀坑、小角晶界和包裹物等缺陷;测试了经过氢气、空气退火前后,辐照前后YSO晶体的透过谱,结果表明:YSO晶体的吸收边大约在202nm,氢气退火后在200～300nm波段透过率增加,空气退火后透过率显著降低;辐照后,氢气退火的样品在200～500nm波段透过率显著降低.     

图形衬底对多周期InGaAs量子点自组装生长的影响

量子点器件技术广泛应用于量子计算和光电器件上.成核位置的均匀性、有序性和尺寸一致性,可以有效提高光电器件性能.为了实现阵列量子点的可控性,本文采用湿法刻蚀制备图形化衬底,理论上解释了铟原子在图形化衬底上成核现象,产生有序的量子点分布特征,发现图形衬底的缺陷诱导在平台边缘和沟壑边缘成核,形成较大的量子点.在Stranski-Krastanow模式下图形衬底制备多周期量子点,发现多周期生长可以弱化台阶结构对量子点分布的限制作用.